RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: Scoubidou
Showing results 1 to 25 of 500
Search took 0.76 seconds.
07-17-2011, 02:17 PM
Replies: 4
Views: 964
Posted By Scoubidou

RE: 12X flight mode for heli

Hi guys
i found my problem. The stunt trim was set to COM and it must be set to Fmod when using flight mode. Now i don't have to play with the dual rate switches to change rates on each flight...
07-05-2011, 04:43 PM
Replies: 4
Views: 964
Posted By Scoubidou

RE: 12X flight mode for heli

thank you, i have flown IMAC planes for so many years with the flight mode switch i thought the helis work the same...Presently, the pitch and throtle curves work fine by flipping the switch mode...
07-04-2011, 05:53 PM
Replies: 4
Views: 964
Posted By Scoubidou

12X flight mode for heli

Hello
I want to use my 12x to fly helis in 3 flight modes without playing with the dual rate switches.

How do you programm the 12X to get different rates on ailerons/elevator/rudder by using a...
Forum: Gas Engines
07-23-2009, 12:52 PM
Replies: 6,847
Views: 912,575
Posted By Scoubidou

RE: RCGF Engines

I bought NIB last winter from KMP.

The only way i found to sart it from cold, is to remove the plug, inject gas directly over the piston, re-install the plug and put 50% choke and flip the...
Forum: Gas Engines
07-22-2009, 05:29 PM
Replies: 6,847
Views: 912,575
Posted By Scoubidou

RE: RCGF Engines

I burned the first tank today of gas mixed 32:1 t to play with the needle on my old RCGF 26.

The engine was a pain to start and turned barely 6700 RPM with Xoar 17x8 or Mejlzlick 16x10. The...
03-25-2009, 08:50 PM
Replies: 8
Views: 3,739
Posted By Scoubidou

RE: 40% Edge 540 build

fiber glass pipe tunnel, Nice!
03-22-2009, 08:47 AM
Replies: 6
Views: 1,784
Posted By Scoubidou

RE: Photos of the New Lightened Gear?

They should look like this?
03-20-2009, 07:41 AM
Replies: 6
Views: 1,784
Posted By Scoubidou

RE: Photos of the New Lightened Gear?

Thanks Dan.

Are the Carden's gears milled from Carden shop workers or they sell TNT milled landing gears?
Daniel
03-17-2009, 01:24 PM
Replies: 6
Views: 1,784
Posted By Scoubidou

Photos of the New Lightened Gear?

Anyone has a photo of the new Carden Lightened Gears listed on the website?
Daniel
Detail:
118" Extra 260 - $85.00

Stock Gear: 23 - 24 oz / Lightened Gear: 16 - 17 oz
03-10-2009, 08:37 AM
Replies: 23
Views: 7,781
Posted By Scoubidou

RE: Carden 37.5% Yak Build

subscribed:D
Did you put a balsa sheet between the fiberglass and foam for the pipe tunel?
Daniel
02-16-2009, 09:47 PM
Replies: 19
Views: 3,012
Posted By Scoubidou

02-15-2009, 07:43 PM
Replies: 1,810
Views: 230,695
Posted By Scoubidou

RE: Extreme Flight 110" 100cc Yak 54 Build!

Hello diamondave
I liked the Biela 26x10 on my Super ZDZ80 and KS-95 canister better than Mejlzick 26x10. The Mejzilck 26x10 spined 300 RPM faster than Biela and it's a better 3 prop at 6700 RPM...
02-10-2009, 03:10 PM
Replies: 19
Views: 3,012
Posted By Scoubidou

RE: KMP Spitfire w Gasser

No problems
I'll update you in the progress.

Good idea about the 3600ma Nicad pack. I wanted to use A123 1100mA but i'll keep it for my DA-100.:D
Daniel
02-10-2009, 07:20 AM
Replies: 19
Views: 3,012
Posted By Scoubidou

RE: KMP Spitfire w Gasser

It should be the same , i bought mine last fall
Here is the bottom left wing
02-08-2009, 04:35 PM
Replies: 19
Views: 3,012
Posted By Scoubidou

RE: KMP Spitfire w Gasser

Hello
When i bolted the engine and checked the CG , the Spitfire needed 1 pound in the nose to balance to the recommended CG??

I have to much project ongoing right now and i decided to pass...
Forum: Gas Engines
02-02-2009, 09:59 PM
Replies: 6,847
Views: 912,575
Posted By Scoubidou

RE: RCGF Engines

Just a quick question for the RCGF 26CC here:

Is it possible to rotate the carb 180 degrees? It will be easier for me to set the needles valves from the top.

Daniel
01-18-2009, 08:07 PM
Replies: 1,810
Views: 230,695
Posted By Scoubidou

RE: Extreme Flight 110" 100cc Yak 54 Build!

Ok I hope EF will be generous like they did for you Diamondave! Do you know the yellow Ultracote part number ? I would like to seal the aileron gap with the same covering..
Daniel
01-18-2009, 06:31 PM
Replies: 1,810
Views: 230,695
Posted By Scoubidou

RE: Extreme Flight 110" 100cc Yak 54 Build!

The Chineese painter on QA was sleeping when mine was painted...
The yellow paint on the canopy is already removing by itself and i have not flown it yet? Any suggestions to fix it?
Daniel
01-11-2009, 07:45 PM
Replies: 1,810
Views: 230,695
Posted By Scoubidou

RE: Extreme Flight 110" 100cc Yak 54 Build!

Anyone use a servo choke in that Yak? There is not much room beside the throttle servo when using cansiters and I was wondering where should i put it?
Daniel
12-21-2008, 08:23 AM
Replies: 1
Views: 1,157
Posted By Scoubidou

RE: stabilizer slack

My 35% 260 did the same thing after 150 flights. I have simply put some drops of thin CA over the stab tube to fill the gap between the tube and stab tube.
12-03-2008, 08:33 AM
Replies: 3
Views: 882
Posted By Scoubidou

RE: USB commander replacement?

I use my sim mostly to practice IMAC and precision flying.
The sticks are not broken but they have a slack at the neutral position. I can not move the sticks by 1/8''without the wanted effect on...
12-02-2008, 09:00 AM
Replies: 3
Views: 882
Posted By Scoubidou

USB commander replacement?

Hello
My lovely daughter played with the AFP commander to roughly and the sticks on the USB commander would need adjustement. Is there a way to repair the commmander or order a new one?
Another...
11-16-2008, 08:31 PM
Replies: 2
Views: 367
Posted By Scoubidou

11-14-2008, 01:19 PM
Replies: 145
Views: 31,084
Posted By Scoubidou

RE: 100cc Extra 300 ARF QB

What's the lenght , rudder to front cowl?
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.