RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 7
1
2
3
Last »
Search: Posts Made By: Hibityhupla!
Showing results 1 to 25 of 172
Search took 0.10 seconds.
Forum: Redcat Racing Support
11-15-2008, 08:29 PM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

yeppers....gotta get the multi-shaft. easy to replace the stock shaft and can find it on ebay fairly cheap.
Forum: Redcat Racing Support
11-09-2008, 07:21 PM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

the redcat clutch and bell fit the 3.3 flywheel fine. when i used the 2 speed i think i had to use a dremel on the chassis where it mounted(the bell was too close and 2nd gear on the bell rubbed...
Forum: Redcat Racing Support
11-08-2008, 07:21 PM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

he might till you shift..lol looks good!
Forum: Redcat Racing Support
11-06-2008, 06:08 AM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

you can use plastic dip or rubber spray to waterproof servos too. just be sure to tape off the part that moves..lol balloons do work great for the receiver and batteries. never seen one on a...
Forum: Redcat Racing Support
09-18-2008, 03:20 AM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

buy a new drive cup and drill the screw out of the old one. Heat works to loosen them up but it wont help if its stripped.
Forum: Redcat Racing Support
09-08-2008, 10:24 PM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

pretty much. it can still get too tight though. if you know what your doing it's an unnecessary step. It's just to make sure you don't get the mesh too tight, or at least try..lol
Forum: Redcat Racing Support
09-08-2008, 06:41 PM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

The paper goes between the clutch bell and tranny. when you get the engine tightened down you simply rotate the tranny or bell and the paper will come out. The paper is just used to try to make a...
Forum: Redcat Racing Support
09-08-2008, 02:45 AM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

I've been drinking so I'm a little confused..lol If it's taking off no matter what the idle is probably too high. Lean it out a little and lower the idle if that"s whats going on. If it's all in...
Forum: Redcat Racing Support
08-26-2008, 05:00 PM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

the 12mm ones are. They did wonders on my revo and tmaxx.
Forum: Redcat Racing Support
08-26-2008, 04:31 PM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

lol.....my revo does that all the time
Forum: Redcat Racing Support
08-25-2008, 02:32 AM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

it has one brake disc coming off the transmission that stops all four wheels, so technically yes....
Forum: Redcat Racing Support
08-23-2008, 11:51 PM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

Are they the ones with the screw on extension or do they replace the 12mm wheel hex and are held on by the pin? I had tons of problems with the screw on type coming off even lock-tite and super...
Forum: Redcat Racing Support
08-23-2008, 03:46 PM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

here they are
Forum: Redcat Racing Support
08-23-2008, 03:42 PM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

Tranny = transmission..lol I know Himoto is working on the metal gears but haven't heard anything new in a while. Blocking the bottom is a win/lose situation. While it does keep rocks from going...
Forum: Redcat Racing Support
08-22-2008, 10:07 PM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

The new bell wont strip the tranny gears as often but i dont see where it would effect the differentials. The spring wouldn't effect either. The only reason for upgrading the spring is because the...
Forum: Redcat Racing Support
08-22-2008, 04:10 PM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

heres some pics
Forum: Redcat Racing Support
08-22-2008, 03:40 PM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

That's an easy one. Take the engine out to start. Then there's a screw going in the front of the clutch bell that needs to come off. It's easier if you hold the flywheel with a pair of vise...
Forum: Redcat Racing Support
08-22-2008, 03:29 PM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

Could be a few different things but all at the same location. Is it running 4wd still? If not the drive cup came loose. the disk could have stripped too. Sometimes if the drive cup is too far...
Forum: Redcat Racing Support
08-18-2008, 02:56 PM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

I usually just order my stuff from Ehroof or type the part #'s at ebay. Never had a problem finding parts.................
Forum: Redcat Racing Support
08-15-2008, 03:05 AM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

sounds like a receiver problem to me
Forum: Redcat Racing Support
08-14-2008, 05:36 PM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

here's a pic.... I have the single speed in mine. I would recommend using an aluminum set of clutch shoes too. I use these- Kyosho Inferno GT/ MP 7.5 Sports Clutch Shoe Assembly
Forum: Redcat Racing Support
08-14-2008, 05:21 PM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

yep....You use the stock flywheel, clutch, bell and the peice that goes between the flywhel and engine. I've done it to a couple different cars now. I'll try to get a close up pic on here tomorrrow...
Forum: Redcat Racing Support
08-14-2008, 05:12 PM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

That stock esc will handle the traxxas brushless engine and a 9.6v Nimh battery. I just tried it on my kids and it works pretty good. Im not sure what the traxxas motor has for turns though..
Forum: Redcat Racing Support
08-14-2008, 03:12 AM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

That's the one......you will need the manifold too. I suggest going with the stock set-up to start and go from there...copy and paste at ebay......
NewTraxxas 3.3/2.5 T-Maxx Header and tuned pipe...
Forum: Redcat Racing Support
08-13-2008, 05:14 PM
Replies: 3,672
Views: 318,616
Posted By Hibityhupla!

RE: Redcat Racing Tornado Thread

The whole system or just the motor? If it just stopped it could be the motor or esc..... The only ep car i have i swapped the electronics out with the traxxas velineon set. If i had to guess i...
Showing results 1 to 25 of 172
 
Page 1 of 7
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.