RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: rakiddy
Showing results 1 to 25 of 51
Search took 0.08 seconds.
03-31-2009, 03:23 PM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

Lehrscott,
I have done one of these using the Estes rocket motor. I can take some photos and post them if you want. With my Power 10 Brushless, 12x6 prop, and 3S 2200 lipo I don't have a...
03-25-2009, 11:57 AM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

Dan,
I agree with ADWB on the COG. I have found that the plane flies fine with the COG anywhere between 2.5 inches behind the leading edge to 2.75 inches behind the leading edge. As far as...
03-23-2009, 03:04 PM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

Pat,
I had an incident where I crashed my Super Cub with an E-flite Park 480 into the Des Moines River. It floated in there for at least an hour until it finally ran onto shore. It still...
03-18-2009, 06:57 PM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

Itzobi,
I thought receiving bad advice from me was what kept you going? On another note, did you happen to make it up to University of Phoenix stadium last weekend for the r/c show? Luckily, I...
03-12-2009, 12:49 PM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

Firebird,
You may want to do a google search on "Parkzone Corsair Upgrades" or something like that because I seem to remember that there was a recall or notice about screws that were holding...
02-11-2009, 03:51 PM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

Itzobi,
I have recently gone to using these guys: http://www.valuehobby.com/products.php?category_id=8 I think they are very reasonable and I have had very good luck with the quality. You might...
02-03-2009, 04:47 PM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

Itzobi,
I will be there for this. I have been planning to show up at this thing for 6+ months now. I can't wait. My grandparents live down there in AZ and so I'm going to meet up with them...
01-22-2009, 08:19 AM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

Itzobi,
I'm interested in your DX5's. Will you please send me a price.
Thanks

Talent,
I have a Phase 3 F-16 on the way for myself. I couldn't pass up that deal. Then I saw the...
01-21-2009, 06:53 PM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

I answer everybody that asks this question the same way. The parkzone P-51 uses the same motor and comes stock with a 10.8V battery. That's only a .3V difference. So, you will be just fine. I...
01-21-2009, 08:05 AM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

Chuck,
If you want a completely stock SC for the least amount of money I would buy a bag of extra parts from somebody's crashed plane off of Ebay. Then I would buy the remaining parts needed...
01-13-2009, 01:26 PM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

Firebird,
I have just began painting a plane in a Harley-Davidson motorcycle scheme. Here is something similar to what it will look like:
Bob
01-10-2009, 02:20 PM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

Tyler,
I agree with you about not mounting the ESC up front. I don't know if you saw my pictures of my fuselage but I actually mounted my receiver & ESC in the rear of the plane. The reason I...
01-10-2009, 11:55 AM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

DGUY,
I think a football field is enough. Just watch the goal posts otherwise you will end up like this guy from rcgroups.
01-10-2009, 11:50 AM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

Tyler,
I know this has been posted before but I just wanted to remind you of this post - http://www.rcgroups.com/forums/member.php?u=106813&page=2 In my opinion this is the easiest & least...
01-08-2009, 12:12 AM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

Mr. Hershey,
That's a great idea and I have used it before on Brushless outrunners. What I was referring to is the original shaft on the SC. The problem is that it is so long that it is...
01-07-2009, 10:07 PM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

Tyler,
I was thinking about when I figured out that the prop shaft was bent on mine the first time. Instead of pulling the prop shaft out you can simply take the prop off of it and spin the...
01-07-2009, 09:23 PM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

Here are a couple of photos showing the placement of the Carbon Fiber Rods that I advocate. The Carbon Fiber Rod that runs along the leading edge keeps the rubber bands from cutting into the wing,...
01-07-2009, 09:00 PM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

You will need a Brushed ESC to finish your conversion. I would recommend the 35A Brushed ESC from Electrifly. The Stock number is: GPMM2035 It is on this page:...
01-07-2009, 02:20 AM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

downunderdog,
I have a SC with an E-flite Power 10 mounted under the cowl. They appear to be roughly the same dimensions with the exception that the Power 10 is 43mm in length. So, I don't see...
01-03-2009, 04:20 PM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

Tyler,
I have done the same thing that you have done with the exception that I used a Helimax 2750kv inrunner. This is a great & inexpensive way to make your Super Cub brushless. The most...
01-03-2009, 04:08 PM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

Mr. Scott,
What I have done to all my SC's is to remove the tail/elevator assembly and poke thin carbon fiber rods from the tail toward the front of the fuselage while keeping the carbon fiber...
01-03-2009, 03:55 PM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

Talent5,
I'm not really one to talk about getting bored with a particular airplane but what I do is continually think about what upgrades I can do in order to make it more aerobatic. I know...
01-03-2009, 03:39 PM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

PSB667,
I would imagine what is going on is that your battery is very cold. LiPo batteries are especially sensitive to cold weather. What I have done in the past when I fly in very cold...
01-03-2009, 03:04 PM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

Dave,
I have been thinking about this about this for a couple of days now. If you look at the aileron setup on the Parkzone P-51 it uses the same setup that I think you want to use. I would...
01-03-2009, 02:58 PM
Replies: 11,777
Views: 2,376,021
Posted By rakiddy

RE: Official Hobby Zone "Super Cub" Thread

Itzobi,
I know that I already sent these to you but I thought that I would share them with everybody else anyway.
Take Care
Showing results 1 to 25 of 51
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.