RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 4
1
2
3
Last »
Search: Posts Made By: Silver Bullet
Showing results 1 to 25 of 77
Search took 0.69 seconds.
Forum: Marketplace
04-05-2021, 06:31 AM
Replies: 2
Views: 730
Posted By Silver Bullet

Raven Ultimate

Too far. Wont ship and cant drive that far. Otherwise, possibly

Specifications:
Wingspan - 122 in.
Length - 113 in.
Weight - 37 lbs.
Forum: Marketplace
04-02-2021, 01:10 PM
Replies: 2
Views: 730
Posted By Silver Bullet

42% Raven

EG 42% Raven.

Strong DLE 170 Engine w/Bowman rings.

Run on ethanol-free w/30:1 Red Line.

Custom made soft mount by Merle Hyde.

ProLog cannisters.
Forum: Marketplace
02-12-2021, 10:02 PM
Replies: 1
Views: 590
Posted By Silver Bullet

42% raven

EG 42% Raven.

Strong DLE 170 Engine w/Bowman rings.

Run on ethanol-free w/30:1 Red Line.

Custom made soft mount by Merle Hyde.

Prolog cannisters.
Forum: Carden Aircraft
02-18-2019, 05:35 PM
Replies: 2
Views: 2,826
Posted By Silver Bullet

By the way, what's the difference between a...

By the way, what's the difference between a Carden PRO and a non-pro airplane?
Forum: IMAC
01-17-2019, 01:15 PM
Replies: 0
Views: 1,483
Posted By Silver Bullet

Regluing Instrument Panel

On my 42%er the instrument panel is coming loose in several areas, probably from exposure to the sun. It's pretty tight where it is located under the canopy but I'll figure out a way. The instrument...
Forum: Futaba Radios Direct support forum
12-18-2018, 10:53 AM
Replies: 45
Views: 11,660
Posted By Silver Bullet

Bill, in message #2 of this thread, you state...

Bill, in message #2 of this thread, you state "12-channel FASSTest is intended for stick banging 3D heli flying. You will not see any benefit using it on an airplane." Is there any disadvantage to...
Forum: Batteries & Chargers
12-10-2018, 06:23 AM
Replies: 4
Views: 1,285
Posted By Silver Bullet

I'd be careful using servo extensions for battery...

I'd be careful using servo extensions for battery supply wiring. The wire on extensions is generally very thin with limited capacity.
Forum: Futaba Radios Direct support forum
12-10-2018, 06:01 AM
Replies: 6
Views: 4,623
Posted By Silver Bullet

Modtron, How do I go about recording my message...

Modtron, How do I go about recording my message and then assigning it to a switch?
Thanks.
Forum: Futaba Radios Direct support forum
12-09-2018, 09:23 AM
Replies: 6
Views: 4,623
Posted By Silver Bullet

18SZ Speech Function

I own an 18SZ and have noted in your listing of functions for this transmitter is 'Speech Function' maybe I missed it, but I have looked many places and can't find how to program this function. I...
Forum: Futaba Radios Direct support forum
06-19-2018, 11:01 AM
Replies: 5
Views: 3,378
Posted By Silver Bullet

Another reason I was considering changing to a...

Another reason I was considering changing to a lipo battery is the charger that Futaba supplys with the 18sz. There is no way it can balance the Life battery and seems very primitive and cheap. ...
Forum: Futaba Radios Direct support forum
06-19-2018, 07:49 AM
Replies: 5
Views: 3,378
Posted By Silver Bullet

Lipo in a 18sz transmitter

I don't seem to be getting very much duration on the standard LIFE battery in my 18sz. It seems to need charging every flying session because voltage drops to 6.6.
Can I substitute a two cell lipo...
Forum: Futaba Radios Direct support forum
01-03-2018, 05:13 PM
Replies: 4
Views: 841
Posted By Silver Bullet

Radio Program Converter

Can the Futaba radio program converter be used to download a program from a 18MZ to an 18SZ? Where can I get the program converter? Thanks, Bob
Forum: Electric Pattern Aircraft
08-01-2016, 07:58 AM
Replies: 1
Views: 1,214
Posted By Silver Bullet

