RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: trickle007
Showing results 1 to 17 of 17
Search took 0.04 seconds.
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
02-03-2012, 06:03 PM
Replies: 3,640
Views: 640,315
Posted By trickle007

RE: Official HPI Savage Flux XS thread...

I dont think it comes with a motor or ESC so it has to be cheaper then 300, I am hoping its priced around 150. IMO 200 would be to steep.
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
01-01-2012, 01:35 PM
Replies: 3,640
Views: 640,315
Posted By trickle007

RE: Official HPI Savage Flux XS thread...

for what ever reason my previous post did not post. I was asking if the HR cups came with the set screws for the cups?
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
01-01-2012, 09:08 AM
Replies: 3,640
Views: 640,315
Posted By trickle007

RE: Official HPI Savage Flux XS thread...

Do you have a link to the HR racing ones? I need to replace mine as well its not as bad as the pictured posted but i only run 2 times and the rear cup is all ready wearing bad.
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
12-30-2011, 08:45 AM
Replies: 3,640
Views: 640,315
Posted By trickle007

RE: Official HPI Savage Flux XS thread...

Well 2nd run with my truck I broke the rear hub carrier, but the part is all ready being delivered today so I will be back up and running in no time.For a monster truck this truck handles turns with...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
12-27-2011, 08:28 PM
Replies: 3,640
Views: 640,315
Posted By trickle007

RE: Official HPI Savage Flux XS thread...

yes the savage xs has a low voltage cut off built in, I set mine to auto cut off for 3.7 volts per cell, If i recall correct factory setting was set to auto cutoff at 3.0 volts per cell which imo is...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
12-26-2011, 02:15 PM
Replies: 3,640
Views: 640,315
Posted By trickle007

RE: Official HPI Savage Flux XS thread...

To Answer your battery question you dont want to store lipos full charge for extended period of times. As for the discharge part after a good run your batteries will be discharged so if you are not...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
12-25-2011, 11:32 PM
Replies: 3,640
Views: 640,315
Posted By trickle007

RE: Official HPI Savage Flux XS thread...

Ya the pinion gear grub screw was not lock tited so it caused it to slip down the motor shaft disengaging it from the trans. Chuggs it is pretty easy to access, 7 screws and the motor and trans drop...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
12-25-2011, 08:05 AM
Replies: 3,640
Views: 640,315
Posted By trickle007

RE: Official HPI Savage Flux XS thread...

Nope looks like I have to take it apart and take a look guess I was just a little impatient. does not look to easy to get to the pinion.
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
12-25-2011, 07:24 AM
Replies: 3,640
Views: 640,315
Posted By trickle007

RE: Official HPI Savage Flux XS thread...

Ok I just opened my XS up did the usual walk through, Binded the tx to rx programmed the ESC andtook the Flux out back for a test drive and it ran great for 5 minutes , then the motor just whines...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
12-04-2011, 12:23 PM
Replies: 3,640
Views: 640,315
Posted By trickle007

RE: Official HPI Savage Flux XS thread...

I copied HPI's part# from HPI's site for the Rubicon body and searched that part# on towers website and what I linked is what I came up with.

This is the 1/8 Scale body...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
12-04-2011, 12:00 PM
Replies: 3,640
Views: 640,315
Posted By trickle007

RE: Official HPI Savage Flux XS thread...

Here ya go Nitro-Rob 1st link to HPI wesite for picture as Tower does not have a picture of it on there site right now 2nd link Tower has this body in stock.

...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
12-03-2011, 09:42 AM
Replies: 3,640
Views: 640,315
Posted By trickle007

RE: Official HPI Savage Flux XS thread...

Nothing in the RC world is 100% waterproof imo.You have to take your own precations as well. If you are worried about the deans connectors getting wet waterproof it yourself by possibly wrapping with...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
12-02-2011, 11:29 AM
Replies: 3,640
Views: 640,315
Posted By trickle007

RE: Official HPI Savage Flux XS thread...

Ok I run windows 7 64 bit will that be an issue?
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
12-02-2011, 09:39 AM
Replies: 3,640
Views: 640,315
Posted By trickle007

RE: Official HPI Savage Flux XS thread...

Ok I am getting a XS for Xmas, My GF has it wrapped sitting under the tree all ready and its driving me nuts but I will wait till xmas to open it up. Anyway my question is will either these 2 castle...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
11-04-2011, 08:32 AM
Replies: 3,640
Views: 640,315
Posted By trickle007

RE: Official HPI Savage Flux XS thread...

Thanks T9 for the dimensions you posted. This is huge for me because I all ready own 2 of the turngy 2c 5200mah packs that I run my Vorza on. From the dimensions you posted it looks like my 5200mah...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
11-03-2011, 08:22 PM
Replies: 3,640
Views: 640,315
Posted By trickle007

RE: Official HPI Savage Flux XS thread...

Will These fit in the XS? http://www.hobbyking.com/hobbyking/store/__14991__Turnigy_5200mAh_2S_30C_Hard_Case_Car_Lipo_Pack_USA_Warehouse_.html
Showing results 1 to 17 of 17


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.