RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: 209mark123
Showing results 1 to 25 of 233
Search took 0.19 seconds.
09-20-2012, 01:08 PM
Replies: 0
Views: 516
Posted By 209mark123

Anybody know if these are any good?

Normally Iwould stay away from anything integy, but these have caught my eye.www.integy.com/st_prod.html (http://www.integy.com/st_prod.html?p_prodid=14275&p_catid=267#.UFuFA1HZh8E). Ihave been...
09-08-2012, 05:49 PM
Replies: 7
Views: 4,528
Posted By 209mark123

RE: Savage xs wont move??

All the gears in the tranny are fine actually, one of the slipper pads looks really worn down so Im changing that to see if it helps. My slipper nut seemed to be tight when Itook it apart so I dont...
09-04-2012, 10:59 PM
Replies: 23
Views: 1,616
Posted By 209mark123

RE: Flux HP stock wheel nuts

So far Ihavent had any problems with them. Time will tell Iguess normally Idont use anything integy but Ithought Iwould give these a shot.
09-04-2012, 09:42 PM
Replies: 7
Views: 4,528
Posted By 209mark123

RE: Savage xs wont move??

Found the exploded bearing left that diff out turned the car on with the front diff still in and it was still having the same problem. So I took the front diff out and ripped them both apart and all...
09-04-2012, 07:26 PM
Replies: 7
Views: 4,528
Posted By 209mark123

RE: Savage xs wont move??

Actually Ijust ripped apart the rear diff and discovered on of the bearings that sit on both sides of the diff on the shafts has totally exploded think this could be the problem forgive me if some of...
09-04-2012, 06:29 PM
Replies: 7
Views: 4,528
Posted By 209mark123

RE: Savage xs wont move??

Another weird part about it is that if Inudge it with my foot it will move under it own power but from a stand still it will just stutter
09-04-2012, 04:03 PM
Replies: 7
Views: 4,528
Posted By 209mark123

Savage xs wont move??

Irecently started having this problem my savage xs wont move when Ihit the throttle makes like a grinding noise as its trying to move but it just stutters. Now when Idid pick it up and held it in the...
09-04-2012, 04:00 PM
Replies: 23
Views: 1,616
Posted By 209mark123

RE: Flux HP stock wheel nuts

Yes these are specifically for the savage www.ebay.com/itm/Integy-C22926-Aluminum-Hex-Wheel-Hub-17mm-Savage-New-/290767531251...
09-03-2012, 12:59 AM
Replies: 12
Views: 1,226
Posted By 209mark123

RE: Savage Flux not going

I think it comes loose eventually no matter what you use, it will just take longer with red. mine went about 4 months though when I used red but it finally backed off. The trick is letting it sit for...
09-02-2012, 11:09 PM
Replies: 12
Views: 1,226
Posted By 209mark123

RE: Savage Flux not going

20 might be a exaggeration Ihave taken it apart quite a few times messing with different gearing options though probably more like 15. Also had one pinion strip out once point is that red loctite if...
09-02-2012, 04:56 PM
Replies: 12
Views: 1,226
Posted By 209mark123

RE: Savage Flux not going

Red loctite is fine you will be able to get it off blue is way to weak for the kind of power this thing has. I have been able to get it off without using heat no problem well over 20 times. Even...
09-02-2012, 12:24 PM
Replies: 12
Views: 1,226
Posted By 209mark123

RE: Savage Flux not going

Easy basically the pinion gear which is the one on the motor has a very small screw in it holding it to the shaft. It walks out over time happened to me 5 mins after Igot the thing. Pull the screw...
09-02-2012, 12:19 PM
Replies: 23
Views: 1,616
Posted By 209mark123

RE: Flux HP stock wheel nuts

Ive had the same problem if you wanna save money I suggest RED loctite and let it dry for 24 hours should fix it no problem. But as someone who has had the same problem I ended up ordering a set of...
08-22-2012, 11:25 PM
Replies: 3
Views: 753
Posted By 209mark123

RE: Big Bore shocks

Ihave heard the aluminum big bores tend to leak a lot, the two on each corner is great for jumping not so great for handling
08-16-2012, 06:22 PM
Replies: 21
Views: 1,389
Posted By 209mark123

RE: FLUX HP battery question

Got the batteries in today soldered on some deans and ran them truck had plenty of power at least as much as my 40c batteries no overheating 20 min run time. Didnt turn out to bad actually.
08-13-2012, 11:17 AM
Replies: 21
Views: 1,389
Posted By 209mark123

RE: FLUX HP battery question

I appreciate the info Iknow what your saying Ihave a 5000mah 50c set and they last a long time Iprobably should have tried to be so cheap but I appreciate the help.
08-13-2012, 10:50 AM
Replies: 21
Views: 1,389
Posted By 209mark123

RE: FLUX HP battery question

I see well what Iordered was a Gens ace 4000mah 2S1P 7.4V 30C hard casewith 50c burst. Like Isaid earlier Iam new and dont really know much about electricity, you think Iwill fry these batteries if...
08-12-2012, 12:15 PM
Replies: 21
Views: 1,389
Posted By 209mark123

RE: FLUX HP battery question

Imay be wrong but the book recommends a minimum of 25c and it says if you use 30c you need more tan 3000mah. Ihave been running venom 4000mah 40c in it without isssue for 6 months.
08-11-2012, 08:50 PM
Replies: 21
Views: 1,389
Posted By 209mark123

RE: FLUX HP battery question

Ihave heard good things about the gens ace they are selling out of them quickly
08-11-2012, 05:20 PM
Replies: 21
Views: 1,389
Posted By 209mark123

RE: FLUX HP battery question

Im not saying turnigy is bad just seemed the gens ace get a lot better reviews these are the ones www.hobbypartz.com/98p-30c-4000-2s1p-hardcase-direct.html...
08-11-2012, 11:57 AM
Replies: 21
Views: 1,389
Posted By 209mark123

RE: FLUX HP battery question

Thanks guys, I ended up ordering gens ace instead they were on sale and I have heard they are a better battery.
08-10-2012, 11:12 PM
Replies: 21
Views: 1,389
Posted By 209mark123

FLUX HP battery question

Been a long time since Ihave been on here Irecently sold my nitro savage and bought a FLUXHPI have been looking at some new batteries for it and Iam having some problems Im looking at these...
04-02-2012, 09:47 AM
Replies: 3,640
Views: 638,275
Posted By 209mark123

RE: Official HPI Savage Flux XS thread...

I dont know if you guys know or not but I called HPI about my esc to see when they were gonna send it back (they have had it for about a month). They said the esc's were back ordered but were suppost...
03-30-2012, 06:35 PM
Replies: 37
Views: 8,104
Posted By 209mark123

RE: hpi savage flux hp wheelie bar

Pretty good little truck really. Not near as durable as the HPbut for what it is Ilike it. The stock esc is junk although mine outlasted most peoples but it finally gave out. But Iknew it probably...
03-30-2012, 04:33 PM
Replies: 37
Views: 8,104
Posted By 209mark123

RE: hpi savage flux hp wheelie bar

At first Iwas not interested at all in it, so Iwent ahead and bought the nitro savage. But after a year of messing around having to tune it all the time carry around a roto start and fuel, not to...
Showing results 1 to 25 of 233
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.