RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: Viper1GJ
Showing results 1 to 25 of 58
Search took 0.03 seconds.
Forum: RC Jets
11-25-2019, 06:08 PM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

Spencer, Congrats in Best Turbine at the rally. ...

Spencer, Congrats in Best Turbine at the rally. We attended the Arizona Jet Rally a few times in the early 2000s when we lived in Denver. Always enjoyed it there.
I’ve thought of the SB throttle...
Forum: RC Jets
11-22-2019, 06:02 PM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

Spencer, Nice photos! What is your jets empty...

Spencer,
Nice photos!
What is your jets empty weight with the K-320? I just put one in mine after my B300F failed.

I also use full time roll mix to differential stabs. It hurts nothing that I...
Forum: RC Jets
11-18-2019, 05:03 PM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

I never had that specific problem with either of...

I never had that specific problem with either of my 1/5 F-16 but I did have some slow doors on both. I flew both with the B300F with no by pass. The fix in both cases was to inject BVM lube oil...
Forum: RC Jets
10-27-2019, 04:16 PM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

Hi Spencer, I chose not to do it because the...

Hi Spencer,
I chose not to do it because the guidance in the B300F manual recommended a pipe of 130mm inlet and 110mm exhaust. I used the stock SM 300N pipe in mine and had no issues. I could not...
Forum: RC Jets
10-09-2019, 10:11 AM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

I don't have the SM jet anymore so I can't...

I don't have the SM jet anymore so I can't measure anything. I do remember I reduced the flap travel to about 1/2" on TO and Landing to help reduce the pitch sensitivity I was experienceing. I think...
Forum: RC Jets
09-15-2019, 05:48 PM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

Spencer, I just left the small gap between the...

Spencer, I just left the small gap between the front and rear canopy. I flew it like that for 2 years before I sold it.
Forum: RC Jets
09-13-2019, 07:05 AM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

Spencer, Go here, post # 224 ...

Spencer,

Go here, post # 224
http://www.rcuniverse.com/forum/rc-jets-120/11613452-skymaster-1-5-scale-f16-build-thread-9.html

I did trim off some of the border at the rear bulkhead to help get...
Forum: RC Jets
08-30-2019, 03:52 PM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

I will have to go measure it. Will report back...

I will have to go measure it. Will report back tomorrow.
Gary
Forum: RC Jets
08-29-2019, 04:35 PM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

I've got two of Joey's pipes running now, one in...

I've got two of Joey's pipes running now, one in 1/5 BVM F-16 with B300F and one in my Havoc with a K-320G. I have never seen either one expand.
Gary
Forum: RC Jets
12-22-2018, 03:50 PM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

Craig, My smoke tubes are the stock tubes...

Craig,

My smoke tubes are the stock tubes from Dreamworks. Right now the turbine and tubes are installed in my 1/5 BVM F-16 and the smoke nozzles are stuck too far inside the pipe to get the...
Forum: RC Jets
12-21-2018, 04:20 PM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

love, here is my setup on B300F. I run the SM...

love, here is my setup on B300F. I run the SM 300N pipe and the PB jet pump with two outlets also. I have similar results at higher power but not quite as thin. I'm using Robart smoke oil. Hope...
Forum: RC Jets
08-29-2018, 03:48 PM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

Joey Tamez built a 300 pipe for my BVM F-16 and...

Joey Tamez built a 300 pipe for my BVM F-16 and its working great. See my posts in Jetlegend/BVM 1:5 F16 PNP post #245

Just give him the measurements and he can do it fairly quickly. Contact...
Forum: RC Jets
08-23-2018, 04:04 PM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

I ran the SM 300 pipe in mine with no issues till...

I ran the SM 300 pipe in mine with no issues till I sold it. I would probably replace the pipe. Good luck.
Gary
Forum: RC Jets
06-03-2018, 09:33 AM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

Levi, Awesome looking jet. The bottom looks...

Levi,
Awesome looking jet. The bottom looks just like I remember. Dirty, greasy, and oil streaked.

Here is a chart from F-16.net showing the LEF schedule on the jets I flew prior to 1995. The...
Forum: RC Jets
02-04-2018, 05:18 AM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

Levi, Congrats! Awesome, can't be better...

Levi,

Congrats! Awesome, can't be better than that. Glad to see you complete the #2 bird. Very nice landing.
Awesome flying site and weather for a maiden flight. What is you CG now?
...
Forum: RC Jets
12-18-2017, 04:37 PM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

Levi, Good Flying on this one. Let us know...

Levi,

Good Flying on this one. Let us know how it goes.

Gary
Forum: RC Jets
12-15-2017, 03:47 PM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

Hi Levi, I recently sold my SM F-16 to a...

Hi Levi,

I recently sold my SM F-16 to a friend in Florida. My last CG settings were 285-290. I preferred a more aft CG to help keep the AOA higher on final to keep the speed slower. I used low...
Forum: RC Jets
10-30-2017, 05:04 AM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

I never had an issue. I do not fly real fast. ...

I never had an issue. I do not fly real fast. Mostly below 150mph. I think the max I ever saw was momentary 180mph.
Gary
Forum: RC Jets
10-29-2017, 02:51 PM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

Great work Ziv, I like your neat layout. Keep...

Great work Ziv, I like your neat layout. Keep posting photos, lots of great ideas.
Thanks,
Gary
Forum: RC Jets
10-29-2017, 02:49 PM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

I used a B300F with no bypass. It worked fine. ...

I used a B300F with no bypass. It worked fine. I think it would be hard to stuff in a big block bypass anyway, plus you would have to custom make it. I really dont think you need it and my even...
Forum: RC Jets
07-11-2017, 01:05 PM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

lavi, If you mean the center pod under the...

lavi,
If you mean the center pod under the fuselage it is a 300 gal fuel tank.
Gary
Forum: RC Jets
05-21-2017, 01:25 PM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

Looks great. Keep posting the photos. Thanks, ...

Looks great. Keep posting the photos. Thanks,
Gary
Forum: RC Jets
05-20-2017, 04:15 PM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

Ziv, I like your tank mounting system. ...

Ziv,

I like your tank mounting system. Nicely done. Where did you put your ECU fuel pump and and smoke pump?

Gary
Forum: RC Jets
05-11-2017, 04:41 PM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

Bruno, I dont know how that would work. You...

Bruno,

I dont know how that would work. You better get someone smarter that me about thrust tube pipes to answer that one. I just know my SM 300N pipe works well with my B300F in the F-16.
...
Forum: RC Jets
05-11-2017, 09:12 AM
Replies: 1,008
Views: 222,262
Posted By Viper1GJ

Burno, You may be able to use the 200N size...

Burno,

You may be able to use the 200N size pipe OK but internal pressure, temps, and exhaust velocity will be higher. I am using the SM 300N pipe. I wanted more low speed static thrust and was...
Showing results 1 to 25 of 58
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.