RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: speedracerntrixie
Showing results 1 to 7 of 7
Search took 0.01 seconds.
Forum: Questions and Answers
09-07-2015, 09:25 AM
Replies: 36
Views: 5,759
Posted By speedracerntrixie

Very true. Some guys handle dead sticks better...

Very true. Some guys handle dead sticks better then others. Before getting into scale aerobatics I was deep into sailplanes. That experience helps greatly when the occasional deadstick happens....
Forum: Questions and Answers
09-06-2015, 06:47 AM
Replies: 36
Views: 5,759
Posted By speedracerntrixie

actually there is some merit with that statement....

actually there is some merit with that statement. I have been ordering bearings from R/C bearings.com and have been very pleased with the quality. I beleive they are better then the stock bearings at...
Forum: Questions and Answers
09-05-2015, 09:22 PM
Replies: 36
Views: 5,759
Posted By speedracerntrixie

Chuck, there are some things that will accelerate...

Chuck, there are some things that will accelerate bearing wear. Leaving fuel in the engine between flying sessions is the number one. I always pump the tank dry and then run the engine dry at idle....
Forum: Questions and Answers
09-05-2015, 11:26 AM
Replies: 36
Views: 5,759
Posted By speedracerntrixie

Yes, get the bearings in along with the crank...

Yes, get the bearings in along with the crank and a prop. No piston and rod yet. Place this in an oven at 200 degrees for 1/2 hour, take out and firmly stike the case a couple times with large...
Forum: Questions and Answers
09-05-2015, 09:41 AM
Replies: 36
Views: 5,759
Posted By speedracerntrixie

You may be in for a new set of bearings. When...

You may be in for a new set of bearings. When they get play the seal between the case and crank is compromised and you get an air leak. Seems its an air leak issue from somewhere you just need to...
Forum: Questions and Answers
09-05-2015, 08:16 AM
Replies: 36
Views: 5,759
Posted By speedracerntrixie

Chuck, I'm aware that the 160 is glow, i...

Chuck, I'm aware that the 160 is glow, i mentioned the higher idle because its common practice on larger engines in general. Obviously you are having a fuel draw issue during maneuvers where you are...
Forum: Questions and Answers
09-04-2015, 07:13 AM
Replies: 36
Views: 5,759
Posted By speedracerntrixie

Check the pressure nipple on your muffler. Some...

Check the pressure nipple on your muffler. Some times they can get some debris that will restrict the line. I would also try a felt clunk. That being said, it is common with the larger gasoline...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.