RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 11
1
2
3
Last »
Search: Posts Made By: ALWAYSPDG
Showing results 1 to 25 of 263
Search took 0.35 seconds.
Forum: RC Warbirds and Warplanes
01-03-2014, 03:14 PM
Replies: 4,698
Views: 831,573
Posted By ALWAYSPDG

Todd, very nice work! Looks really good and...

Todd, very nice work! Looks really good and unique! Nice detail to all areas you worked on!

Sehr schöne Arbeit


später

Mike
Forum: Futaba Radios Direct support forum
12-09-2013, 08:14 AM
Replies: 5
Views: 1,644
Posted By ALWAYSPDG

Question 12FG to 14SG data transfer

Hi Bax.

I am thinking of purchasing a 14SG Tx and I would like to transfer all my models from the 12FG to the new 14SG Tx. I know they both use SD cards, so is there a way to transfer the model(s)...
Forum: Batteries & Chargers
08-01-2013, 06:56 AM
Replies: 3
Views: 717
Posted By ALWAYSPDG

RE: Should i cycle new receiver battery?

You need to do a forming charge/procedure on your new battery. Cycle the battery three times at 0.1C. Check out Hangtimes on the web, he explains this procedure clearly.

Hope that helps,


...
Forum: Futaba Radios Direct support forum
07-17-2013, 09:04 PM
Replies: 6
Views: 749
Posted By ALWAYSPDG

RE: R617FS Receiver ruined???

Sounds like you had an over voltage condition occur. If that is the case, I would send that Rx to Futaba for service/repair. I don't think there is a fuse or a fuse link that blows to save the Rx. I...
Forum: Futaba Radios Direct support forum
07-17-2013, 05:55 PM
Replies: 6
Views: 749
Posted By ALWAYSPDG

RE: R617FS Receiver ruined???

What make and model was your BEC?


Thanks,


Mike
Forum: Futaba Radios Direct support forum
03-12-2013, 08:36 AM
Replies: 2
Views: 643
Posted By ALWAYSPDG

RE: Hi Bax.

Hi Bax.

Thanks for the info. When I get a chance I'll try doing it your way and see how it goes.


Thanks,

Mike
Forum: Futaba Radios Direct support forum
03-06-2013, 07:46 AM
Replies: 2
Views: 643
Posted By ALWAYSPDG

Hi Bax.

Hi Bax.

What do I program on the GV-1 itself vs what do I program on the 12FG Tx? I want to set up three head speeds, do I set them up on the GV-1 or the Tx? I had this GV-1 setup before on a...
Forum: Futaba Radios Direct support forum
03-02-2013, 11:23 PM
Replies: 2
Views: 557
Posted By ALWAYSPDG

RE: 12FG & Governor

Hi Bax.

What do I program on the GV-1 itself vs what do I program on the 12FG Tx? I want to set up three head speeds, do I set them up on the GV-1 or the Tx? I had this GV-1 setup before on a...
Forum: Batteries & Chargers
02-25-2013, 10:07 PM
Replies: 16
Views: 879
Posted By ALWAYSPDG

RE: Dead Cell?

Hey Don.

When you charged the battery, did it feel warm to the touch when you pulled it off the charger?


Mike
Forum: Futaba Radios Direct support forum
02-24-2013, 10:37 PM
Replies: 2
Views: 557
Posted By ALWAYSPDG

12FG & Governor

Hi Bax.

Could you please explain to me how to program the Futaba governor and/or 12FG using the 12FG Tx. I would like to have one switch turn it on, Then have a three position switch to select...
Forum: Batteries & Chargers
01-22-2013, 10:24 PM
Replies: 5
Views: 984
Posted By ALWAYSPDG

RE: Looking for a battery analyzer

i use the CBA II and it works great. You are able to plug it intot he computer and do all your adjustments and monitor the discharging from there. It is a cool analyzer. The customer service is...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
12-17-2012, 07:59 AM
Replies: 106
Views: 12,655
Posted By ALWAYSPDG

RE: 12FG discontinued

How about the new Futaba 14SG Tx that is due out later this month? Is this Tx to replace the 12FG Tx? The 14SG is now listed on Tower's website.

Mike
Forum: Batteries & Chargers
12-14-2012, 08:51 AM
Replies: 5
Views: 11,035
Posted By ALWAYSPDG

RE: Glow plug igniter won't charge?

