RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 4
1
2
3
Last »
Search: Posts Made By: Joecool73
Showing results 1 to 25 of 99
Search took 0.16 seconds.
Forum: Traxxas Monster Truck forum
12-12-2014, 06:14 AM
Replies: 17
Views: 4,583
Posted By Joecool73

Nice drjav, I just put the tekno m6s on the rear...

Nice drjav, I just put the tekno m6s on the rear last night. I only run on 6s and its awesome fun, got to have throttle control for sure. Did you have any problems getting the hex pin in the hex on...
Forum: Traxxas Monster Truck forum
12-04-2014, 04:48 AM
Replies: 17
Views: 4,583
Posted By Joecool73

Im sorry for the confusion, the rear right drive...

Im sorry for the confusion, the rear right drive shaft is what snapped off, the output yoke 6828X http://www3.towerhobbies.com/cgi-bin/wti0001p?&W=002150286&I=LXAVNK&P=K which in turn made me lose...
Forum: Traxxas Monster Truck forum
12-03-2014, 10:49 AM
Replies: 17
Views: 4,583
Posted By Joecool73

I broke the output yoke on the right rear side...

I broke the output yoke on the right rear side that attaches to the motor shaft. one of the ears on the yoke just shredded off. as for the u joint and interior halfshaft those are mia. I'm...
Forum: Traxxas Monster Truck forum
12-01-2014, 04:34 PM
Replies: 17
Views: 4,583
Posted By Joecool73

Just a heads up. Wound up getting a new Traxxas...

Just a heads up. Wound up getting a new Traxxas Platinum 4x4 slash and it did come with the newer 4 pole VXL. I dropped that into my wifes 2wd slash and put the 1515 Castle 8th combo in the...
Forum: Traxxas Monster Truck forum
11-05-2014, 02:47 PM
Replies: 17
Views: 4,583
Posted By Joecool73

A little bummed. My sidewinder 8th will fit in...

A little bummed. My sidewinder 8th will fit in the stock 2WD slash transmission but there is no room to mesh the gears without heavily modding the trans case. So now I wonder if I should buy a 4x4...
Forum: Traxxas Monster Truck forum
11-04-2014, 03:36 PM
Replies: 17
Views: 4,583
Posted By Joecool73

Awesome tips, thanks. The difference from the CC...

Awesome tips, thanks. The difference from the CC 3800Kv to the sidewinder 8th motor is approx. 3mm in diameter. So it should fit without a problem on the stock tranny. Ill have the motor tomorrow...
Forum: Traxxas Monster Truck forum
11-03-2014, 08:19 AM
Replies: 17
Views: 4,583
Posted By Joecool73

I will start with a single 3s lipo and work up...

I will start with a single 3s lipo and work up from there based on gearing. this is my wife's Ford Raptor Slash. I wanted to put something in it more powerful than the VXL 4 pole combo or the...
Forum: Traxxas Monster Truck forum
11-01-2014, 04:54 PM
Replies: 17
Views: 4,583
Posted By Joecool73

Ford Raptor Sidewinder 8th Combo

Bought my wife a Traxxas Ford Raptor Slash a few months ago to get her into the hobby. She loves bashing now as much as I do. Since she had the stock brushed xl-5 and Titan 12T motor, I upgraded to...
Forum: Traxxas Monster Truck forum
10-22-2014, 04:26 PM
Replies: 0
Views: 1,429
Posted By Joecool73

Castle SCT SV3 3800KV Combo ESC Fabricated Mount

Im sure its been done a few times but here is how I mounted my Castle SCT SV3 ESC to my Ford Raptor Slash. Used an electrical box and gaskets to hold it on. Works great. Even the hardest crashes...
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
10-03-2014, 02:33 PM
Replies: 2
Views: 1,401
Posted By Joecool73

Yep saw it and Rcnetwork on youtube did a...

Yep saw it and Rcnetwork on youtube did a unboxing on the arrma kraton as well as bigsquid has a write up coming. Want to see some running videos,both the kraton and the typhon look excellent.
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
09-27-2014, 07:23 AM
Replies: 2
Views: 1,401
Posted By Joecool73

Arrma 1/8 Typhon and Kraton

Anyone seen any running videos of either of these yet? I only have found 1 unboxing video at https://www.youtube.com/watch?v=YBiIk2UC_xI . Tower hobbies has the Typhon in stock and the Kraton on...
Forum: Questions and Answers
03-20-2014, 01:53 PM
Replies: 870
Views: 165,490
Posted By Joecool73

Good For March 2014 Your Promotional...

