RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 4
1
2
3
Last »
Search: Posts Made By: Generalx5
Showing results 1 to 25 of 96
Search took 0.63 seconds.
Forum: RC Helicopter General Discussions
09-13-2012, 07:21 PM
Replies: 6
Views: 1,580
Posted By Generalx5

SAVE a few bucks Buddy Codes here!

Hey guys, I have some buddy codes to share....</p>

This includes batteries and Planes and parts!</p>

Here we go....</p>
...
Forum: Car Nitro & Gas Engines
04-20-2009, 09:30 PM
Replies: 135
Views: 66,735
Posted By Generalx5

RE: Kyosho GXR28 ENGINE TROUBLE!!!

Your second gear probably isnt engaging...maybe your stuck on the first gear. Check the 2 speed tranny on that and you might need to insert allen key in there and loosen the second gear. Its its too...
Forum: Car Nitro & Gas Engines
02-27-2009, 03:24 PM
Replies: 135
Views: 66,735
Posted By Generalx5

RE: Kyosho GXR28 ENGINE TROUBLE!!!

if you cant get it to start right. Look at the begining page 1 of this thread.....I went through alot to get it to run without choking.
Forum: Car Nitro & Gas Engines
02-27-2009, 03:18 PM
Replies: 135
Views: 66,735
Posted By Generalx5

RE: Kyosho GXR28 ENGINE TROUBLE!!!

Actually the GXR28 is a pretty decent stock engine....very high compression.
Forum: Car Nitro & Gas Engines
02-27-2009, 03:17 PM
Replies: 135
Views: 66,735
Posted By Generalx5

RE: Kyosho GXR28 ENGINE TROUBLE!!!

might be too lean still.....what does it look like on the surface of the dead plugs? black or browned out? the breaking is from lean mixtures. I used to go nuts running mine in the fileds on a cold...
Forum: Car Nitro & Gas Engines
09-30-2008, 12:49 AM
Replies: 266
Views: 185,786
Posted By Generalx5

RE: Nitro Guide and FAQs

How are you able to do that? The only why I can think of is to actually set the servo back to close the carb opening, but you have a low end screw that prevents it from quitting on a really really...
Forum: Car Nitro & Gas Engines
09-26-2008, 10:13 PM
Replies: 266
Views: 185,786
Posted By Generalx5

RE: Nitro Guide and FAQs

Its actually very simple...

Most of the time, the biological filter, or mechanical filters will cycle the water through its filtration system. The water that has been filtered is pumped back...
Forum: Car Nitro & Gas Engines
09-25-2008, 09:50 PM
Replies: 266
Views: 185,786
Posted By Generalx5

RE: Nitro Guide and FAQs

It was during January this year when I first started with RC stuff. Now I have 3 RC nitros.

Tamiya 1/10 .15 engine. 2x Kyosho Infernogts, 1 BMW M3 and Kalsonic ImpulzzZZZZ

At the moment,...
Forum: Car Nitro & Gas Engines
09-17-2008, 09:09 PM
Replies: 266
Views: 185,786
Posted By Generalx5

RE: Nitro Guide and FAQs

that would have been my guess too, is the engine by chance running backwards? sometimes i get the backward running start. But corrects itself after I give it a rev. This seems to happen only when I...
Forum: Car Nitro & Gas Engines
06-23-2008, 03:43 PM
Replies: 266
Views: 185,786
Posted By Generalx5

RE: Nitro Guide and FAQs

Have you taken a look at the clutch yet? If the wheel is still spining at the bottom of idle rpm, then your clutch shoes are too loose. You might have a broken spring. Do you have the stock clutch...
Forum: Car Nitro & Gas Engines
06-22-2008, 05:02 PM
Replies: 266
Views: 185,786
Posted By Generalx5

RE: Nitro Guide and FAQs

are you running too hot? Try either leaning or richining the HSN and see how it does. one of them will work. Do a high speed run, and then brake and idle, listen to how the engine sounds. You will...
Forum: Car Nitro & Gas Engines
06-22-2008, 04:14 PM
Replies: 266
Views: 185,786
Posted By Generalx5

RE: Nitro Guide and FAQs

With a warm weather, normally you wont need more fuel because oxygen density is lower in warm air. So if it is still shutting down, there could be a few possible causes.

