RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Search
Today's Posts
Mark Forums Read
Vendor Directory
Notices
Search: Posts Made By: gade600sdi
Showing results 1 to 8 of 8
Search took 0.04 seconds.
Forum: Gas Engines
11-16-2012, 09:36 AM
Replies: 6,892
Views: 1,136,629
Posted By gade600sdi

RE: NEW DLE 20cc Gasser! (Data & Links 1st Post)

Did you change over now to the DLE55 ignition now without the idle "step"?
Forum: Gas Engines
11-16-2012, 08:42 AM
Replies: 6,892
Views: 1,136,629
Posted By gade600sdi

RE: NEW DLE 20cc Gasser! (Data & Links 1st Post)

I agree fully, the seam means nothing and may not work in all instances. You have to do it the right way with a TDC gauge, dial indicator, and degree wheel. Mine was definately at 38 BTDC and I flew...
Forum: Gas Engines
11-16-2012, 07:51 AM
Replies: 6,892
Views: 1,136,629
Posted By gade600sdi

RE: NEW DLE 20cc Gasser! (Data & Links 1st Post)

w8ye,

No I am not turning the engine over backwards!!! I rotated the crank the way the prop rotates counter clockwise. Dont know how you could have possibly derived that comment from what I...
Forum: Gas Engines
11-16-2012, 06:55 AM
Replies: 6,892
Views: 1,136,629
Posted By gade600sdi

RE: NEW DLE 20cc Gasser! (Data & Links 1st Post)

My DLE 20 has not been running as perfect as I like, so I checked a few things over and one of them was ignition timing. The book says 28-30 degrees BTDC for the Rxcel ignition. So I made up my...
Forum: Gas Engines
11-02-2012, 08:52 AM
Replies: 6,892
Views: 1,136,629
Posted By gade600sdi

RE: NEW DLE 20cc Gasser! (Data & Links 1st Post)

This is not a DLE 20 problem, but a geometry problem. Use a long arm on your carb and a small one on your servo. Set your travel to 100% on high and low and adjust the angle and the lenght of the...
Forum: Gas Engines
07-19-2012, 12:25 PM
Replies: 6,892
Views: 1,136,629
Posted By gade600sdi

RE: NEW DLE 20cc Gasser! (Data & Links 1st Post)

Guys, I highly recommend the J'Tec radiowave inverted muffler. They have a nice sized can on them and a heat treated finish. They are top notch and a little expensive, but they will hold up well...
Forum: Gas Engines
08-27-2010, 11:47 AM
Replies: 6,892
Views: 1,136,629
Posted By gade600sdi

RE: NEW DLE 20cc Gasser! (Data & Links 1st Post)

How about a DLE 20 CC on a Hangar 9 Funtana 125. Is this enough motor to hover the plane? I have a 120AX glow sitting on the shelf I may use, but thought of this new 20 maybe instead. I know some...
Forum: Gas Engines
07-29-2010, 12:43 PM
Replies: 6,892
Views: 1,136,629
Posted By gade600sdi

RE: NEW DLE 20cc Gasser! (Data & Links 1st Post)

No way too much plane. I have one and I am flying a OS91. It pulls it with authority. A 120 AX would be good for glow if you realy want to cook, especially for 3D. I have a LOT of nose weight in...
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.