RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: keathebch
Showing results 1 to 9 of 9
Search took 0.06 seconds.
Forum: Glow Engines
05-30-2023, 06:41 AM
Replies: 3,345
Views: 416,330
Posted By keathebch

Thank You

Thank You
Forum: Glow Engines
05-25-2023, 04:16 AM
Replies: 3,345
Views: 416,330
Posted By keathebch

Does anyone have any push rod tubes? I could use...

Does anyone have any push rod tubes? I could use about 4.
Forum: Glow Engines
05-26-2020, 02:46 PM
Replies: 3,345
Views: 416,330
Posted By keathebch

Push rod tubes/Parts

Hi everyone, i am trying to locate some pushrod tubes used or new, or a substitute, I have cross referenced OS with no luck there so far. Thanks
Forum: Glow Engines
05-01-2020, 05:16 AM
Replies: 3,345
Views: 416,330
Posted By keathebch

The bottom cylinders seem to stop running, at...

The bottom cylinders seem to stop running, at idle without the glow driver. attached. and you will probably need to run a built in glow driver, that you can adjust to come on with a low throttle...
Forum: Glow Engines
05-01-2020, 05:08 AM
Replies: 3,345
Views: 416,330
Posted By keathebch

Hello everyone, does anyone have any pushrod...

Hello everyone, does anyone have any pushrod covers they can let go of. . I need a least 4
Thanks
Forum: Glow Engines
12-04-2019, 07:06 PM
Replies: 3,345
Views: 416,330
Posted By keathebch

thanks for the information, I agree that's a lot...

thanks for the information, I agree that's a lot of RPM. this is a new motor I bought in 2010,just now got around to using it. I propped it low to get it running, but if its ok to maiden with a...
Forum: Glow Engines
12-04-2019, 07:26 AM
Replies: 3,345
Views: 416,330
Posted By keathebch

Hello, got my motor running good but from your...

Hello, got my motor running good but from your experience could someone recommend a minimum tank size for the 400, I am looking for at least 5 minutes at mixed throttle. I am using a 20x8 prop...
Forum: Glow Engines
10-16-2019, 10:48 AM
Replies: 3,345
Views: 416,330
Posted By keathebch

I was cleaning and screwed the needle valve in...

I was cleaning and screwed the needle valve in until it became un screwed and the o ring showing. I then screwed it out until it stopped and back in about 4.5 turns is that close you think?
Forum: Glow Engines
10-15-2019, 07:47 AM
Replies: 3,345
Views: 416,330
Posted By keathebch

Could someone tell me where the starting settings...

Could someone tell me where the starting settings are for the low speed needle,...
Showing results 1 to 9 of 9


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.