Search: Posts Made By: DrFrier
Showing results 1 to 21 of 21
Search took 0.65 seconds.
03-23-2006, 04:45 PM
Replies: 6
Views: 672
Posted By DrFrier

RE: 7CAP 2 Elevator Servos

Thanks Bill. I appreciate your help. I have ordered the Dual Servo Reverser that you manufacture.

Jim
03-22-2006, 06:58 PM
Replies: 870
Views: 155,378
Posted By DrFrier

RE: Tower Promo codes - please-please add as you get them

Today I ordered $131 worth of stuff from Tower, and used the code 011XM and got $20 off.

Jim

_____________________________

Failure is the opportunity to begin again more intelligently.
03-22-2006, 05:38 PM
Replies: 5
Views: 690
Posted By DrFrier

APC Props

What is the difference between an APC Pattern, and APC Sport prop, and the "W" APC prop?

Thanks,

Jim

____________________________________

Failure is the opportunity to begin again...
03-22-2006, 03:46 PM
Replies: 7
Views: 644
Posted By DrFrier

RE: Futaba 7CAP Support

Thanks Steve,

I'll have to order that Futaba SR-10 Dual Servo reverser from Tower Hobbies. I appreciate your input.
03-22-2006, 12:53 PM
Replies: 7
Views: 644
Posted By DrFrier

RE: Futaba 7CAP Support

Thanks for your help. I went to that site and posted the same question. However, I noticed there were other unanswered questions there. How often does Futaba check that site and follow up on...
03-22-2006, 12:49 PM
Replies: 6
Views: 672
Posted By DrFrier

7CAP 2 Elevator Servos

I'm nearly finished asseblying my GSP Cap232. I used 2 elevator servos. After an hour of fooling around with my radio (Futaba's 7CAP), and radio instruction manual, I was finally able to mix the two...
03-22-2006, 12:13 PM
Replies: 7
Views: 644
Posted By DrFrier

Futaba 7CAP Support

I'm nearly finished asseblying my GSP Cap232. I used 2 elevator servos. After an hour of fooling around with my radio (Futaba's 7CAP), and radio instruction manual, I was finally able to mix the...
Forum: Beginners
03-18-2006, 10:26 AM
Replies: 5
Views: 481
Posted By DrFrier

RE: Prop Balancing

A.G.
Are you sure you add it to the HEAVY end?

Jim
Forum: Beginners
03-18-2006, 08:33 AM
Replies: 5
Views: 481
Posted By DrFrier

Prop Balancing

I've been asking my club members the proper way to balance a prop. Some say, "sand the heavy end," others claim that will mess up the aerodynamics of the blade and you should sand the blade near the...
01-17-2006, 06:57 PM
Replies: 48
Views: 6,790
Posted By DrFrier

RE: Nice heli crash vid...[;)]

I keep getting an error message, page not found.
01-17-2006, 06:13 PM
Replies: 27
Views: 5,613
Posted By DrFrier

RE: 2 videos!! check it!

Forbidden, forbidden.
01-13-2006, 02:11 PM
Replies: 2
Views: 364
Posted By DrFrier

RE: New Aeorbatic Foam Airplanes

Thanks for your help, got it.

Jim
01-13-2006, 12:49 PM
Replies: 2
Views: 364
Posted By DrFrier

New Aeorbatic Foam Airplanes

Someone told me to go to Insanefoamies.com to look at the new 3-D foam airplanes. But I can't find this website anywhere. So I figure I am misspelling it, or not looking in the right places. Any...
Forum: Beginners
01-10-2006, 12:33 PM
Replies: 25
Views: 1,243
Posted By DrFrier

RE: Servo installation info requested

Ken,

2 questions;

1. Do you predrill the wood (a smaller pilot hole) into which you are placing the screw?
2. How the heck to you tell when you have applied just enough torque to place...
Forum: Beginners
01-10-2006, 12:24 PM
Replies: 50
Views: 2,630
Posted By DrFrier

RE: Sealing Engine Bay Area ?

Chuck,

Thanks so much for this valuable information. Thanks for taking the time to find this article and post it.

My conclusions, after reading the article, would be to gently warm the...
Forum: Beginners
01-10-2006, 11:55 AM
Replies: 6
Views: 528
Posted By DrFrier

RE: Need help for GP CAP 232 Build

Erik,

When I have problems like this, I take the plans and the parts to my club, either at the flying field on the weekends, or at our monthly meeting, and there are lots of guys there that help...
Forum: ARF or RTF
01-10-2006, 11:47 AM
Replies: 3
Views: 460
Posted By DrFrier

RE: Cap 232 Questions

lloyd,

This is the 1660 mm wing span, which works out to be about 65 inches. The assembly booklet calls for a 1.20 4-stroke.

Thanks Jim
Forum: ARF or RTF
01-09-2006, 02:17 PM
Replies: 16
Views: 1,117
Posted By DrFrier

RE: What Plane do I want?

The VERY BEST "BIG" trainer there is is the Senior Telemaster, Hobby-Lobby. It's a huge airplane, kit or ARF, flies beautifully. You can use a .46 or a .61 2-stroke. It's a blast with a .90...
Forum: ARF or RTF
01-09-2006, 01:04 PM
Replies: 3
Views: 460
Posted By DrFrier

Cap 232 Questions

I got a GiantScalePlanes.com Cap 232 for Christmas. There doesn't appear to ba a lot of information on this ARF either here (RCU) or any other web site, including GiantScalePlanes.com. If you are...
Forum: The Clubhouse
10-05-2005, 12:33 PM
Replies: 85
Views: 5,776
Posted By DrFrier

RE: What's your club's web page?

WWW.RCFLYERSUNLIMITED.COM

We have about 140 members with a terrific flying site.
10-05-2005, 12:25 PM
Replies: 2
Views: 506
Posted By DrFrier

Goldberg Sukhoi ARF 1.20

I am currently flying the Phoenix .40 size Sukhoi and want a larger airplane. I read the 2 product reviews concerning the Goldberg 1.20 size Sukhoi, but I was wondering if anyone else is flying the...
Showing results 1 to 21 of 21


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service