RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: syamaner
Showing results 1 to 21 of 21
Search took 0.26 seconds.
07-12-2022, 12:34 PM
Replies: 19
Views: 4,958
Posted By syamaner

Here... ...

Here...
https://www.dropbox.com/s/hi5urt10anoomo3/ESMHSEAFURY-80FAF.pdf?dl=0
07-12-2022, 11:45 AM
Replies: 19
Views: 4,958
Posted By syamaner

Will check it and if I can find it I will let you...

Will check it and if I can find it I will let you know.
Replies: 1
Views: 961
Posted By syamaner

Today I have tested this setup and found out that...

Today I have tested this setup and found out that except "subtrim -100" everything was OK. A little bit modification made the function even better.
The seven point curve is as follows: Point 1 (idle...
Replies: 1
Views: 961
Posted By syamaner

Security feature for gasoline engine kill switch

As you know, a remote controlled opto isolated kill switch is a very important security feature when using gasoline engines. But it has a down side. You can accidentally activate the switch during...
Replies: 7
Views: 1,133
Posted By syamaner

Great! :) I am a surgeon and this is my motto...

Great! :) I am a surgeon and this is my motto during the operations.

There is no connection in my aircraft without a security measure. Usually I use connector caps but sometimes high quality...
Replies: 7
Views: 1,133
Posted By syamaner

Thanks a lot for the answers. I also had the...

Thanks a lot for the answers. I also had the opprtunity to make a few tests. I have used an analog Hitec HS325, a digital Bluebird and a digital and programmable Hitec HS5496.
When I retained the...
Replies: 7
Views: 1,133
Posted By syamaner

What if the signal wire to the servo disconnects?

Do you have any idea or experience on this topic?
The servo receives supply voltage but at some point during the operation the signal wire has an interruption (maybe due to a bad connector or bad...
Replies: 2
Views: 3,360
Posted By syamaner

Yesterday I have used the same setup (Student...

Yesterday I have used the same setup (Student Futaba 9C and Teacher Aurora 9). I have used the simulator connector for Futaba with a cross over trainer cord for Aurora. Everything was fine... Until...
06-03-2014, 09:31 AM
Replies: 19
Views: 4,958
Posted By syamaner

I had problems with one retract. It would bind...

I had problems with one retract. It would bind anywhere during its travel and stop. A detailed examination showed a bent jackscrew. During tests I inadvertently connected the retract to a servo...
06-03-2014, 09:25 AM
Replies: 19
Views: 4,958
Posted By syamaner

Now a couple of flight videos... Landing flaps...

Now a couple of flight videos... Landing flaps has been adjusted for full travel to mechanical limits. This has a marked stabilizing effect on the final approach.
...
04-30-2014, 10:15 PM
Replies: 19
Views: 4,958
Posted By syamaner

Thanks Brian. DLE55 seems to be a good choice. ...

Thanks Brian. DLE55 seems to be a good choice.
Mick15 it is a masterpiece. Great! Thank you for the video and advice.
04-30-2014, 01:07 PM
Replies: 19
Views: 4,958
Posted By syamaner

It would be a pleasure to watch your video. ...

It would be a pleasure to watch your video.
During my PPL lessons we have been taught not to use flaps with excessive sidewinds. But with my old Sea Fury I had noticed that in any weather condition...
04-30-2014, 12:27 PM
Replies: 19
Views: 4,958
Posted By syamaner

Thank you "irocbsa" and "mick 15". I made the...

Thank you "irocbsa" and "mick 15".
I made the first landing with the take off flap setting (maybe 10 - 15 degrees). Due to sidewind I elected not to use full flap. But I fully agree with you.
04-30-2014, 09:26 AM
Replies: 19
Views: 4,958
Posted By syamaner

I have read many comments about this aircraft...

I have read many comments about this aircraft where the builders said that “the plane flies like a charm”. Yes this was true! It is rock solid in the air (remember the 150 g/dm2 wing loading). DLE55...
04-30-2014, 09:14 AM
Replies: 19
Views: 4,958
Posted By syamaner

Now the aircraft was ready to fly. The engine had...

Now the aircraft was ready to fly. The engine had been already broken in several weeks ago. But what about the pilot? Was he ready???
The take off weight of the aircraft was around 11 kg and with a...
04-30-2014, 09:06 AM
Replies: 19
Views: 4,958
Posted By syamaner

After the engine and tank has been prepared and...

After the engine and tank has been prepared and mounted to the aircraft, it was almost ready to go to the field. The size was impressive (at least for me)! There was a little problem with the...
04-30-2014, 08:55 AM
Replies: 19
Views: 4,958
Posted By syamaner

After gluing the wing panels to the center...

After gluing the wing panels to the center section using the two (at each side) wood joiners the wing was almost ready.
Unfortunately the fuselage was not such straightforward. The elevators (two...
04-30-2014, 08:31 AM
Replies: 19
Views: 4,958
Posted By syamaner

ESM Sea Fury 30 - 40 cc. From box to air...

I will try to share my experience on an ESM Sea Fury with you.
Sea Fury is one of my favorite aircraft for more than three years. My first Sea Fury was manufactured by Seagull. It has been flying...
08-29-2011, 02:36 PM
Replies: 132
Views: 17,701
Posted By syamaner

RE: Flight-Model KI-61 ???

As far as I know there is a problem with retracts. The wing is not one piece and the aircraft is designed to have a single retract servo placed in the fuselage. So you have to mount and unmount the...
08-28-2011, 08:22 AM
Replies: 66
Views: 5,948
Posted By syamaner

RE: Lithium Battery Hysteria!!!....

I always balance charge my LiPo's without removing them from the plane.

I have a question to those who use a LiPo and a regulator as a receiver battery on a glow or gas powered aircraft: Do you...
08-28-2011, 06:03 AM
Replies: 66
Views: 5,948
Posted By syamaner

RE: Lithium Battery Hysteria!!!....

In our local forum we always have a similar discussion. Some friends say "LiPo + UBEC is the best" and others say "the only battery for RC is NiCd". :)
I am using all kinds of power sources in my...
Showing results 1 to 21 of 21


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.