Register

If this is your first visit, please click the Sign Up now button to begin the process of creating your account so you can begin posting on our forums! The Sign Up process will only take up about a minute of two of your time.

Search:

Type: Posts; User: Checklst

Page 1 of 29 1 2 3 4

Search: Search took 1.54 seconds.

  1. Replies
    54
    Views
    1,167

    OMG....... I thought I was alone thinking like...

    OMG....... I thought I was alone thinking like that. Like Pamster says local 2 stroke air cooled oil made for any weed wacker,chain saw, blower.... ect....The engine MFG oil ratio is the only...
  2. Replies
    9
    Views
    379

    Hear are a few pics of my 4 star 60 with a VVRC...

    Hear are a few pics of my 4 star 60 with a VVRC 21cc conversion. The only mods were moving the blind nuts on the fire wall out a little as the gas motor was just a touch wider. I used the motor...
  3. Replies
    29
    Views
    709

    I would go with the 20 or 21cc ............I have...

    I would go with the 20 or 21cc ............I have the VVRC 21cc(valleyView) on my Sig 4star 60 and if flys great....power is just perfect....a 15 would fly it but a 20cc ups the fun factor.
  4. Replies
    8
    Views
    398

    Had the tip of the needle break off and remained...

    Had the tip of the needle break off and remained stucked in the needle seat. It was hard to find......not until both needles were out laying side by side did I notice part of the low needle was...
  5. Replies
    4
    Views
    325

    I stripped a single servo on the elevator when I...

    I stripped a single servo on the elevator when I bound to an existing plane set up on my radio......the elev went full down and drove way past the end point..........I guess it could happen on all...
  6. Thread: CA hinges

    by Checklst
    Replies
    5
    Views
    195

    I was out of the Radio South hinges......used...

    I was out of the Radio South hinges......used Great planes and the rudder came off................The plastic pulled clean out of the rudder leaving the fuzz inside the balsa....Never had a Radio...
  7. Replies
    10
    Views
    299

    Never had a problem using CC through...

    Never had a problem using CC through PayPal...........did they ever give you a reason for a cc card going into reverse, a paid/not paid reverse is strange indeed.
  8. Replies
    2
    Views
    196

    I sent mine back and hitec gave me a new...

    I sent mine back and hitec gave me a new one............still does the breakdown on the new unit.........A electronics expert at out field after me describing the break down,said I should look for a...
  9. Replies
    54
    Views
    1,854

    I mostly us nylon gear Hitec or what ever I have...

    I mostly us nylon gear Hitec or what ever I have around the shop from retired aircraft................I purchased a couple of throttle servos and was glad to see hitec make a new HV430 an upgrade on...
  10. Replies
    6
    Views
    1,049

    Nice job on the conversion.........DID you do the...

    Nice job on the conversion.........DID you do the antenna conversion????/it looks like a JR 2.4 antenna for the 8103.
  11. Would not try to be a jerk to you stickbuilder My...

    Would not try to be a jerk to you stickbuilder My response was just a comment due to my boredom at the mall one day. My strong opinion is not just on my observation of that day but is based on my...
  12. I think the AMA is scared of fraud............one...

    I think the AMA is scared of fraud............one only needs to look at the local mall handicap parking spaces to relies most are not disabled using the spots reserved for them. (really pisses me...
  13. Replies
    75
    Views
    2,079

    The only miss I ever had on a gas was due to the...

    The only miss I ever had on a gas was due to the timing being to advance(came from the factory set wrong) might put a timing wheel on her a give a check. Just a thought
  14. Replies
    4
    Views
    205

    +1 on the eneloop NIMH 2000mh............... give...

    +1 on the eneloop NIMH 2000mh............... give Hangtime a call should have a direct replacement for you.

    http://hangtimes.com/
  15. Replies
    9
    Views
    403

    The ignition that comes with the DLE55 is a vary...

    The ignition that comes with the DLE55 is a vary good ignition.....as for replacements, 2 of the best I know of are RC Extreme(RCXP ignition) and CH Ignition........both owners sell high quality...
  16. Thread: Vvrc 21

    by Checklst
    Replies
    13
    Views
    922

    Hey Guys ..........................finally got a...

    Hey Guys ..........................finally got a day to fire her up.....to windy to fly, 15 to 20 mph no fly day for me.. This little engine likes to run......fired right up to a couple tweaks of...
  17. Thread: Vvrc 21

    by Checklst
    Replies
    13
    Views
    922

    Thanks Av8tor the gaps are tight but sealing them...

    Thanks Av8tor the gaps are tight but sealing them sure can't hurt. All connectors are tight so I'll do the seal job tonight.........Looks like Friday is my next go day, weather wise.........I was...
  18. Thread: Vvrc 21

    by Checklst
    Replies
    13
    Views
    922

    Done with the conversion.............tomorrow is...

    Done with the conversion.............tomorrow is the big day on first start up on this little 21cc engine. The 4 star conversion was a little harder than it looked because the fuse is so small and...
  19. Hitec H4 might do it ...

    Hitec H4 might do it

    http://hitecrcd.com/products/chargers/dcdc-chargers/h4-dcdc-four-port-multi-charger/product
  20. Replies
    157
    Views
    8,094

    LOL........ Love British humor!!!!!! Opps off...

    LOL........ Love British humor!!!!!!

    Opps off topic sorry
  21. Replies
    157
    Views
    8,094

    Two thumbs up .......with a Beer:cool: Have one...

    Two thumbs up .......with a Beer:cool: Have one T-A IBEC and two Wike and have never had trouble in 3 years.........I like them.
  22. Replies
    35
    Views
    1,076

    I agree wildnloose for a KISS set up, a Deans...

    I agree wildnloose for a KISS set up, a Deans aiming plug set up is hard to beat for a simple receiver setup..........I still use dual deans batt/switch with Lifepo4 on my 50cc a whole lot of things...
  23. Replies
    11
    Views
    405

    Carb rebuild kit is not to costly....usually the...

    Carb rebuild kit is not to costly....usually the pump diaphragm...of course clean the screen as said by others. If problem is still their see if someone in your club has a spare ignition you could...
  24. Replies
    8
    Views
    310

    Sorry AT I missed your links or I would have...

    Sorry AT I missed your links or I would have directed him to your link...............I looked right past your link because I did not see the HTTP//WWW. My mind must be trained to the old looking...
  25. Replies
    6
    Views
    214

    Maybe this will help a little, its an automotive...

    Maybe this will help a little, its an automotive plastic panel plug.......sold at Autozone ect...........covers up the hole nicely
    ...
Results 1 to 25 of 709
Page 1 of 29 1 2 3 4
All times are GMT -6. The time now is 07:57 PM.

SEO by vBSEO 3.6.1 ©2011, Crawlability, Inc.