RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Nostromo1
Showing results 1 to 7 of 7
Search took 0.01 seconds.
Forum: RC Jets
08-10-2022, 07:04 PM
Replies: 252
Views: 58,179
Posted By Nostromo1

I would appreciate it if someone could let me...

I would appreciate it if someone could let me know what length exhaust bends they used? Distance measured from the exterior surface of the cowling (normal to the surface) to the inner surface of the...
Forum: RC Jets
08-05-2022, 11:23 AM
Replies: 252
Views: 58,179
Posted By Nostromo1

I made a few changes to the landing gear rails....

I made a few changes to the landing gear rails. I'll upload the photos soon. I got the Xicoy mounted yesterday and the exhaust cutouts in the cowling are quite a bit off, so that'll require some...
Forum: RC Jets
07-11-2022, 04:53 PM
Replies: 252
Views: 58,179
Posted By Nostromo1

Measurement this morning revealed that each tank...

Measurement this morning revealed that each tank is just above 1700cc, so I agree, one tank will be sufficient for a 5-6 min flight. I'll go that route. Thanks
Forum: RC Jets
07-10-2022, 06:03 PM
Replies: 252
Views: 58,179
Posted By Nostromo1

Hello, I am working on the fuselage with the aim...

Hello, I am working on the fuselage with the aim of installing a Xicoy X45TP. The CG appears to correspond to the front edge of the wing joiner tube. I am trying to decide how to install the two...
Forum: RC Jets
11-23-2021, 07:15 AM
Replies: 252
Views: 58,179
Posted By Nostromo1

Do look at Eurokitshop for struts. I have them on...

Do look at Eurokitshop for struts. I have them on three airplanes and plan on using them on the Tucano as well this winter. Their struts are machined (not cast) to close tolerances and are...
Forum: RC Jets
10-22-2021, 08:43 AM
Replies: 252
Views: 58,179
Posted By Nostromo1

I just recently ordered the turboprop configured...

I just recently ordered the turboprop configured for the Xicoy. Plan is to install Electron retracts and Eurokitshop struts which are hydraulic.
As asked in another post, would folks with flying...
Forum: RC Jets
11-20-2020, 05:09 PM
Replies: 252
Views: 58,179
Posted By Nostromo1

Could someone tell me who is the US distributor...

Could someone tell me who is the US distributor for the kit? I only found it listed on the kingtech luxumbourg site.
Also I'm looking at the xicoy x45tp which is firewall mounted. Any thoughts...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.