Register

If this is your first visit, please click the Sign Up now button to begin the process of creating your account so you can begin posting on our forums! The Sign Up process will only take up about a minute of two of your time.

Search:

Type: Posts; User: Redcat James

Page 1 of 4 1 2 3 4

Search: Search took 0.07 seconds.

  1. Replies
    2
    Views
    115

    You can find all you engine hop ups here...

    You can find all you engine hop ups here http://www.davesmotors.com/
    I would recommend the pipe, clutch springs and maybe the coil.
  2. Replies
    4
    Views
    146

    02051t is for the aluminum suspension mounts.

    02051t is for the aluminum suspension mounts.
  3. It sounds like your vehicle was cogging and when...

    It sounds like your vehicle was cogging and when you continued to try and drive it it made the esc and motor very hot until it blew up. Normally the cause for that is a bad esc but now your motor may...
  4. Replies
    4
    Views
    146

    06045 is the direct replacement.

    06045 is the direct replacement.
  5. Replies
    1
    Views
    205

    I would give Redcat a call at (602)454-6445 when...

    I would give Redcat a call at (602)454-6445 when you have the vehicle in front of you and they should be able to assist you over the phone, should be covered under warranty.
  6. 2.4 is the radio

    2.4 is the radio
  7. That should work just fine.

    That should work just fine.
  8. The new Earthquakes come with a black cooling...

    The new Earthquakes come with a black cooling head and short antenna since they are 2.4. If your engine won't turn over from what I've seen the pinch on the new engines is extra tight. You can use a...
  9. Replies
    7
    Views
    252

    If the gear mesh is properly adjusted and no...

    If the gear mesh is properly adjusted and no rocks go through the gears it should last a lot longer. You can loosen the slipper to prevent the gears from absorbing all the shock in the drivetrain,...
  10. Replies
    3
    Views
    247

    Did you use shoulder screws, do you have a...

    Did you use shoulder screws, do you have a picture of them? Yes they come from the factory threaded into plastic :(
  11. As long as you keep it under 250 degrees you...

    As long as you keep it under 250 degrees you should be fine.
  12. Replies
    1
    Views
    114

    Here you go...

    Here you go http://www.redcatracing.com/s.nl/it.A/id.2236/.f
  13. 24620 is for 2.4 and is the latest...

    24620 is for 2.4 and is the latest version...............
  14. Replies
    2
    Views
    145

    So you're saying the motor won't slide out far...

    So you're saying the motor won't slide out far enough to install the larger gear?
  15. I would reset the needle settings to the stock...

    I would reset the needle settings to the stock settings. Turn both the high and low speed needles clockwise until they bottom out. Back the high speed needle out 3-1/2 turns and the low speed 2-1/4...
  16. I would recheck the needle settings, the idle...

    I would recheck the needle settings, the idle setting and the clutch. I would also check the glow plug.
  17. Replies
    2
    Views
    144

    Where is the ST/DR knob set to?

    Where is the ST/DR knob set to?
  18. http://www.redcatracing.com/02092

    http://www.redcatracing.com/02092
  19. Replies
    9
    Views
    620

    Actually we say that because the esc, motor and...

    Actually we say that because the esc, motor and gearing are designed for 2s lipo.
  20. Replies
    6
    Views
    187

    http://www.redcatracing.com/108839

    http://www.redcatracing.com/108839
  21. Replies
    9
    Views
    620

    The Tornado EPX Pro is only rated out of the box...

    The Tornado EPX Pro is only rated out of the box for a 2s lipo battery, adding a 3rd cell will void the warranty.
  22. Did you try the dual rate knob? It should be set...

    Did you try the dual rate knob? It should be set to 6. There is no end point adjustment on a Tornado controller.
  23. This is a different esc but the manual and set up...

    This is a different esc but the manual and set up are the same. Click the manual link under description http://www.redcatracing.com/03351
  24. Replies
    3
    Views
    156

    Maybe the engine is overheating. Try richening it...

    Maybe the engine is overheating. Try richening it up.
  25. Replies
    11
    Views
    159

    If the car is on the ground and you slowly pull...

    If the car is on the ground and you slowly pull the pull starter up, will the car stay on the ground or come up with the pull start?
Results 1 to 25 of 77
Page 1 of 4 1 2 3 4
All times are GMT -6. The time now is 02:49 AM.

SEO by vBSEO 3.6.1 ©2011, Crawlability, Inc.