Search: Posts Made By: shamferj
Showing results 1 to 6 of 6
Search took 0.01 seconds.
Forum: Tactic & AnyLink Support Forum 03-24-2014, 06:58 PM
Replies: 1
Views: 809
Posted By shamferj
tactic 2 module and multiplex

Will the new tactic module work with the multiplex evo9 radios? Not sure if the hitec adapter plug would work. Are the pinouts the same on hitec and multiplex?
Forum: Airtronics Support Forum 03-23-2014, 11:52 PM
Replies: 1
Views: 422
Posted By shamferj
The sd-10g has a dedicated gyro function for...

The sd-10g has a dedicated gyro function for adjusting and setting different gains. It doesn't have a dedicated stick override function like the jr 10x or 12x, but could be done using a programmable...
Forum: Airtronics Support Forum 04-22-2013, 06:27 AM
Replies: 1
Views: 457
Posted By shamferj
RE: TWin throttles

to make the twin throttles work you need to make the throttle channel master and channel 7 as the slave. make the mixing value 100% and then make sure to keep the c-mix swith on the transmitter on at...
Replies: 33
Views: 2,279
Posted By shamferj
RE: Need a Transmitter and $500 in pocket....

You won't go wrong with any of the radios mentioned. Some are a better value than others, but all will most likely function just fine. I own radios from each one of these manufacturers and there are...
Forum: Airtronics Support Forum 04-13-2013, 01:27 PM
Replies: 10
Views: 1,144
Posted By shamferj
RE: SD 10G or what?

The 10G is very easy to program and is as logical as the 9c. I have a 9c and a jr 11x as well. the jr radios are a little more cumbersome. I have two sd-10g's cause i love them so much! You really...
Forum: Airtronics Support Forum 08-28-2012, 03:33 PM
Replies: 8
Views: 1,129
Posted By shamferj
RE: RDS 8000 question

Use a programmable mixer aux7 as master and elevator as slave. Flip aux7 switch in position you want mixer to turn on then enter in the p-mix your offset amount. I would start at 10% or less up...
Showing results 1 to 6 of 6



Forum Jump


All times are GMT -8. The time now is 07:59 AM.