Is your high end rich...
Forum: Car Nitro & Gas Engines
06-22-2008, 02:22 PM
Replies: 266
Views: 185,786
Posted By Generalx5

RE: Nitro Guide and FAQs

Could be that fact that it is a lean mixture, what is your ambiant temp? do you know the temp on the head sinks? Check your glow plug to see if any black stufff develops.

If all the above is...
Forum: Car Nitro & Gas Engines
06-17-2008, 12:36 PM
Replies: 266
Views: 185,786
Posted By Generalx5

RE: Nitro Guide and FAQs

Good question. Answers to this may vary. IMO, I would run the car the way everyone else wants to run it. A typical engine would last about 20G or so, if you were careful and took good care of the...
Forum: Car Nitro & Gas Engines
04-25-2008, 02:07 AM
Replies: 266
Views: 185,786
Posted By Generalx5

RE: Nitro Guide and FAQs

Glad to be of some help.
Forum: Car Nitro & Gas Engines
04-24-2008, 12:04 PM
Replies: 266
Views: 185,786
Posted By Generalx5

RE: Nitro Guide and FAQs

Try this, if you WOT and then have the car run off, then release the throttle and apply breaks, will engine rpm still remain high? it should immediatly come to idle rpm when you hit the breaks, if it...
Forum: Car Nitro & Gas Engines
04-24-2008, 12:03 PM
Replies: 266
Views: 185,786
Posted By Generalx5

RE: Nitro Guide and FAQs

Sounds like your low end is lean, if its too lean its hard for the idle rpm to kick in right away. Acceleration is good because of a lean low end.
Forum: RC On Road Nitro Cars
03-13-2008, 11:45 PM
Replies: 8
Views: 1,855
Posted By Generalx5

RE: 1:8th Scale On road GRP Gandini too small!?!?!

Alright, I've reconsidered, They are going back....
Forum: RC On Road Nitro Cars
03-12-2008, 03:53 AM
Replies: 8
Views: 1,855
Posted By Generalx5

RE: 1:8th Scale On road GRP Gandini too small!?!?!

anypictures of this quickrelease device? Im hoping to find something I can use to adapt it to onto my 1:10 on road...
Forum: RC On Road Nitro Cars
03-11-2008, 01:13 PM
Replies: 8
Views: 1,855
Posted By Generalx5

RE: 1:8th Scale On road GRP Gandini too small!?!?!

Theres no way....I Tried it on my 1:8th for the front and it still wont fit. Those tires are more like 1:10th. Anyways, im going to home hardware or home depot to find me a cupling that can hold down...
Forum: RC On Road Nitro Cars
03-10-2008, 11:16 PM
Replies: 8
Views: 1,855
Posted By Generalx5

1:8th Scale On road GRP Gandini too small!?!?!

I bought 2sets of the 1:8th on-road foam wheels, these turn out to be the size of 1:10 wheels?:( It has a 12mm hex instead of the 17mm. And it would be a good size for my Tamiya 1:10...
Forum: Car Nitro & Gas Engines
02-22-2008, 01:55 PM
Replies: 135
Views: 66,735
Posted By Generalx5

RE: Kyosho GXR28 ENGINE TROUBLE!!!

http://www.youtube.com/watch?v=mXxpbNQI5sU

New Tune video. Hows that looking?
Forum: Car Nitro & Gas Engines
02-15-2008, 01:52 PM
Replies: 7
Views: 1,523
Posted By Generalx5

RE: Blow off whistle on your pipe?

Dude, turbo charge that Inferno GT! Turbo charge that Truggy, Turbo charge it!

I can make other guys look stupid on their mini bikes, or pocket bikes. Those gasoline small scale motorbikes that...
Forum: Car Nitro & Gas Engines
02-15-2008, 01:26 PM
Replies: 7
Views: 1,523
Posted By Generalx5

RE: Blow off whistle on your pipe?

Hey I agree, When throttle is high, i see alot of gas comming out of the exhaust, it doesnt take much to get the blow offf to go off...Hahaha, DUDE!!!!!!! Imagine your engine reving up, and you hear...
Forum: Car Nitro & Gas Engines
02-15-2008, 02:04 AM
Replies: 19
Views: 2,163
Posted By Generalx5

RE: Help with Mach 28

Sigh.......you guys, for so many years and you still wont learn.


Forget the Mach 28! Get a Mach 3 Turbo!!! THose things give you the closest turns! Comes with micro-power technology, and...
Showing results 1 to 25 of 96
 
Page 1 of 4
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.