Register

If this is your first visit, please click the Sign Up now button to begin the process of creating your account so you can begin posting on our forums! The Sign Up process will only take up about a minute of two of your time.

Search:

Type: Posts; User: JoeAirPort

Page 1 of 40 1 2 3 4

Search: Search took 0.91 seconds.

  1. I used the SWB 1.5" for ailerons and elevators.

    I used the SWB 1.5" for ailerons and elevators.
  2. RE: DLE 30 Prop hub replacement and install

    Remove the prop shaft by attaching an old prop or hand made tool (using prop bolts) to hold the hub while loosening the prop shaft. Then use a gear puller to pull the hub off. Or use a prop drilling...
  3. Replies
    7
    Views
    830

    RE: Shipping verification for Paypal

    Thanks!
  4. Replies
    7
    Views
    830

    RE: Shipping verification for Paypal

    Thanks Jared. Good info. I just firgure it's worth an extra buck or less to get deliver conf on stuff under $100. Not worth the gamble. Stuff happens.
  5. Replies
    7
    Views
    830

    Shipping verification for Paypal

    You gurus who sell a lot of stuff and use PayPal.....for ups or FedEx it's a no brainer since they have tracking. But for USPS what is best to satisfy PayPal for shipping verification? Signature?...
  6. Replies
    10,975
    Views
    780,389

    RE: Extreme Flight 88

    You must be the guy that I'm messaging on Youtube. How's it going? I think I rotated the carb and block. I also flipped the throttle arm so it's 180 degrees from original position.
  7. Replies
    22
    Views
    1,191

    RE: servo installation advice

    If the whimpy little throttle spring pulls the throttle off its mount, it wasn't installed properly. I leave my springs as-is from mfg and I never have had this happen. It's not the root cause here....
  8. RE: How to Setup A123 Pack with Charge & Arming Switch Capabilities?

    If you go with CellPro chargers you need just one 3 pin charge jack (does power and balance in one connector). I use the Deans 3-pin charge jack. Mounts on the side of the fuse. Works great. I charge...
  9. Replies
    6
    Views
    710

    RE: Hitec Servo Opinions - Thanks

    I use the 7985 for throttle on my gas planes. Works great. I use the 7955 instead of the 7954. Much better gear train (titanium).
  10. Replies
    39
    Views
    3,363

    RE: Best 100 - 120cc engine for 3D

    You ain't kidden Jim. :)
  11. Replies
    38
    Views
    2,760

    RE: multiple throttle servo failures

    The carbon filled nyrod is the shiz. I use it.
  12. Replies
    39
    Views
    3,363

    RE: Best 100 - 120cc engine for 3D

    I have the DA-120 with stock muffs on an Extreme Flight 110" Yak 54 and I love it. I fly tons of 3D on it. Perfect engine IMO. I've had many engines and it is reliable and a power house. I trust it...
  13. Replies
    10,975
    Views
    780,389

    RE: Extreme Flight 88

    You can also open the pipe tunnel on the bottom of the fuse. That's what I do. Never had my Extra or Yak over heat. I like the looks of the louver on the front of the Yak.
  14. Replies
    12
    Views
    1,374

    RE: ETHANOL FREE GAS!!! WEBSITES.

    Taking away the money certainly helps but you made a good point.
  15. Replies
    12
    Views
    1,374

    RE: ETHANOL FREE GAS!!! WEBSITES.

    You can't assume that for all of their gas stations. I think there's rules for how a station can carry non-ethanol gas. Don't remember what they are.

    The Senate just voted against an Ethanol...
  16. Replies
    12
    Views
    1,374

    RE: ETHANOL FREE GAS!!! WEBSITES.

    We need to vote them all out of office....eventually. All of the ones that pushed for this. It's a crock of crap.

    Meanwhile we should buy our gas at these places if we can. Just make sure to...
  17. RE: 35% radio/servo/battery setup question

    I used 22 gauge on my 35% Yak. I used #16 wire for the A123 batteries going to Deans Ultra connectors to the switches.
  18. RE: Extreme Flight Extra 300, 50cc, 88.5inch Wingspan, Build !!!!!!!

    Yes I did. Got the DA-120 combo. All I can say is OMG what an amazing plane...especially with that grunty DA-120. Amazing power.

    I had to sell either my 88 Yak or 88 Extra. It wasn't an easy...
  19. Replies
    10,975
    Views
    780,389

    RE: Extreme Flight 88

    You can always get another Yak later (I would miss mine too). The Extra is awesome. You'll like it.
  20. RE: Extreme Flight Extra 300, 50cc, 88.5inch Wingspan, Build !!!!!!!

    Glad you got it back into action and enjoying it Nitro. I have flown the heck out of mine. Once you get in a groove with it, amazing things will happen. I sold mine to a club friend and so far the...
  21. Replies
    10,975
    Views
    780,389

    RE: Extreme Flight 88

    Sorry to hear about that. Not sure what happened but you shouldn't over tighten the bolts. Just snug them up with a little muscle and that's it. Can't crank on them like metal bolts. Also can't leave...
  22. RE: 35% radio/servo/battery setup question

    A 9C only has 8 proportional channels. So you'll need some help for all those servo connections (9), not including an ignition kill. Plus (2) battery connections. Also to gang the two rudder servos...
  23. Replies
    8
    Views
    502

    RE: June 6, 1944

    Garatitude to all those men for this great country.
  24. Replies
    10,975
    Views
    780,389

    RE: Extreme Flight 88

    It's fine as long as you don't pan cake the plane or have a rough landing. I have CF in my 110" yak. It came with the kit. One thing I like about CF is that the legs don't spread out like the alum.
  25. Replies
    10,975
    Views
    780,389

    RE: Extreme Flight 88

    Cool. Looks awesome. Had mine out last weekend.
Results 1 to 25 of 1000
Page 1 of 40 1 2 3 4
All times are GMT -6. The time now is 09:50 PM.

SEO by vBSEO 3.6.1 ©2011, Crawlability, Inc.