RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: Brenner
Showing results 1 to 25 of 500
Search took 0.75 seconds.
Forum: Electric Pattern Aircraft
Yesterday, 10:41 AM
Replies: 3
Views: 788
Posted By Brenner

So how does it fly? What's the throttle response...

So how does it fly? What's the throttle response like? Does it have enough power? What props are you using?
Forum: Electric Pattern Aircraft
02-07-2023, 08:27 AM
Replies: 2,031
Views: 682,292
Posted By Brenner

You're not wasting your time. I think you would...

You're not wasting your time. I think you would like the performance that a modern f3a Contra Drive gives your plane.

With a Contra Drive you are going to want a much higher pitch than you would...
Forum: Electric Pattern Aircraft
06-15-2022, 10:39 AM
Replies: 2,031
Views: 682,292
Posted By Brenner

Hey Daniel, You will need to press it back...

Hey Daniel,

You will need to press it back on using a small press. When you do this the bottom of the motor must be supported by the press. When you press it back on make sure that you press it...
Forum: Electric Pattern Aircraft
06-09-2022, 12:14 PM
Replies: 2,031
Views: 682,292
Posted By Brenner

There is no need to heat the collapsible collet....

There is no need to heat the collapsible collet. Just get a longer bolt. I actually use a 25mm set screw. It works great.

Brenner…
Forum: RC Jets
03-06-2022, 10:25 AM
Replies: 1,948
Views: 402,710
Posted By Brenner

How is the PBR12X different from the expander...

How is the PBR12X different from the expander that Powerbox already has on its website?
Forum: RC Jets
03-06-2022, 08:49 AM
Replies: 1,948
Views: 402,710
Posted By Brenner

If both of the connected receivers goes into...

If both of the connected receivers goes into failsafe, how does the PBR12X handle this situation? does it it pass on the failsafe positions of the last receiver that was working? Does it have it's...
Forum: RC Jets
03-04-2022, 12:41 PM
Replies: 1,948
Views: 402,710
Posted By Brenner

Does anyone know when Powerbox will be shipping...

Does anyone know when Powerbox will be shipping new transmitters again? Also, why did they stop shipping in the first place?
Forum: RC Jets
03-04-2022, 12:40 PM
Replies: 1,948
Views: 402,710
Posted By Brenner

If you're using a lot of high current servos you...

If you're using a lot of high current servos you can connect power leads to more than one empty servo connector. I typically use two power input leads into my expander for my f3a pattern plane. I've...
Forum: RC Jets
03-03-2022, 12:16 PM
Replies: 1,948
Views: 402,710
Posted By Brenner

Futaba has a 14 channel receiver, and Jeti has up...

Futaba has a 14 channel receiver, and Jeti has up to 18 channel receivers, but these receivers are heavy, and there's no redundancy for all that weight.

The trend is for receivers to have fewer...
Forum: RC Jets
03-02-2022, 10:43 AM
Replies: 1,948
Views: 402,710
Posted By Brenner

There's nothing about this device on the Powerbox...

There's nothing about this device on the Powerbox website...
Forum: RC Jets
03-02-2022, 09:18 AM
Replies: 1,948
Views: 402,710
Posted By Brenner

It looks good. Does anyone know what the actual...

It looks good. Does anyone know what the actual weight is? Does the switch just disconnect the receivers or does it also disconnect the power to the receivers and the servos? Is it possible to use...
Forum: RC Jets
02-22-2022, 05:25 PM
Replies: 1,948
Views: 402,710
Posted By Brenner

I would be surprised if you could find a single...

I would be surprised if you could find a single person who uses more than half the functionality of the core radio. I don't think that's the point.

