RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: NBE1
Showing results 1 to 8 of 8
Search took 0.06 seconds.
Forum: Esky Helicopters
08-18-2010, 10:42 PM
Replies: 6,242
Views: 563,939
Posted By NBE1

RE: .........

Well the belt cp is officially dead!!! Long story short had some people look at it andit crashed and died. I now have a heli-max axe 400 RTR. Just got it and am excited. Thank you for all your advise.
Forum: Esky Helicopters
08-18-2010, 10:40 PM
Replies: 6,242
Views: 563,939
Posted By NBE1

RE: .........
Forum: Esky Helicopters
08-02-2010, 09:50 PM
Replies: 6,242
Views: 563,939
Posted By NBE1

RE: .........

I'll try the ESC thanks Disney1. The stock rotor head is not usable:) my bad.
Forum: Esky Helicopters
08-02-2010, 07:17 PM
Replies: 6,242
Views: 563,939
Posted By NBE1

RE: .........

Thank you for the explanation. Yes, currently I am using all stock gear (except the rotor head). I have heard that there is problems with the stock ESC but the head is spinning up.
Forum: Esky Helicopters
08-01-2010, 08:51 PM
Replies: 6,242
Views: 563,939
Posted By NBE1

RE: .........

The battery is in good shape. I do have an iPhone and will look into that. I have been looking at this head vs the stock and what is the difference between Bell-Hiller mixing and CCPM for the rotor....
Forum: Esky Helicopters
07-30-2010, 12:09 PM
Replies: 6,242
Views: 563,939
Posted By NBE1

RE: .........

So my swash plate is level with all servos at 90 deg, and in my infanite wisdom I set pitch of both blades not just one:). Now at full throttle it will just want to tip right. Still will not get any...
Forum: Esky Helicopters
07-28-2010, 02:07 PM
Replies: 6,242
Views: 563,939
Posted By NBE1

RE: .........

Flybar is level and head speed comes up. The heli gets light on its skids but does not want to get airborne. I read on xheli discussion that the stock swash plate and shaft need to be used with the...
Forum: Esky Helicopters
07-27-2010, 03:40 PM
Replies: 6,242
Views: 563,939
Posted By NBE1

RE: .........

Hello. I have a newbie Belt CP question. I just installed the EXI CNC rotor head and tail on my CPv1 and now I cannot get any lift. Heli tries to pick up at full throttle and begins to lean left...
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.