RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: spaceworm
Showing results 1 to 2 of 2
Search took 0.04 seconds.
Forum: Glow Engines
08-12-2010, 09:42 PM
Replies: 14
Views: 1,273
Posted By spaceworm

RE: Cant get sleeve back over the ring..

I would say not normal. Make sure the ring ends are aligned with the pin in the piston. Make sure the rings ends have not caught in a port. Make sure you have the right rings. Was there a lot of...
Forum: Glow Engines
08-12-2010, 09:22 PM
Replies: 14
Views: 1,273
Posted By spaceworm

RE: Cant get sleeve back over the ring..

With the ring as above, aligned with the pin, compress the ring with a small gear type hose clamp just tight enough to hold the ring in the groove, but so you can slide the piston/ring out of the...
Showing results 1 to 2 of 2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.