RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: sol451
Showing results 1 to 25 of 36
Search took 0.74 seconds.
Forum: RC Sailboats
02-10-2012, 06:02 AM
Replies: 3
Views: 1,051
Posted By sol451

RE: using 6 ch. 2.4ghz heli radio & rx on rc sailboats

Most of our club members have used
the spectrum system that way for our sailboat
That works very well
02-27-2010, 11:31 AM
Replies: 14
Views: 7,529
Posted By sol451

RE: How long for shipping from Hobby King?

I have received orders within 10 to 14 days using standard shipping
and I have used Express which took 4 days but is a little pricey
and thats to Canada
...
Replies: 6
Views: 1,055
Posted By sol451

RE: Transmitter neck strap availability

I have purchased key lanyards at a Dollar store
that work well .Just make sure the clasp has a
strong spring
KP:)
Replies: 7
Views: 1,165
Posted By sol451

RE: Water flying with 2.4 Ghz radios

Several members of our model sailboat club now
use Spektrum systems in there boat with no problems
:)
02-24-2008, 01:14 PM
Replies: 1
Views: 516
Posted By sol451

power supply

I have a Multiplex charger and would like
to buy a power supply.What amount of amps
would I need. I charge 2000 to 2650 Milamp
4 or 8 pack batteries
Thanks...
11-12-2007, 08:50 AM
Replies: 4
Views: 800
Posted By sol451

RE: multiplex charger ln5014

To clarify my question the battery is a 2500 mil amp nickel metal trans pack
the charger plug uses standard servo wire I must have stated the wrong figures
for rate of charge Next times I will...
11-11-2007, 07:32 PM
Replies: 4
Views: 800
Posted By sol451

multiplex charger ln5014

I used my new Multiplex 5014 to charge to charge a 2500 mil amp
battery Ist the charger at .2 it charged for 2.2 hours ,then on the screen it said end
and showed 850 mil amps does this mean it...
Replies: 17
Views: 1,084
Posted By sol451

AM FM

If two people were racing and one had 75 fm channel 68 the other
was using 75 Am channel 68 would there be a problem with
interferance .
Thanks Ken
Forum: RC Sailboats
05-22-2007, 02:29 PM
Replies: 8
Views: 1,554
Posted By sol451

RE: sailwinch or arm options?

Consider using Futaba 3802 it has plenty of torque
but speed is a little slow . It`s compact size fits
very well and does not at weight to the boat [sm=thumbs_up.gif]
Replies: 0
Views: 648
Posted By sol451

futaba 2.4 run time

what is the run time if using the factory
600 ml amp battery[8D]
Replies: 8
Views: 1,541
Posted By sol451

RE: futaba 2.4

Was the stock battery not large enough to give you good flying time
how many minutes flying does the 1650 milamp give you[:o]
Replies: 8
Views: 1,541
Posted By sol451

futaba 2.4

Has anyone purchased the new Futaba 2.4 system
What are the run times from the factory supplied transmitter battery
I want actual times not factory specs
Replies: 1
Views: 501
Posted By sol451

lipo in transmiter

Is it possible to use a lipo Battery in
a transmiter example 2450 mil at 11.1 volt
ken
Replies: 15
Views: 2,004
Posted By sol451

RE: Spektrum TX blown fuses

I had the same problem when I first got my Spectrum
There is a notice in manual about reverse polarity for
charging [&o]
11-23-2006, 08:36 AM
Replies: 2
Views: 547
Posted By sol451

1dead cell

I recently damaged a 9 volt pack 2300 mil amp,after cheking all the cells I
found one was very low .2 volts the others charged back to 1.2
My question is what happens if I replace the dead cell...
11-13-2006, 09:19 AM
Replies: 2
Views: 453
Posted By sol451

ruined pack

After charging a 9.6 volt aa transmitter pack
I removed it from the charger with the charge plug attached
the plugs made contact, the battery heated up
and burned the wires. Too hot to hold....
Replies: 0
Views: 720
Posted By sol451

transmiter problem

I have hitec transmitters they are both laser 2 surface
The problem is that one alows my sail servo to fully rotate
and the other doesn`t. What could cause this problem
thanks...
Replies: 1
Views: 556
Posted By sol451

sail winch

Hi Mike
I am looking for a drum servo to use on a sailboat
I need torque and speed but it must be light , the hitec hs 785 b specs
say it turns 360 in 1.4 sec . Is this for one revolution
...
Replies: 1
Views: 460
Posted By sol451

Max Voltage

Hello Mike
Can you tell me the maximun voltage I
can use in my Ranger 2 z transmitter
Thanks Ken[sm=angry.gif]
Replies: 1
Views: 393
Posted By sol451

battery packs

Does Hitec make battery packs to fit transmitter
Ranger 2z .if so do they come in Nickel metal
Thanks Ken
Replies: 1
Views: 380
Posted By sol451

re transmitter

Hello Mike
I gave the wrong model description in the preveous post
My transmitter ia a Hitec Ranger 2Z. Can it be charged with the batteries
inside
...
Replies: 1
Views: 390
Posted By sol451

transmitter

I use a Hitec laser2 transmitter with my boats and wondering if i can charge the batteries
while still in the transmitter. I am using nickel metal 2000 mil amp Is there any modifications
to be...
Replies: 3
Views: 6,098
Posted By sol451

increase servo rotation

Can any one give me instructions on
how to increase servo rotation.
Thanks Ken[sm=confused.gif][sm=confused.gif]
Replies: 1
Views: 564
Posted By sol451

Increase rotation of servo

Some people say it is possible to increase the amount
of rotation on a servo . For example 120 degrees to 180.
Can you explain to me how it is done.
Thanks Ken
Replies: 2
Views: 418
Posted By sol451

RE: Servo repair canada

correct spelling
Showing results 1 to 25 of 36
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.