Take a glow plug and connect it to the ignitor and see if the glow plug "glows". If your glow ignitor is new, most manufactures recommend charging it for 16 hours on a wall wart charger before first...
Forum: Batteries & Chargers
12-13-2012, 08:25 PM
Replies: 42
Views: 8,353
Posted By ALWAYSPDG

RE: LIFE battery charging in the plane question

Hey Raron.

I have two LiFe batteries in my 30cc gas Extra 300 that are burried. I'll I did was purchase a balance plug extension 12" and run it up to the hatch area. I do not have to remove the...
Forum: Batteries & Chargers
12-10-2012, 10:04 PM
Replies: 5
Views: 780
Posted By ALWAYSPDG

RE: What Connector To Use?

I use the XT60 connectors and they so far are working out great. I have replaced all of my Deans connectors with the XT60 connectors!


The XT60 connectors are so much easier to disconnect than...
Forum: RC Warbirds and Warplanes
12-10-2012, 06:13 PM
Replies: 4,089
Views: 799,733
Posted By ALWAYSPDG

RE: Scale cockpit - Wow

Hey Floater.

Use about 1/4 throttle with full flaps, land it with power. You fly it onto the runway, do not try to flare it, fly it onto the runway. I learned this when flying my 60 size TF...
Forum: RC Warbirds and Warplanes
11-26-2012, 04:45 PM
Replies: 2,011
Views: 296,812
Posted By ALWAYSPDG

RE: NEW H9 P51 Mustang 60 ARF

Hey Chris.

You said, "You can usually adjust this at the trunion in the mechanism by filing the strut flat spot position", how do you do this exactly?

Thanks,

Mike
Forum: Futaba Radios Direct support forum
10-09-2012, 06:51 AM
Replies: 2
Views: 692
Posted By ALWAYSPDG

RE: 12FG model memory

Okay, thanks for the info. I would think this Tx would have the capability to bulk copy, so that you don't have to copy model by model. It could take quite some time if you have a lot of models in...
Forum: Futaba Radios Direct support forum
10-08-2012, 04:52 PM
Replies: 2
Views: 692
Posted By ALWAYSPDG

12FG model memory

Hi Bax or Krystal.

I am wondering, if there is a way to copy all of my models onto a SD card all at once, rather than doing it, model by model?

Also, in the manual, it calls for a 2 GB...
Forum: RC Warbirds and Warplanes
10-05-2012, 04:34 PM
Replies: 4,089
Views: 799,733
Posted By ALWAYSPDG

RE: TF 1/5 Scale P-51 ARF Assembly (1ST MISHAP!!!)

Thanks Thunder for the info, that is good to know! Sounds like these gas engines as a whole, are bullet proof.

Thanks,

Mike
Forum: RC Warbirds and Warplanes
10-05-2012, 04:24 PM
Replies: 4,089
Views: 799,733
Posted By ALWAYSPDG

RE: TF 1/5 Scale P-51 ARF Assembly (1ST MISHAP!!!)

Hey CR.

Question for you. Since you have so much time on this engine, I was wondering how you keep it running so good. How do you store it for the winter? Do you run some oil thru it or what? I...
Forum: Futaba Radios Direct support forum
09-26-2012, 06:56 AM
Replies: 8
Views: 1,204
Posted By ALWAYSPDG

RE: 12FG Tx radio problem

Hi Krysta.

Okay, thanks for the info. My Tx is on its way to you. This is the first time I have ever had to send in a Futaba product for service. I have been using Futaba for about 20 years so...
Forum: Futaba Radios Direct support forum
09-25-2012, 04:11 PM
Replies: 8
Views: 1,204
Posted By ALWAYSPDG

RE: 12FG Tx radio problem

Hi Bax.

Do you know what the current turn around time is for my Tx at Hobby Services in IL?


Thanks,

Mike
Forum: Futaba Radios Direct support forum
09-25-2012, 01:25 PM
Replies: 8
Views: 1,204
Posted By ALWAYSPDG

RE: 12FG Tx radio problem

Hi Bax.

Yes, I have decided to send in the Tx, as I also think something is wrong inside the radio.

Thanks,

Mike
Forum: Futaba Radios Direct support forum
09-24-2012, 09:30 AM
Replies: 8
Views: 1,204
Posted By ALWAYSPDG

RE: 12FG Tx radio problem

I was just looking at the THR CURVE page/graph and the vertical line that is controlled by the throttle stick jumps around ever so slightly when the stick is stationary. Is this normal? The default...
Showing results 1 to 25 of 263
 
Page 1 of 11
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.