Different people have different needs and...
Forum: Electric Pattern Aircraft
02-20-2022, 09:43 AM
Replies: 2,031
Views: 682,292
Posted By Brenner

it’s a “bolt-in” upgrade…

it’s a “bolt-in” upgrade…
Forum: RC Jets
02-11-2022, 11:56 AM
Replies: 1,948
Views: 402,710
Posted By Brenner

I would have trouble flying with sticks like that…

I would have trouble flying with sticks like that…
Forum: Electric Pattern Aircraft
01-20-2022, 05:18 PM
Replies: 2,031
Views: 682,292
Posted By Brenner

With the 23" props I am using maybe 3700mah for...

With the 23" props I am using maybe 3700mah for P23 and about 4000mah for F23. However, the numbers you get will depend a lot on your flying style and your plane setup. The 22" props might be 200mah...
Forum: Electric Pattern Aircraft
01-20-2022, 03:34 PM
Replies: 2,031
Views: 682,292
Posted By Brenner

Hey Daniel, Both setups are good. The 23"...

Hey Daniel,

Both setups are good. The 23" setup will give you more speed range and better vertical performance, and the 22" setup will pull less from your packs.

Brenner ...
Forum: RC Jets
01-13-2022, 04:26 AM
Replies: 1,948
Views: 402,710
Posted By Brenner

What you need is some sort of scripting language...

What you need is some sort of scripting language in the transmitter that has access to telemetry, and can initiate actions..
Forum: RC Jets
01-12-2022, 03:21 PM
Replies: 1,948
Views: 402,710
Posted By Brenner

Sounds like a pressure sensor is needed to...

Sounds like a pressure sensor is needed to trigger the alarm while there is still enough pressure left to lower the gear. You would also need some code to figure out what the rate of pressure decay...
Forum: Electric Pattern Aircraft
12-06-2021, 03:07 AM
Replies: 2,031
Views: 682,292
Posted By Brenner

The primary benefit is that the system runs...

The primary benefit is that the system runs cooler. This is a benefit here in the United States because ambient temperatures regularly exceed 40C.

Brenner ...
Forum: Electric Pattern Aircraft
12-05-2021, 12:18 PM
Replies: 2,031
Views: 682,292
Posted By Brenner

In the United States the AMA is going to allow...

In the United States the AMA is going to allow 12s packs in pattern competition starting in 2022...

Brenner ...
Forum: Electric Pattern Aircraft
12-04-2021, 11:12 AM
Replies: 2,031
Views: 682,292
Posted By Brenner

Unfortunately, I don’t fly Masters so I can’t...

Unfortunately, I don’t fly Masters so I can’t speak from personal experience. However, Tony Frackowiak has been having success with 4400 6s packs.

Brenner…
Forum: Electric Pattern Aircraft
12-04-2021, 09:24 AM
Replies: 2,031
Views: 682,292
Posted By Brenner

The 812 motor that's being tested right now...

The 812 motor that's being tested right now really has way too much power to be used without some sort of rpm limiter. My concern is that there's no practical way to guarantee that it wouldn't drive...
Forum: Electric Pattern Aircraft
12-04-2021, 08:14 AM
Replies: 2,031
Views: 682,292
Posted By Brenner

Yes, there are two motors that are being...

Yes, there are two motors that are being considered. One is being offered for sale right now.

They are both Pyro 600 size motors, but they have been redesigned. The rear bearing has been upsized...
Forum: Electric Pattern Aircraft
11-28-2021, 06:46 PM
Replies: 2,031
Views: 682,292
Posted By Brenner

When a Contra Drive is operating air is...

When a Contra Drive is operating air is accelerated as it passes through the disk of the front prop so when this passes through the disk of the rear prop it is moving faster than it was when it was...
Forum: Electric Pattern Aircraft
11-26-2021, 02:39 PM
Replies: 2,031
Views: 682,292
Posted By Brenner

Hey John, Try putting the pinion gear bolt...

Hey John,

Try putting the pinion gear bolt back in and then loosen it up a few turns. Then tap on the head of the bolt with any handy tool. You should be able to knock the bronze insert free.
...
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.