RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: lposter
Showing results 1 to 19 of 19
Search took 0.04 seconds.
Forum: RC Tanks
05-10-2010, 01:46 PM
Replies: 43
Views: 3,225
Posted By lposter

RE: Identifying lost part

Just checked again.....its 7.8v on the TXside between the yellow and greenish cable.

So voltage is getting to the TXboard.

tried a different antannae as well just now but no luck there....
...
Forum: RC Tanks
05-10-2010, 01:37 PM
Replies: 43
Views: 3,225
Posted By lposter

RE: Identifying lost part

HI BIggTOny

Sorry about that.....I was actually getting voltage to the receiver board. Imeasured across two contacts on the TXside of the cable from the RXboard and got a voltage (cannot rememeber...
Forum: RC Tanks
05-10-2010, 11:21 AM
Replies: 43
Views: 3,225
Posted By lposter

RE: Identifying lost part

Hi folks

Today Igot two more crystal pairs and a new TXboard. Neither of which made any difference.

After significant and long term investment in this tiger I am in the position where Ican...
Forum: RC Tanks
05-04-2010, 02:57 AM
Replies: 43
Views: 3,225
Posted By lposter

RE: Identifying lost part

Hi BIggTOny

Its my wallet that deserves sympathy....I'll survive, it might not!

<div>

Thats correct..
Forum: RC Tanks
05-04-2010, 12:06 AM
Replies: 43
Views: 3,225
Posted By lposter

RE: Identifying lost part

Hi 1stSgt

I did indeed try the leg bending thing but to no avail. Ibent them until it required some serious flexing to get them in (at least on the TX board...theres not much room for much bending...
Forum: RC Tanks
05-03-2010, 01:21 AM
Replies: 43
Views: 3,225
Posted By lposter

RE: Identifying lost part

Sorry for all th eposts.....

Whats the difference between 01, 02, 03.....17 crystal sets?

I see them on rctank.de and the 01...03 sets are cheaper than later numbers? Anyone know and which...
Forum: RC Tanks
05-03-2010, 01:18 AM
Replies: 43
Views: 3,225
Posted By lposter

RE: Identifying lost part

Hi BiggTony

I did get another battery and with a fresh charge the fan did start. Im a bit worried about that as the first battery was at about 70% Ireckon....at which point the fan wouldnt spin.
...
Forum: RC Tanks
05-03-2010, 12:01 AM
Replies: 43
Views: 3,225
Posted By lposter

RE: Identifying lost part

HI folks

The transmitter led is on and steady red, blinking headlights and hiss from speaker. I have no access to other HL transmitter/crystals (except the spare ones).

As I genuinely have...
Forum: RC Tanks
05-02-2010, 01:16 PM
Replies: 43
Views: 3,225
Posted By lposter

RE: Identifying lost part

Slight update....there is a vague hiss noise from the speaker but it is in no way responding, in either volume or tone, to anything on the transmitter i.e. its there all th etime

p
Forum: RC Tanks
05-02-2010, 01:03 PM
Replies: 43
Views: 3,225
Posted By lposter

RE: Identifying lost part

OK..... I disconected the fan...no joy.

Disconnected everything except the TX board, power, volume control and speaker. Nothing happening.

I am assuming that the miniumum one can expect is the...
Forum: RC Tanks
05-02-2010, 07:46 AM
Replies: 43
Views: 3,225
Posted By lposter

RE: Identifying lost part

Iwas afraid someone would say that!

The fan wont be so easy to get out of the equation (Iused rccommand's method and taking it out would be a nightmare - or getting it back in).

Are there any...
Forum: RC Tanks
05-02-2010, 06:10 AM
Replies: 43
Views: 3,225
Posted By lposter

RE: Identifying lost part

Howdy

I finally got the spring issue sorted. Used a piece from the sprial binding of an A4 notepad, stripped the paint, heat hardened it, cut i to size and it works nicely.

I thought I was...
Forum: RC Tanks
04-11-2010, 04:12 AM
Replies: 43
Views: 3,225
Posted By lposter

RE: Identifying lost part

Nice pictures there BigTony and very helpful!

Ihave managed to get a spring in there but it is way too powerful. It takes a good deal of pressing to budge the barrel downwards and I doubt very...
Forum: RC Tanks
04-10-2010, 11:41 AM
Replies: 43
Views: 3,225
Posted By lposter

RE: Identifying lost part

Hi PantherG

Ihaev one more bag of "assorted springs"from Ebay which should be here Monday.....and if there isnt one in that, Imay have take you up on your offer....

p
Forum: RC Tanks
04-10-2010, 11:35 AM
Replies: 43
Views: 3,225
Posted By lposter

RE: Identifying lost part

HI BIg Tony

The spring Ilost was describedin my first post as "Its a loosely coiled spring that sits between the white bit (BBunit?)at the end of the barrel assembly and the roof of the turret."
...
Forum: RC Tanks
04-10-2010, 08:43 AM
Replies: 43
Views: 3,225
Posted By lposter

RE: Identifying lost part

Got myself two assortment boxes of springs but none of them were exact right size.

Installed the one closest to it (as decsirbed earlier) but have a serious case of barrel droop.

The elevation...
Forum: RC Tanks
04-08-2010, 01:47 PM
Replies: 43
Views: 3,225
Posted By lposter

RE: Identifying lost part

Friday would be grand..... its Thursday night here and Iwont be able to go shopping for one until the weekend.

appreciate it..
p
Forum: RC Tanks
04-08-2010, 01:34 PM
Replies: 43
Views: 3,225
Posted By lposter

RE: Identifying lost part

Thanks for that, Its a good plan....

If anyone has their tiger turret in pieces.....could they take a shot of the spring with a ruler beside it for scale (diameter and length)so Ihave something to...
Forum: RC Tanks
04-08-2010, 01:19 PM
Replies: 43
Views: 3,225
Posted By lposter

Identifying lost part

Ineed some help!

Ihave lost a piece out of the turret of my HLTiger....'

Its a loosely coiled spring that sits between the white bit (BBunit?)at the end of the barrel assembly and the roof of...
Showing results 1 to 19 of 19


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.