Good For March 2014



Your Promotional Offers


Coupon #
Promotional Offer
Good Thru
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
03-18-2014, 01:34 PM
Replies: 1
Views: 975
Posted By Joecool73

Traxxas Rustler VXL Drag link

What is a good way to tighten up the drag link to remove slop? I have way to much wheel wobble from the drag link slop. You guys know what Im talking about, you hold the tire in your hand and move...
Forum: Batteries & Chargers
09-22-2012, 09:57 AM
Replies: 3
Views: 1,266
Posted By Joecool73

RE: LVC IC PCB for 5S Lipo

Here are some of the finished project pics minus the PCB for the LVC. Still working on that.
Forum: Batteries & Chargers
09-08-2012, 03:42 AM
Replies: 3
Views: 1,266
Posted By Joecool73

LVC IC PCB for 5S Lipo

Any of you guys know where to buy a LVC for a 5S lipo? I have several lipos for various RC's that I have like the ERBE, Rustler, MCPX, Align 450, etc,etc. My 1.2A Ni CD batteries recently died in...
Forum: Beginners
08-19-2012, 04:45 AM
Replies: 36
Views: 3,452
Posted By Joecool73

RE: Which Iron ?

Ive been using this butane one for a few months now. Lasts long and can go anywhere. Ready to solder from off to on in ≈ 30 seconds. Adjustable Watts range from 30 to 70 watts. I really like it...
Forum: Traxxas Monster Truck forum
07-28-2012, 04:28 AM
Replies: 2
Views: 738
Posted By Joecool73

Erevo Erbe Air Vent = Temp Down

Im sure you guys have seen many people impale their rc bodies to allow more airflow to the electronics. Im no different and wanted a cooler motor and esc. Im running 18/54, 6S 5A 40C and all...
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
07-25-2012, 06:53 AM
Replies: 9
Views: 2,187
Posted By Joecool73

RE: 3.8 Hard Compund Tires for Bashing

They look good. I ad the trenchers on my rustler vxl a while back and mounted them on the stock wheels. They are a good tire. For my erevo I'm looking more for the stock size that they come with. ...
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
07-23-2012, 05:23 PM
Replies: 9
Views: 2,187
Posted By Joecool73

RE: 3.8 Hard Compund Tires for Bashing

Nice info guys. However, Im looking for a tire that is close to the original in size. I think the badlands by proline are the closest. Going to use the stock traxxas rims and stick these tires on...
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
07-22-2012, 01:19 PM
Replies: 9
Views: 2,187
Posted By Joecool73

3.8 Hard Compund Tires for Bashing

My new ERBE needs some new shoes. I run mostly off road bashing style on 6S with 18/54 gearing. Looking for a hard compound tire. Not finding very many choices. Any of you guys running a hard...
Forum: RC Car General Discussions
07-17-2012, 02:42 PM
Replies: 3
Views: 2,061
Posted By Joecool73

RE: How to balance rc tire

Thanks for the tips guys. I wound up just balancing the wheels using one of the axles on the truck. Removed the yoke from the tranny and took off a e clip so the stub axle would spin freely on the...
Forum: Traxxas Monster Truck forum
07-15-2012, 07:03 AM
Replies: 2
Views: 5,552
Posted By Joecool73

Erevo Erbe bashing 6S 18/54

Just curious how many of you guys are bashing the ERBE with 18/54 gearing with 6S or 22.2 Volts? I only run the 6S and it is awesome offroad. Had the 65 spur and wanted a little more offroad speed....
Forum: Traxxas Monster Truck forum
07-08-2012, 04:13 AM
Replies: 2
Views: 795
Posted By Joecool73

RE: Peer pressure made me buy a EREVO

Hey thanks. Im happy to say Ive had it for a few days and nothing has broke. I must be doing something wrong. I am running 6S 5A 40C Zippy Flight Max lipos; Little bit of work to make them fit but...
Forum: Traxxas Monster Truck forum
07-07-2012, 09:48 AM
Replies: 2
Views: 795
Posted By Joecool73

Peer pressure made me buy a EREVO

Since everyone is buying these EREVO ERBE's, I didnt want to get left out. Here are a couple of pics for your amusement.
Forum: RC Car General Discussions
07-06-2012, 11:14 AM
Replies: 3
Views: 2,061
Posted By Joecool73

How to balance rc tire

tire is on the balancer. find the heavy and light spot. Add putty to the light spot. Then what ? Keep adding or removing putty til:
1. The tire keeps spinning in one direction only and never...
Showing results 1 to 25 of 99
 
Page 1 of 4
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.