RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: airtourer
Showing results 1 to 25 of 53
Search took 0.64 seconds.
Forum: Batteries & Chargers
03-13-2016, 06:57 AM
Replies: 6
Views: 1,718
Posted By airtourer

PS the "node over amps" in the manual says to...

PS the "node over amps" in the manual says to check the wiring. My wiring on another PL8 works fine.
Paul
Forum: Batteries & Chargers
03-13-2016, 06:54 AM
Replies: 6
Views: 1,718
Posted By airtourer

Ps. I see " node over amps" message in the manual...

Ps. I see " node over amps" message in the manual says to check the wiring. My wiring setup on my friends PL8 works fine.
Forum: Batteries & Chargers
03-13-2016, 05:31 AM
Replies: 6
Views: 1,718
Posted By airtourer

Revolectrix Powerlab 8

Hello All,

I recently bought a PL8. I need some help please.

My problem is it won't charge at more than 3 amps. This is because I think it is only balance port charging and not charging through...
Forum: Futaba Radios Direct support forum
02-06-2016, 02:13 AM
Replies: 1
Views: 547
Posted By airtourer

Futaba 12z with Powerbox Competition

Hello,

Can anyone help please.

I have a Futaba 12z, and a glider which requires 13 channels.

The 12 th channel is used to extend the motor pod. How do I set up a Virtual Channel for the...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-06-2016, 01:52 AM
Replies: 0
Views: 424
Posted By airtourer

Futaba 12z Glider setup with Powerbox Competition.

Hello,

Can anyone help please.

I have a Futaba 12z, and a glider which requires 13 channels.

The 12 th channel is used to extend the motor pod. How do I set up a Virtual Channel for the...
Forum: RC Gliders, Sailplanes and Slope Soaring
04-24-2015, 04:44 AM
Replies: 1
Views: 1,514
Posted By airtourer

Hi, Found a readable link. Thanks, Paul

Hi,

Found a readable link. Thanks,

Paul
Forum: RC Gliders, Sailplanes and Slope Soaring
04-24-2015, 04:24 AM
Replies: 1
Views: 1,514
Posted By airtourer

Paritech ASG 29/ Jetec E90

Hello All,

I recently bought a Paritech ASG 29 and want to use a Jetec E90 for self launching.

Most web sites for the Jetec E90 show the same copied page with dimensions, but when enlarged...
Forum: Questions and Answers
11-19-2014, 01:40 AM
Replies: 4
Views: 475
Posted By airtourer

Os fx 160

Hi All,I have owned and operated an OS160 for a few years now, recently it is running hot to a point where it shuts down in flight. I have not changed fuels. Different plugs make no difference.The...
Forum: RC Gliders, Sailplanes and Slope Soaring
10-20-2014, 09:51 AM
Replies: 4
Views: 1,966
Posted By airtourer

Thanks that's the one. Cheers

Thanks that's the one. Cheers
Forum: RC Gliders, Sailplanes and Slope Soaring
10-20-2014, 02:29 AM
Replies: 4
Views: 1,966
Posted By airtourer

Aries 1960s Glider

Hi All,

Does anyone one remember a classic free flight glider by the name Aries, from memory about 2 meters wing span with polyhedral. I don't know who designed it, might have been late 50s early...
Forum: Gas Engines
05-30-2014, 12:24 AM
Replies: 1
Views: 625
Posted By airtourer

DA 150 Exploded View

Hello All,

Can anyone direct me to an exploded view of the DA150. Just curious what it looks like inside.

Cheers,

Paul
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
08-27-2013, 06:03 AM
Replies: 0
Views: 419
Posted By airtourer

Powerbox Competition

Hi All,

I have purchased a Powerbox Competition.

In the instructions it says to be careful which socket to use to connect the RX to the Powerbox. The instructions are somewhat confusing as to...
Forum: Questions and Answers
08-27-2013, 05:53 AM
Replies: 0
Views: 334
Posted By airtourer

Powerbox Competition

Hi All,

I have purchased a Powerbox Competition.

In the instructions it says to be careful which socket to use to connect the RX to the Powerbox. The instructions are somewhat confusing as to...
Forum: Gas Engines
02-24-2013, 12:40 AM
Replies: 69
Views: 5,868
Posted By airtourer

RE: Oil spatter

Hi Everyone,

Thanks for all your replies, suggestions.

Since writing my post I have tuned the engine up to where its now slightly lean. Fades a bit going up hill. Will richen a bit before...
Forum: Gas Engines
02-15-2013, 06:07 AM
Replies: 69
Views: 5,868
Posted By airtourer

RE: Oil spatter

Thanks for all your ideas. The engine is 150cc DA.

Paul
Forum: Gas Engines
02-15-2013, 04:20 AM
Replies: 69
Views: 5,868
Posted By airtourer

Oil spatter

Hi All,

Please see accompanying picture. I am curious what you think the cause is and how to remedy the excessive oil spatter.

The oil is mixed at 50:1 and is a fully synthetic type. The...
Forum: Gas Engines
09-12-2012, 09:55 PM
Replies: 3
Views: 767
Posted By airtourer

RE: DA 150

Hi Red and Speedy,

Thanks for your assistance,

Paul
Forum: Gas Engines
09-12-2012, 04:36 AM
Replies: 3
Views: 767
Posted By airtourer

DA 150

Hi All,

I have two questions regarding the tuning of my DA150, any suggestions appreciated.

The engine has had forty flights at ten minutes a flight plus ground run time setting up and...
Forum: Carden Aircraft
08-29-2012, 02:42 PM
Replies: 1
Views: 2,524
Posted By airtourer

RE: 40% Extra 300 Mid-wing

Hi all,

Have flown my Extra at the rear most CG position Dennis recommended for normal flying. The model flys very true and far exceeded
my expectations. In a word awesome.

Please enjoy...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
08-27-2012, 10:36 PM
Replies: 1
Views: 667
Posted By airtourer

Hitec Servos

Hello All,

Can someone inform me where I can have Hitec servos checked and overhauled if necessary.

Paul
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
04-10-2012, 06:43 AM
Replies: 4
Views: 597
Posted By airtourer

RE: Futaba12Z

Hi,

Tks for your help.

Paul
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
04-10-2012, 06:40 AM
Replies: 4
Views: 597
Posted By airtourer

RE: Futaba12Z

Hi,

Tks for your help.

Paul
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
04-09-2012, 06:50 AM
Replies: 4
Views: 597
Posted By airtourer

Futaba12Z

Hello All,

I need advice on how to set a condition where the ailerons both droop or raise a small amount. My setup has two chanels for aileron operation and no other mixes or condition...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-01-2012, 07:44 AM
Replies: 3
Views: 524
Posted By airtourer

RE: R6008HS with 12Z

Hi AV8R and Skaluf,

Thanks for your replies. I looked at that page several times today
and didnt notice the chart at the bottom.

Good time to give up sniffing glue huh......

Cheers.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-01-2012, 12:54 AM
Replies: 3
Views: 524
Posted By airtourer

R6008HS with 12Z

Hi All,

Can I use R6008HS Rx with my 12z Tx.

Tks,

Airtourer
Showing results 1 to 25 of 53
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.