RCU Forums - Search Results

Search: Posts Made By: nh4clo4

Showing results 1 to 4 of 4
Search took 0.04 seconds.

Forum: Scratch Building, Aircraft Design, 3D/CAD

06-07-2011, 05:34 AM

Replies: 26

CNCShark?

Views: 3,053

Posted By nh4clo4

RE: CNCShark?

Mine has an auto z setter. It is a piece of aluminum grounded to the spindle, when you push the auto z button, the router automatically lowers the z until the bit touches the aluminum. When it...

Forum: Scratch Building, Aircraft Design, 3D/CAD

06-06-2011, 03:33 PM

Replies: 26

CNCShark?

Views: 3,053

Posted By nh4clo4

RE: CNCShark?

.1 would be a good finish cut, it also depends on the plunge rate, what happens with a v bit is it's diameter gets larger as it plunges, and depending on the gantry, it will push it down, and when it...

Forum: Scratch Building, Aircraft Design, 3D/CAD

06-06-2011, 07:40 AM

Replies: 26

CNCShark?

Views: 3,053

Posted By nh4clo4

RE: CNCShark?

MDFproduces alot of resistance to v bits, Did you do 2 passes with the V bit or one? Iusually either set the tool parameters to get 2 passes to required depth, or set the first z high, then resend...

Forum: Scratch Building, Aircraft Design, 3D/CAD

06-05-2011, 09:51 AM

Replies: 26

CNCShark?

Views: 3,053

Posted By nh4clo4

RE: CNCShark?

Saramos, V carve is very good software, if you are more familiar on a different cad, you can always import those files in to V carve to write the tool paths. I use a different cad, then use V carve...

Showing results 1 to 4 of 4