RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: FlyingPilgrim
Showing results 1 to 7 of 7
Search took 0.16 seconds.
Forum: Kit Building
11-22-2005, 11:27 AM
Replies: 26
Views: 3,457
Posted By FlyingPilgrim

RE: Goldberg Ultimate questions

I've got mine where they show it on the plans, mid-ship. Mounting a YS 1.10 up front. Not sure how my balance will be yet, but should be close. Mock it all up before covering, aim for slight...
Forum: Kit Building
11-21-2005, 10:22 AM
Replies: 26
Views: 3,457
Posted By FlyingPilgrim

RE: Goldberg Ultimate questions

Rangeman, the Saito 1.20 should power your plane fine. There are several people that have that combo and are happy with it. With the Saito, you can always use a higher nitro fuel if you find you want...
Forum: Kit Building
03-25-2005, 11:06 PM
Replies: 26
Views: 3,457
Posted By FlyingPilgrim

RE: Goldberg Ultimate questions

Kirknik, sorry to hear about your loss. Nothing hurts worse than losing a plane you've only had a short while. As far as the exhaust goes, I've seen some where the builder has routed the stock...
Forum: Kit Building
03-25-2005, 12:50 PM
Replies: 26
Views: 3,457
Posted By FlyingPilgrim

RE: Goldberg Ultimate questions

Oh, as far as pitts mufflers, I may have misled you in my earlier statement. I believe you can use one with the stock cowl, but it may have to be cut out around the muffler, exposing a good chunk of...
Forum: Kit Building
03-25-2005, 12:47 PM
Replies: 26
Views: 3,457
Posted By FlyingPilgrim

RE: Goldberg Ultimate questions

I've got a YS 1.10, and I hope to be able to use the stock muffler. I'm using a Gator soft-n-safe isolation mount. Unfortunately, YS went the same route as Saito (or vise-versa) when they redesigned...
Forum: Kit Building
03-24-2005, 11:38 PM
Replies: 26
Views: 3,457
Posted By FlyingPilgrim

RE: Goldberg Ultimate questions

I'm putting together a recent laser cut kit. I've found the wood quality generally very good- light/soft where appropriate, and good quality ply. I had one warped aileron that was as hard as oak, and...
Forum: Kit Building
03-24-2005, 01:01 PM
Replies: 26
Views: 3,457
Posted By FlyingPilgrim

RE: Goldberg Ultimate questions

Are you talking about the FX-91 or the 91 Surpass 4- stroke? If you are using the 2- stroke, no, the stock muffler will not fit, and even if you buy a pitts muffler, you may have trouble fitting it...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.