Stabilizer Fences

I've got a new Invitation and indeed the rudder is very sensitive. Exponential helps some but is just not the way I want to go. This plane comes with stab fences and two jigs one at 95 degrees and...
Forum: Futaba Radios Direct support forum
05-23-2016, 04:52 PM
Replies: 1
Views: 437
Posted By Silver Bullet

Display Flash

I recently upgraded my 18SZ software to revision 1.6.
Since then when I turn on my radio the display flashes once very brightly before it changes to the normal display. It's almost similar to...
Forum: Futaba Radios Direct support forum
04-04-2016, 09:32 AM
Replies: 1
Views: 427
Posted By Silver Bullet

Servo arms for BLS154

I have several low profile (aileron) S9154 and BLS154 servos and need additional servo arms. As you know these servos have a larger diameter output gear than most Futaba servos. I prefer aluminum...
Forum: Futaba Radios Direct support forum
11-24-2015, 07:24 AM
Replies: 3
Views: 1,093
Posted By Silver Bullet

Thanks for the SD card info. I updated my...

Thanks for the SD card info.

I updated my 18SZ and it apparently took ok because the information now reads "1.E".

Now I'm having trouble loading "Pattern Plane Models for the 18SZ...
Forum: Futaba Radios Direct support forum
11-23-2015, 05:38 PM
Replies: 3
Views: 1,093
Posted By Silver Bullet

SD Card

The manual for the 18SZ states it "is capable of using SD cards with a memory size between 32MB and 2GB". This seems odd to me as I would think it means the card must just have a minimum of a...
Forum: Futaba Radios Direct support forum
10-14-2015, 03:20 PM
Replies: 1
Views: 799
Posted By Silver Bullet

LiFE Battery Charger

I just received my T18SZ today and was wondering about balance charging the LiFe transmitter battery. The battery has two cables coming out of it - one with a standard "J" connector and one with...
Forum: Electric Pattern Aircraft
09-27-2015, 01:25 PM
Replies: 37
Views: 24,072
Posted By Silver Bullet

I maidened my Invitation recently and about a...

I maidened my Invitation recently and about a minute into the flight lost the canopy into a huge field of 4' high beans. Had to order a new one as there was no way a bunch of us and camera'd...
Forum: Electric Pattern Aircraft
08-22-2015, 05:44 PM
Replies: 4
Views: 3,010
Posted By Silver Bullet

Pletty Advance 30-10 with Jeti Spin 99

Pletty Advance 30-10 with Jeti Spin 99
Forum: Electric Pattern Aircraft
08-12-2015, 08:32 PM
Replies: 4
Views: 2,001
Posted By Silver Bullet

CG of Invitation/Essence

what is the correct starting location of the G2 aircraft? BJ's site states 200 mm for the Invitation and 230 mm for the Essence (from the wing leading edge at the root). Since these are basically...
Forum: Electric Pattern Aircraft
08-10-2015, 07:32 PM
Replies: 37
Views: 24,072
Posted By Silver Bullet

deleted

deleted
Forum: RC Pattern Flying
07-01-2015, 08:48 AM
Replies: 11
Views: 1,171
Posted By Silver Bullet

What ever became of Sam. He just suddenly...

What ever became of Sam. He just suddenly dropped out of the pattern community.
He was an innovator and a great builder.
Forum: Electric Pattern Aircraft
06-10-2015, 06:07 PM
Replies: 37
Views: 24,072
Posted By Silver Bullet

Chris, Did you get so excited to finish and fly...

Chris,
Did you get so excited to finish and fly the Invitation that you dropped the build thread? j/k
Looking forward to the completion
Forum: Electric Pattern Aircraft
05-15-2015, 10:50 AM
Replies: 141
Views: 43,328
Posted By Silver Bullet

Matt, what esc were you using?

Matt, what esc were you using?
Showing results 1 to 25 of 77
 
Page 1 of 4
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.