Search: Posts Made By: Jerkey
Showing results 1 to 25 of 218
Search took 0.96 seconds.
05-13-2014, 04:08 PM
Replies: 0
Views: 384
Posted By Jerkey

Check out this link!!!

My friend owns a hobby shop in Illinois. He has acquired many planes that are top notch turn key flyers. Most are listed on his website. Here is the link. http://www.dbalsa.com
Replies: 3
Views: 411
Posted By Jerkey

RE: 12FG HELP!!!

Tried that didn't work. Anyway the radio is on it's way to Champaign IL for repair and check up. I bought it used so a check up is in order. Anyway I tried formatting the card in every format Windows...
Replies: 3
Views: 411
Posted By Jerkey

12FG HELP!!!

I had a update go bad on my Futaba 12FG. I'm looking for someone near Streator IL that has a 12FG so I can get my SD Card formatted.

Thanks,
Mike
10-10-2010, 02:21 PM
Replies: 2
Views: 907
Posted By Jerkey

RE: Aerofly Pro Deluxe Graphics Issue

It seems the latest graphics driver has corrected my problem.

Thank You,

Mike
10-10-2010, 12:09 PM
Replies: 2
Views: 907
Posted By Jerkey

Aerofly Pro Deluxe Graphics Issue

I am have a problem with my plane graphics being messed up in AFPD. Seems to be only the plane graphics that are the problem. Performance wise it seems to be fine. I am running Windows 7 64bit. My TM...
10-09-2010, 11:49 PM
Replies: 18
Views: 1,823
Posted By Jerkey

RE: AFPD Airplane Graphics issues

I also am have the same problem with my plane graphics being messed up. I am also running Windows 7 64bit. My TM log is also completely empty.

Windows 7
ATI 5870
I7 Processor

Thanks,...
Replies: 4
Views: 1,564
Posted By Jerkey

Futaba 12FG Battery

I bought the R/C Accessories 2600 mah Lipo for my 12FG. Great battery but it is way smaller in size than the OEM 1700mah NIMH that came with the radio. And also the OEM is a special fit in the radio...
Forum: Gas Engines
08-08-2010, 04:56 PM
Replies: 1
Views: 615
Posted By Jerkey

DA-50R Carb Plate

Can somebody tell me the right placement of the carb plate hole on the DA-50R. Should it be positioned closest to the engine (front) or away from engine (rear).

Thanks,

Mike
08-01-2010, 10:07 PM
Replies: 8
Views: 3,519
Posted By Jerkey

Aeroworks Extra 300 50cc QB CG

First off my setup is a DA50/Jtec pitts muffler/Vess 23X8 prop/and tru-turn lightened back plate spinner. To get my CG at 4 inches it is taking both A123 2cell 2300 packs put back by the rudder servo...
07-30-2010, 10:12 PM
Replies: 0
Views: 572
Posted By Jerkey

Power Source for Bantam e-Station BC8DX

OK I bought a Bantam e-Station BC8DX Lipo Charger to charge my (2) A123 2300mah batteries at the same time. I'm looking into power sources for this setup. I have been looking at the Honda generator...
Replies: 10
Views: 1,704
Posted By Jerkey

Futaba R6008HS 2.4GHz Receiver

I recently purchased a Futaba 2.4GHz System (TM-8 & R6008HS). The TM-8 Module is going in my 9CAP transmitter. I have JR 8411 digital servos throughout my aircraft except for my throttle servo which...
08-03-2008, 01:26 AM
Replies: 12
Views: 2,606
Posted By Jerkey

RE: Hard Drive Camcorder

Hmm let's look real hard at Mrbiggs post. He asked and I quote "Any other brands you'd recommend?" I therefore posted two brands along with specific model numbers for Mrbigg to look at. And if you...
Forum: Gas Engines
07-23-2008, 08:47 PM
Replies: 5
Views: 929
Posted By Jerkey

G62 Problem

My friend has a G62 in his Corsair. Engine runs great on the ground. He has only around 5 flights on it. So far every landing has been a dead stick. Engine consistently dies on his approach to land....
07-23-2008, 04:17 PM
Replies: 12
Views: 2,606
Posted By Jerkey

RE: Hard Drive Camcorder

Canon HG10 AVCHD 40GB High Definition Camcorder with 10x Optical Zoom
07-23-2008, 04:15 PM
Replies: 12
Views: 2,606
Posted By Jerkey

RE: Hard Drive Camcorder

Sony Handycam HDR-SR11 60GB Hard Drive Camcorder
03-09-2008, 07:10 PM
Replies: 327
Views: 35,024
Posted By Jerkey

RE: Carden Profile

Beef ditch the 3000. Your 46 Brielli would be more suited for that planes wieght. Usually at 16lbs a 50cc gasser is the choice engine. With the 3000 ST you will prolly lose altitude at a full...
08-11-2007, 08:13 PM
Replies: 5
Views: 1,737
Posted By Jerkey

Extreme FLight Extra 300E

I have the Extreme Flight Extra 300E 45". Plane is awsome but after my flying session today I noticed the landing gear block was caved in. It bkoke at the rear and was pushed up into the fuse. My...
Replies: 35
Views: 2,144
Posted By Jerkey

Changing Crystal On TX

Tell me is it safe to change crystals on transmitters. Like go from one channel to another.

Thanks,

Mike
Forum: 3D Flying!
04-08-2007, 08:12 PM
Replies: 11
Views: 2,449
Posted By Jerkey

RE: BEST $40 to $60 3D SERVOS

Joel call me or check the front bumper of your Roadmaster.

Mike
Forum: 3D Flying!
04-04-2007, 06:05 PM
Replies: 3,678
Views: 348,178
Posted By Jerkey

RE: Funtana X100

Do you guys think a YS FZ120 would be a good motor for this plane?

Thanks,

Mike
12-28-2006, 06:24 PM
Replies: 6
Views: 7,693
Posted By Jerkey

AFPD Downloads

Can someone tell me the best place to get AFPD downloads?

Thanks,

Mike
Forum: 3D Flying!
11-22-2006, 07:24 PM
Replies: 5
Views: 1,252
Posted By Jerkey

RE: Outdooor foamy

Extra Stiffy by Copperhead Aviation
11-03-2006, 07:15 PM
Replies: 3
Views: 1,568
Posted By Jerkey

RE: Here's what I have...

ORIGINAL: lvspark

Got any pics of the equipment?
10-31-2006, 09:08 PM
Replies: 3
Views: 1,568
Posted By Jerkey

Here's what I have...

I purchased this stuff a few years ago from black widow I believe. My camera is model number ALM-2451G. The receiver says AV RECEIVER Model #ALM-2452 RX. Is any of this any good? If not what do you...
10-28-2006, 09:58 PM
Replies: 127
Views: 10,813
Posted By Jerkey

RE: check your JR 8611a's

His name is Bigg....Mr. Bigg
[sm=shades_smile.gif]
Showing results 1 to 25 of 218
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service