Register

If this is your first visit, please click the Sign Up now button to begin the process of creating your account so you can begin posting on our forums! The Sign Up process will only take up about a minute of two of your time.

Search:

Type: Posts; User: racemaxx24

Page 1 of 40 1 2 3 4

Search: Search took 0.92 seconds.

  1. Poll: RE: Opinion Or Experiance Over At The Traxxas Forums

    I was pertaining to "TherealDadx2mj" and other similar usernames. Thanks for pointing out the obvious, though.
  2. Poll: RE: Opinion Or Experiance Over At The Traxxas Forums

    I find it funny that anyone viewing this thread thinks the above posters have any affiliation with Traxxas. For one, a true member of the administration staff would avoid conflict in public forums of...
  3. RE: Tmaxx - upgrading the sensor & radio?

    The radio will have no noticeable change over your previous one. It will just eliminate the worry of having the same crystals as someone else running at the same time.
  4. Replies
    4,427
    Views
    453,396

    RE: OFFICIAL MINI E-REVO THREAD!!!

    Use the RC18 diff shim set. That's what i've read to use and installed in mine today. Hopefully that will help hold it together.

    You should always tighten the screws tight. The skid plate plus...
  5. Replies
    4,427
    Views
    453,396

    RE: OFFICIAL MINI E-REVO THREAD!!!

    Well, RIP rear differential ring gear. A fresh 2S is all it took to finish it off. Time to shim them this time so it don't happen again...
  6. Replies
    3
    Views
    367

    RE: fuel priming

    Just put your finger over the exhaust outlet and pull the starter a few times without the glow ignitor on. It'll push some fuel in the lines and into the carb, enough to get it started.

    A couple...
  7. Replies
    4,427
    Views
    453,396

    RE: OFFICIAL MINI E-REVO THREAD!!!

    Kinda curious as to what everyone thinks of THESE.

    For $23, kinda hard to go wrong trying them. They look promising. Anyone got experience with them?
  8. RE: did I make a bad purchase or am I just unlucky or am I just a bad driver???

    Same here. I've been really tempted to try Redcat products but as soon as I begin really searching in, I see stories like this. I can run the hell out of my Traxxas products with no issue even though...
  9. Replies
    33
    Views
    1,335

    RE: T-maxx upgrades?

    Best way to handle that is to grab a few things you look like you need and bring them up to the counter like you're ready to pay. Ask them a question about your T-Maxx and if they give you any lip at...
  10. Replies
    14
    Views
    943

    RE: Best city for Hobby Shops???

    St. Louis has a very nice shop pertaining to mostly cars with an assortment of planes and other RC's called Mark Twain Hobbies. They were very helpful the last time I was in there (end of 09) and...
  11. Replies
    6
    Views
    657

    RE: I got scamed

    Just a little suggestion here. I try to never trade/deal with anyone that has the same email address as their username UNLESS they have good verifiable feedback on other sites. Typically the only...
  12. Replies
    33
    Views
    1,335

    RE: T-maxx upgrades?

    Yep, the pegs are basically the pad that most trucks use in their slipper assembly. They make for a pain sometimes in reassembly. [:@]
  13. Replies
    5
    Views
    335

    RE: clutch problems

    Also, a vented clutchbell will help alot with the composite clutches that are on these trucks. The built up heat they will get from lots of hard accelerating will kill them quick.
  14. Replies
    8
    Views
    510

    RE: Truggy or truck?

    Pretty much, yessir! Truggy's are essentially built for racing and although can be good bashers, aren't built for it. A Revo will definitely be more in the direct you want.
  15. Replies
    8
    Views
    510

    RE: Truggy or truck?

    $150 for even a 2.5r Revo is a steal. I would take that in a heart beat.

    To fit the .28, you would need to install a big block mounting kit and probably some other mods to make it fit. Although...
  16. Replies
    60
    Views
    3,227

    RE: RCU Site Problems??

    I can't seem to change my profile picture at all. Every time I try to upload I get an error. Different sizes of pictures, file types, etc. None of them work.
  17. Replies
    26
    Views
    1,208

    RE: Fuel/nitro?

    I use O'Donnell 20% in all of my models and I see no difference in performance going by color. Traxxas add's extra oil to their fuels for their motors but you'll be fine with O'Donnell. O'Donnell...
  18. Replies
    3
    Views
    284

    RE: Engine tempature?

    I use THIS for temp. checking. Small so you can keep it on your pocket and reliable. If you don't want to get on of those, there's an old trick where you can put a little spit on the head. If it...
  19. Replies
    21
    Views
    3,940

    RE: 1/16 Summit Brushed Version Review

    Traxxas brushed ESC's have been rather lack luster, I do agree. But their brushless ones seem to be of good quality. I have 2 VXL-3m systems and they both have been trouble free. I think the XL 2.5's...
  20. Replies
    18
    Views
    1,132

    RE: revo 3.3 fluid leak

    Sounds to me like you're just getting some oil seepage from the motor around the start shaft and it's leaking out the EZ-Start case. Not really anything to be worried about. Do you tend to run it...
  21. Replies
    10
    Views
    602

    RE: Pro .15 resurrection - Need advice

    You would probably get away with running the drive shafts you have with no issues. I put a 3.3 on my 1st gen T-Maxx a little while back and while they did twist somewhat, they never actually broke....
  22. Replies
    1
    Views
    231

    MERV Radio Help

    I've got a DX 2.0 system I am trying to bind with my ESC but I am having no luck. I'm following Traxxas' instructions on how to bind your transmitter/ESC but before it would only go through the...
  23. Replies
    9
    Views
    449

    RE: Computer Help

    This sounds like more of a hardware issue than software, almost like a sector might have gone bad and it can't load some of the important files.

    Any idea who the hard drive manufacturer is...
  24. Replies
    7
    Views
    450

    RE: Front wheels not spinning

    I'm not really familiar with Redcat products but it sounds to me like a front different issue or possibly a jammed CVD/dogbone (like I said, i'm not really familiar with Redcat's stuff so...). Are...
  25. Question on a few upgrades... (Mini-T)

    So, i've been out of the RC scene for quite awhile but i'm looking to get back going but in a smaller scale. I've had my eye on a Mini-T up at HobbyTown and I think i'm gonna go pick it up this week....
Results 1 to 25 of 990
Page 1 of 40 1 2 3 4
All times are GMT -6. The time now is 01:45 AM.

SEO by vBSEO 3.6.1 ©2011, Crawlability, Inc.