RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: iqman86
Showing results 1 to 18 of 18
Search took 0.32 seconds.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
10-02-2008, 02:25 PM
Replies: 3
Views: 610
Posted By iqman86

RE: Does anyone use ap2000i as a backup?

It is the spartan AP2000i stabilizer, it allows you to hover hands free for photography and supposedly if you are flying and get into trouble you let go and the unit will stablize into a safe hover.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
10-02-2008, 02:16 PM
Replies: 3
Views: 610
Posted By iqman86

Does anyone use ap2000i as a backup?

I bought the spartan ap200i to help me try new things without worrying about crashing. Is this going to work?
Forum: RC Helicopter Beginners Forum
10-02-2008, 02:08 PM
Replies: 10
Views: 1,753
Posted By iqman86

RE: why is the ESC wire wrapped around nut?

Thank you for all the info
Forum: RC Helicopter Beginners Forum
10-02-2008, 01:52 PM
Replies: 10
Views: 1,753
Posted By iqman86

RE: why is the ESC wire wrapped around nut?

I bought this particular trex from someone on this site, when i checked it over there was no ring. So I checked my other trex and it had one. So hence the question of adding it to the newer one, is...
Forum: Electric General Discussion
10-02-2008, 10:56 AM
Replies: 1
Views: 394
Posted By iqman86

AP2000i - Will this work on 6 channel System?

I have dx6i on my trex 600 will the AP2000i stabilizer system work on this? thanks
Forum: RC Helicopter Beginners Forum
10-02-2008, 09:26 AM
Replies: 10
Views: 1,753
Posted By iqman86

RE: why is the ESC wire wrapped around nut?

I am using the spektrum dx6i system, so I dont need it, correct. thanks
Forum: RC Helicopter Beginners Forum
10-02-2008, 08:57 AM
Replies: 10
Views: 1,753
Posted By iqman86

why is the ESC wire wrapped around nut?

Can someone explain why the wire from the ESC going to receiver has to be wrapped around a nut? is this ness.? thanks
Forum: Electric RC Helis
09-29-2008, 05:36 PM
Replies: 7
Views: 1,971
Posted By iqman86

RE: Trex 600 tail spin problem

ok, done and done, light is contiuously on now, unless it move rudder. but it still loses altitude when turning tail. Could the gyro be bad??? thanks
Forum: Electric RC Helis
09-29-2008, 03:52 PM
Replies: 7
Views: 1,971
Posted By iqman86

RE: Trex 600 tail spin problem

my gain setting in the dx6 is at 67%, hope that is what you meant
Forum: Electric RC Helis
09-29-2008, 03:45 PM
Replies: 7
Views: 1,971
Posted By iqman86

RE: Trex 600 tail spin problem

The light on top is double blinking and the gain I am not sure which setting that is, sorry.
Forum: Electric RC Helis
09-29-2008, 11:33 AM
Replies: 7
Views: 1,971
Posted By iqman86

RE: Trex 600 tail spin problem

No REVO on, all are 0%, I even tried to switch gyro direction to see if it was backwards, but that was not it. I can hover ok, but as soon as i yaw left or right the heli goes up or down with that...
Forum: Electric RC Helis
09-29-2008, 10:41 AM
Replies: 7
Views: 1,971
Posted By iqman86

Trex 600 tail spin problem

I am using gy401 with dig servo. The heli will lift off somewhat smooth, but as i increase throttle it wants to spin then if I decrease throttle it spins the other way. Is this from the direction...
Forum: T-Rex heli
09-28-2008, 06:28 PM
Replies: 2
Views: 509
Posted By iqman86

Trex 600 setup problem

This my second trex 600 setup. The first one flies perfectly, but the second one is not. I think it is something stupid i did but i cant figure it out.
Problem: when i increase throttle my tail...
Forum: RC Helicopter Beginners Forum
09-18-2008, 02:29 PM
Replies: 2
Views: 565
Posted By iqman86

What is the best way to practice Auot-rotation?

I have a Trex-600 and never learned to auto rotate land, any help would be appreciated. thanks
Forum: Batteries & Chargers
09-18-2008, 10:58 AM
Replies: 2
Views: 3,196
Posted By iqman86

Wiring Diagram of 3s1p lipos in parallel???

Can anyone show me the wiring for two 3s1p 5000 mah 20c lipos? I would like the result to be 6s1p 5000mah. thanks
Forum: Batteries & Chargers
09-18-2008, 10:56 AM
Replies: 39
Views: 19,203
Posted By iqman86

RE: Welcome to Common Sense RC

What is the proper wiring of two 3s1p 5000mah 20c batteries in parallel? thanks
Forum: Electric RC Helis
09-15-2008, 12:27 PM
Replies: 73
Views: 64,073
Posted By iqman86

RE: Align T-rex 600 Build Thread - Pics inside!

All my control surfaces seem to work, but the motor wont come on? When I throttle up, all the cyclics move up, but no motor. I have a AR7000 reciever with dx6i Tx. Do I have something plugged in...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-12-2008, 10:56 AM
Replies: 0
Views: 583
Posted By iqman86

fly sky Tx and Rx setup???

I have a helipro blackhawk 500 that i am trying to reinstall the factory receiver and transmitter. I know heli works fine when I had my ar6000 and dx6i installed. Now that i am selling i want to put...
Showing results 1 to 18 of 18


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.