RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: capnpaul
Showing results 1 to 8 of 8
Search took 0.05 seconds.
Forum: Gas Engines
08-02-2016, 03:48 PM
Replies: 1,678
Views: 461,839
Posted By capnpaul

Hi Discus-fly, i think you will find the ignition...

Hi Discus-fly, i think you will find the ignition fires when the magnet leaves the senser, not when it comes up to it.
Check some of CH Ignition videos for more information.
Forum: Gas Engines
11-19-2015, 10:59 AM
Replies: 1,678
Views: 461,839
Posted By capnpaul

I am getting 7400 RPM with a 18-6 classic prop. I...

I am getting 7400 RPM with a 18-6 classic prop. I noticed when i change to a good synthetic oil rpm went up.
One thing i did was add a check valve or PVC valve in the tube going to the manifold and...
Forum: Gas Engines
11-18-2015, 11:59 AM
Replies: 1,678
Views: 461,839
Posted By capnpaul

Hi Erwin, what size prop are you using? It sounds...

Hi Erwin, what size prop are you using? It sounds very loaded down.
Forum: Gas Engines
11-16-2015, 07:33 AM
Replies: 1,678
Views: 461,839
Posted By capnpaul

Thats a good point. What i noticed is when i hold...

Thats a good point. What i noticed is when i hold the push rod against the tappet and rotate the engine you can feel the tappet fall off the top of the cam. This is what gouged the cam. I radiused...
Forum: Gas Engines
11-15-2015, 07:16 AM
Replies: 1,678
Views: 461,839
Posted By capnpaul

Hi Jim, I ordered a new crankcase and...

Hi Jim,
I ordered a new crankcase and motor mount also from Austars. My NGH38 came as the "pro" model with no lugs to beam mount it. The standoffs didn't fit that good and on a deadstick...
Forum: Gas Engines
10-25-2015, 01:51 PM
Replies: 1,678
Views: 461,839
Posted By capnpaul

Jim, thats a good web site for NGH parts. Let us...

Jim, thats a good web site for NGH parts. Let us know how you make out.
Forum: Gas Engines
10-25-2015, 09:21 AM
Replies: 1,678
Views: 461,839
Posted By capnpaul

I would take it to a weld shop that does tig...

I would take it to a weld shop that does tig welding. I've seen these guys weld two beer cans together the manifold shoud be a piece of cake.
If its only a crack you could try JB weld.
good luck,
Forum: Gas Engines
05-01-2015, 12:15 PM
Replies: 1,678
Views: 461,839
Posted By capnpaul

This is one of the better videos by a guy who...

This is one of the better videos by a guy who knows what he is talking about. The owner of CH Ignitions.

https://www.youtube.com/watch?v=DTwyptJpJL0
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.