Register

If this is your first visit, please click the Sign Up now button to begin the process of creating your account so you can begin posting on our forums! The Sign Up process will only take up about a minute of two of your time.

Search:

Type: Posts; User: geeter

Page 1 of 27 1 2 3 4

Search: Search took 0.78 seconds.

  1. Replies
    159
    Views
    9,973

    It is kind of a pain to clean them , but when I...

    It is kind of a pain to clean them , but when I think of the fun I had and the performance they have , it's worth it. It only takes a few minutes of your time. With some spray nine or 409. Nitro fuel...
  2. Replies
    159
    Views
    9,973

    To be honest. Letrics don't turn me on. Now my...

    To be honest. Letrics don't turn me on. Now my kaos running a .50 gt webra with a performance specialties muffler turning 14,500 going 110 mph does. also my viper 500 running a TH with a macs tuned...
  3. Replies
    660
    Views
    73,292

    I was given a gms.47. One of the worst engines I...

    I was given a gms.47. One of the worst engines I have ever had. I tried two different carbs , every glow plug there is including idel bar plugs. Still wouldn't run and have been around nitro motors...
  4. Replies
    4
    Views
    384

    You'll usually gain some rpm by taking the baffel...

    You'll usually gain some rpm by taking the baffel out. A little noise but not a biggie. I do it all the time.
  5. Thread: Tatic 624 rx

    by geeter
    Replies
    3
    Views
    322

    ...i resoldered it back on very carefully. tested...

    ...i resoldered it back on very carefully. tested the range, it was fine. put it in a nitro .40 and is flying fine....RON
  6. Replies
    2
    Views
    569

    I would by a .46 they run good. Ain't much...

    I would by a .46 they run good. Ain't much difference in power.
  7. Replies
    33
    Views
    7,700

    Your talking of welding the muffler together. You...

    Your talking of welding the muffler together. You have to be a very good tig welder to do this. If it has been run the oil will impregnate the aluminum making it almost impossible to do.
  8. Replies
    33
    Views
    7,700

    The muffler on any two stroke can be held on...

    The muffler on any two stroke can be held on tight. Take it apart. Clean it good with solvent. Put 15 min epoxy between the halves. Bolt together. Clean the exhaust inlet on the muffler and outlet...
  9. I ain't going no where after thirty years of...

    I ain't going no where after thirty years of flying. This is a nice hobby. I will do what is required. If you don't then they have won. I'll be damn if I'll let them do that. Besides the law can...
  10. Replies
    121
    Views
    7,572

    you can also use armorall . like used on cars .

    you can also use armorall . like used on cars .
  11. Thread: Tatic 624 rx

    by geeter
    Replies
    3
    Views
    322

    Yes I did . For 20.00 it ain't worth taking a...

    Yes I did . For 20.00 it ain't worth taking a chance.
  12. Thread: Tatic 624 rx

    by geeter
    Replies
    3
    Views
    322

    Tatic 624 rx

    Just a note to say be careful with the 1 in. Antenna wire on your 624 rx don't twist it or bend it . Just leave it alone . I had one fall out in flight . It was only held on by a couple of threads of...
  13. Replies
    4
    Views
    534

    that is what you do to tune the pipe to the...

    that is what you do to tune the pipe to the engine. just what macs says to do. don't cut it to short about 1/4 in at a time.also the prop can affect rpm so go with a smaller prop. don't load it down...
  14. Replies
    6
    Views
    1,174

    The sport jet is for general fast flying the jet...

    The sport jet is for general fast flying the jet f.i.r.e is for racing only.
  15. Replies
    60
    Views
    2,481

    Check the compression. Bring it to compression...

    Check the compression. Bring it to compression TDC and see if it holders for at least three seconds. Overheating is a sign of a worn out piston & sleeve. If it is good , look for something else.
  16. Replies
    15
    Views
    710

    check compression ,it should hold for three...

    check compression ,it should hold for three seconds min. does the engine idel well ? does it run hot when trying to lean it out. these are signs of a worn out engine.go to hobby people and order the...
  17. Replies
    15
    Views
    1,789

    Now I use good old pennsoil outdoor 2cycle at...

    Now I use good old pennsoil outdoor 2cycle at 32-1 . No need for expensive oils is my view.
  18. Replies
    6
    Views
    372

    That's my mix . I don't know what concrete...

    That's my mix . I don't know what concrete release oil costs.
  19. Replies
    6
    Views
    372

    I would say about 5.00 to 6.00 per gallon.

    I would say about 5.00 to 6.00 per gallon.
  20. Replies
    6
    Views
    372

    Smoke oil

    Yes it will work, but getting it is the problem . They usually won't sell it to ya. This stuff anybody can buy. I t doesn't leave a mess on the plane either. There are a lot of formulas I guess. But...
  21. Replies
    6
    Views
    372

    gas engines smoke oil

    hey guys i have come up with a homemade smoke oil that smokes like crazy. don't spend 28.00 to 30.00 a gallon for super dri or robart.. make this.... home heating oil and mineral oil. the kind you...
  22. Replies
    13
    Views
    964

    I have been using nimh battries in my models for...

    I have been using nimh battries in my models for years. Yes store bought nimh from ray o vac. Dura cell etc , in tx and rx packs 4.8 volt to 6 volt. No problems either except a bad cell now and...
  23. Replies
    2
    Views
    369

    I love my 650. Have four planes on it and 4 624...

    I love my 650. Have four planes on it and 4 624 rx's works perfect. Good radio for sure...RON
  24. Replies
    34
    Views
    1,925

    I vote for v v r/c.

    I vote for v v r/c.
  25. Thread: Tactic TR624

    by geeter
    Replies
    1
    Views
    377

    I bought tatic. Great radio. For the price there...

    I bought tatic. Great radio. For the price there isn't a radio that comes close to tatic. I fly four planes with 624 rx's one is a 20 cc gas. I should have the 625 rx in that but I will change for...
Results 1 to 25 of 661
Page 1 of 27 1 2 3 4
RCU Reviews
All times are GMT -6. The time now is 04:25 PM.

SEO by vBSEO 3.6.1 ©2011, Crawlability, Inc.