RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: SyCo_VeNoM
Showing results 1 to 25 of 25
Search took 0.06 seconds.
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
04-03-2016, 01:02 PM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

sheesh I've always wanted those threads just...

sheesh
I've always wanted those threads just never could justify the cost

are you running a 540 can motor on it, or the stock tiny ass one?
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
02-02-2013, 10:14 AM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

well got the GPM knuckles they seem well made
also put the front RPM arms on it(did the rear prior)

at least the wheel wobble is gone from the stupid plastic clips popping out :D

also...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
01-23-2013, 10:12 PM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

blasphemy putting an ofna sticker on a merv think you might need to be stoned :D

paint job looks nice, and the wing color really goes with the scheme

BTW welcome to the board
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
01-18-2013, 08:16 PM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

I've got GPM parts on other RC's and am pretty happy(4-5 sets of C-hubs, and knuckles)

The GH sound almost as bad as Yeah Racing parts I've had. I've tried 2 bearing kits from YR 80% of the...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
01-09-2013, 01:28 PM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

well might as well bring this thread back up to the front

as I've heard the RPM knuckles, and hubs for the merv are complete trash, and went and researched it and saw a lot of complaints on them...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
08-03-2012, 07:20 PM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

you are comparing apples to oranges here
merv pulls 25amps
your nitros electronics pull probably somewhere along 1-3 tops, and not constant.
25amps will kill nimh's of that size. your best bet...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
01-31-2011, 04:41 PM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

The motor should run around 250 degrees F after 5 mins of running till you are done. If it constantly gets hotter either your tune is too lean, or you do not have enough airflow in the body. Chances...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
01-20-2011, 03:29 PM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

center diff is like the rear diff
like say both the front wheels are stuck the rears will spin.
The revo has a spur on a slipper so if say the fronst get stuck the rears will stop,(and prolly...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
12-21-2010, 08:35 AM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

Wouldn't even give it minutes. I'd give it 2 seconds with how much torque that sucker has to make, and how the wheels will be unable to spin due the the sheer weight of the motor bottoming the truck...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
12-02-2010, 09:11 PM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

dunno how that would work on the VXL I know traxxas's blue XL-5 it won't work at all(and says so too).
A cheap $4 (on ebay) low voltage alarm that plugs into the balance ports IMO is a better option
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
12-02-2010, 05:23 PM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

Cold could do if from what I read in the past if they are cold enough
.
The batteries not putting enough power out is not your issue though IMO. Your packs are able to put out 44amps each if...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
12-02-2010, 03:36 PM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

Well I've discharged one to storage voltages only reason I did it was I knew I wouldn't get anytime to run it soon seeing the RC I had it in broke a c-hub 3 mins into its run. Which is pretty much...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
12-01-2010, 08:14 PM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

bad idea
NEVER EVER discharge a lipo
also you should balance charge them at least once every 5-6 uses.
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
11-24-2010, 11:08 AM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

2S in parallel is still 2S ;)
just the mAh add
2S in series = 4S which = fried electronics in this ;)

only reason you can connect 2 NiMh in series is the lower voltage, and they have a much...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
11-10-2010, 05:28 PM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

plug in. the bullets on the 35A esc are the same size as the connectors on the vxl motor.

only thing you will have to do is solder on a traxxas male plug for the battery.
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
11-09-2010, 09:38 PM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

http://www.hobbypartz.com/hobbywing-ezrun-35a-brushless-esc.html
$30 free shipping

http://www.hobbypartz.com/led-program-card-for-brushless-esc.html
Programming card $7 not needed but makes...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
11-08-2010, 09:40 PM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

Wow just looked at the 1/16 summit's part list. Here is the GRAND total of all the changes (seriously)
7215 (front & Rear body post set)
7235 (front & rear bumper set)
Body
tires

7132r...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
11-08-2010, 05:02 PM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

well I got a HW 35A ESC in mine.
Had to swap the location of the radio and ESC though to make it fit, which kills its waterproofing.

Did you run the 4s in series or parallel?
Cause if it...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
11-04-2010, 11:46 AM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

yup
Figured I could make a brushed summit for way under what traxxas is going to charge for the brushless one
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
11-04-2010, 11:35 AM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

well few reasons actually.
One is I don't have the VXL system I got a HW ESC in mine, had to put the ESC in the battery box location, reciever in the ESC location, and for winter I'd like...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
11-04-2010, 10:31 AM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

Hey does anyone know what the stock Brushed MERV gearing is?
I just bought a Brushed setup to pop in mine for winter (I find BL WAY too hard to control on ice + I plan on making it a summit when...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
10-24-2010, 05:44 PM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

Agree my MERV manual has both a slash and e-revo on it, along with layouts of both in the same book ;)
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
10-21-2010, 10:26 PM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

yea the original plan was use electronics I had laying around from 1/10ths cause I know I saw a 540 motor mount for it somewhere.
I was actually estimating it to be around the same size as th CRT...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
10-16-2010, 11:39 AM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

Well got my revo together.
I bought it as a roller with expectations parts I had laying around would work... I would have been better just buying it RTR in the end...
But anyways its finally...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
10-07-2010, 11:10 PM
Replies: 4,457
Views: 685,957
Posted By SyCo_VeNoM

RE: OFFICIAL MINI E-REVO THREAD!!!

Hey all I got 2 quick questions seeing I'm still waiting for my roller to come.

an the vxl 380 motor work on a HW 35A ESC? or will it toast it?

other is what Hobbyking lipos will work (my...
Showing results 1 to 25 of 25


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.