RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: EXT2Rob
Showing results 1 to 4 of 4
Search took 0.02 seconds.
Replies: 6
Views: 1,021
Posted By EXT2Rob

RE: motor stutters, no go

Happy New Year, indeed!  That connector was the problem.  The male end has a splined spring-tension collar. I used a hobby knife to open them up, and the connection is better.  Car runs fine again! ...
Replies: 6
Views: 1,021
Posted By EXT2Rob

RE: motor stutters, no go

Went and had a look at the motor wires this morning.  I used a hobby knife to "open up" the splines on the bullet connector to the motor that seemed not as tight as the other two.  Turned on the car...
Replies: 6
Views: 1,021
Posted By EXT2Rob

RE: motor stutters, no go

Right.  Did all those things.  I did notice one of the three motor wire connectors seemed a little less tight than the other two.  That would do it, huh?
Replies: 6
Views: 1,021
Posted By EXT2Rob

motor stutters, no go

I know I've seen this subject here before, but danged if Ican't find it. Ihave an EZrun 35A 4300kv motor system, the one with the blue finned motor. It's about a year old and has been great since...
Showing results 1 to 4 of 4


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.