RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: fossmarkluni
Showing results 1 to 9 of 9
Search took 0.31 seconds.
Forum: Glow Engines
01-01-2020, 02:08 PM
Replies: 3,345
Views: 411,860
Posted By fossmarkluni

Talking Flew my ASP 400 today to celebrate the new year,...

Flew my ASP 400 today to celebrate the new year, here is a short video on Youtube: youtu.be/DBECdtgmwqg
I love this engine, so sad they are not made anymore.
Forum: Glow Engines
05-18-2016, 07:15 AM
Replies: 3,345
Views: 411,860
Posted By fossmarkluni

Preparing my Phoenix Models YAK 54 30% with ASP...

Preparing my Phoenix Models YAK 54 30% with ASP 400 (w/ Keleo exhaust and microsens Glow 5 LP) for the season, I love this engine (and aircraft) although I haven't flown more than a few hours with...
Forum: Glow Engines
05-01-2013, 12:03 AM
Replies: 3,345
Views: 411,860
Posted By fossmarkluni

RE: ASP/MAGNUM FS400AR Rebuild/Overhaul

Lubed the baby up and did some more test runs with the drain nipple closed, everything works perfectly. I can see small amounts of oil seeping through the push rod tubes and through the front...
Forum: Glow Engines
04-28-2013, 01:23 PM
Replies: 3,345
Views: 411,860
Posted By fossmarkluni

RE: ASP/MAGNUM FS400AR Rebuild/Overhaul

I will check if I have a smaller prop to do the first break-in runs. From what I have read others suggested that it was better to run the ASP 400 with a bit larger prop because peak torque came quite...
Forum: Glow Engines
04-28-2013, 12:41 PM
Replies: 3,345
Views: 411,860
Posted By fossmarkluni

RE: ASP/MAGNUM FS400AR Rebuild/Overhaul

Remember the engine is running very rich during the first minutes and to be honest I really doubt a "lighter" prop would have made any change to the problem I experienced. There was loads of oil...
Forum: Glow Engines
04-28-2013, 08:18 AM
Replies: 3,345
Views: 411,860
Posted By fossmarkluni

RE: ASP/MAGNUM FS400AR Rebuild/Overhaul

Can you scan or take a picture of your manual? The discussion regarding leaving the drain nipple open or closed during running has never been closed as far as I can see (in this thread).
If Sanye...
Forum: Glow Engines
04-28-2013, 07:51 AM
Replies: 3,345
Views: 411,860
Posted By fossmarkluni

RE: ASP/MAGNUM FS400AR Rebuild/Overhaul

I have scanned page nr. 5 from the manual and highlighted the text.

Carosel43: After I put a ton of after run oil in the front everything feels just like it should, no snagging no screeching. ...
Forum: Glow Engines
04-28-2013, 07:09 AM
Replies: 3,345
Views: 411,860
Posted By fossmarkluni

RE: ASP/MAGNUM FS400AR Rebuild/Overhaul

To be more accurate the debris was like very small black spots (like paint), and I did not see any metal debris except one very small piece I found in the oil right beneath the crankshaft. I assume...
Forum: Glow Engines
04-28-2013, 02:14 AM
Replies: 3,345
Views: 411,860
Posted By fossmarkluni

RE: ASP/MAGNUM FS400AR Rebuild/Overhaul

Hi!

I purchased this engine from hobbyking two months ago. Yesterday (April 27, 2013) I started it up the first time and it ran perfectly for 8 minutes, I had the main needle 3,5 turns out and...
Showing results 1 to 9 of 9


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.