Search: Posts Made By: silvermansteve
Showing results 1 to 25 of 368
Search took 0.42 seconds.
Replies: 3
Views: 323
Posted By silvermansteve

XERUN 150 and dx3s, sr300

with this spectrum dx3s setup, I can't get the throttle trim low enough to allow the motor to stay still at neutral throttle. in other words, the car would just take off. with the tactic rtr radio...
01-11-2014, 08:12 PM
Replies: 3
Views: 408
Posted By silvermansteve

What Problem is This?

I have a losi 3.4, stock with the ross in a ten-t. it sat for a couple of years. I took it out yesterday.

the ross cranked it, and the engine started making clanking sounds. not normal. but...
01-11-2014, 07:59 PM
Replies: 9
Views: 1,097
Posted By silvermansteve

I got a dynamite platinum .25 truggy motor for...

I got a dynamite platinum .25 truggy motor for about $100 on ebay a while ago don't know maybe worth a look.
12-09-2013, 03:43 PM
Replies: 13
Views: 2,116
Posted By silvermansteve

the sale is over, unfortunately. the kit has...

the sale is over, unfortunately. the kit has some upgrades over the rtr, you can see on the axial site. if you don't have a radio maybe the rtr is good for you. usually it's cheaper to go rtr than...
12-06-2013, 10:37 PM
Replies: 13
Views: 2,116
Posted By silvermansteve

Axial SCX 10 Jeep Kit

i'm looking at an Axial SCX 10 Jeep Rubicon Kit. I already have a cr-01. if anybody has experience with both--would the axial have a tighter turning radius? is the axial reliable--talking about...
Forum: The Clubhouse
11-30-2013, 02:34 PM
Replies: 212
Views: 17,134
Posted By silvermansteve

hk is ok if you understand not to rely on their...

hk is ok if you understand not to rely on their customer service, and that you might lose sometimes. I order from them still, and have gotten lots of great stuff and a couplle of lemons. if you...
11-25-2013, 03:56 PM
Replies: 6
Views: 439
Posted By silvermansteve

if a car is taken out of the box and ran twice...

if a car is taken out of the box and ran twice and is almost pristine it might be worth a little over 50 percent of new, in my experience. that's a LITTLE over 50 percent, not much. if the thing's...
11-25-2013, 03:08 PM
Replies: 2
Views: 266
Posted By silvermansteve

xerun 150, need more help. won't run sensorless.

my xerun 150 runs fine now that I followed syko's advice and calibrated the throttle settings -- idle, neutral and full throttle. but it refuses to run sensored. i'm using the hobbyking sensor...
11-25-2013, 02:55 PM
Replies: 7
Views: 304
Posted By silvermansteve

I have a question too. do these motors have rev...

I have a question too. do these motors have rev limiters? how easy is it to over rev them with no load? I always assumed you could do it, like maximus says, but can you really? ever seen it...
11-25-2013, 02:52 PM
Replies: 7
Views: 304
Posted By silvermansteve

you are most wise, syco. it was exactly,...

you are most wise, syco. it was exactly, precisely and completely as you said. my experience in rc has taught me that if there's a problem with equipment that's not on fire, or maybe is on fire,...
11-25-2013, 01:55 PM
Replies: 7
Views: 304
Posted By silvermansteve

thanks! I will try setting up the esc per the...

thanks! I will try setting up the esc per the manual. I do not think radio throttle reverse changes the direction the shaft spins in? anyway, I do know about switching the wires.... as for the...
11-24-2013, 09:09 AM
Replies: 24
Views: 4,736
Posted By silvermansteve

http://www.hobbyking.com/hobbyking/store/__16272__...

http://www.hobbyking.com/hobbyking/store/__16272__HK15298B_High_Voltage_Coreless_Digital_MG_BB_Servo_66g_20kg_0_16s.html. 20kg, cheap, 20 bucks. have one but did not test it out. if it breaks,...
11-24-2013, 09:03 AM
Replies: 7
Views: 304
Posted By silvermansteve

xerun 150 escwith strange behavior

the xerun 150 is hooked up to a turnigy trackstar 2350 4 pole motor. i'm running it on 5s. in a Tamiya truggy. i'm using a spectrum dx3s. the problem does not seem to be the radio -- it works on...
10-21-2013, 11:12 PM
Replies: 2
Views: 667
Posted By silvermansteve

I bought some gears from robinson racing. worked...

I bought some gears from robinson racing. worked for me. they have a good reputation, i'd say. not cheap.
10-15-2013, 05:33 AM
Replies: 14
Views: 4,811
Posted By silvermansteve

I liked the pictures foxy; also you have a nice...

I liked the pictures foxy; also you have a nice view there. may I ask, what esc is that? ( I just happen to be obsessing over 1/8 scale esc's right now, to go on a truggy conversion; I don't think...
10-13-2013, 04:58 PM
Replies: 0
Views: 202
Posted By silvermansteve

steel gears for revo

hello:

this is for a revo 3.3, tekno brushless conversion run on 6s with a 2000kv 4 pole motor. I stripped the tranny's input gear, traxxas part nos. 5383, 5384, 5385 depending on ratio.
...
Forum: RC Jets
10-11-2013, 08:13 PM
Replies: 190
Views: 13,600
Posted By silvermansteve

I want to ban revos. and 6s batteries. and 3s...

I want to ban revos. and 6s batteries. and 3s batteries because they can be run in serial.... for 6s. because I've twice stripped my stock input gear. and ban the Tamiya cr-01 for snapping...
10-11-2013, 04:11 PM
Replies: 0
Views: 230
Posted By silvermansteve

revo gears

hello:

this is for a revo 3.3 I think, tekno brushless conversion run on 6s with a 2000kv 4 pole motor. I stripped the tranny's input gear, traxxas part nos. 5383, 5384, 5385 depending on...
10-08-2013, 03:05 AM
Replies: 5
Views: 745
Posted By silvermansteve

you are always quite helpful and generous with...

you are always quite helpful and generous with your time. thanks, i'll look for the hack now.
10-08-2013, 02:54 AM
Replies: 5
Views: 745
Posted By silvermansteve

yeah! I guess I was thinking more about the esc....

yeah! I guess I was thinking more about the esc. but you need their tqi radio tx and rx to unlock it. kind of dampens my enthusiasm. thank you for your reply foxy.
10-08-2013, 02:45 AM
Replies: 5
Views: 745
Posted By silvermansteve

Mamba monster extreme from xo1

is there any reason NOT to run the monster extreme esc -- and even motor in a revo or truggy? thanks. oh, on 6s.....
Forum: ARF or RTF
10-02-2013, 06:36 AM
Replies: 3
Views: 441
Posted By silvermansteve

kyosho arfs

I was looking at the calmato 1400 ep and others on the kyosho site. prices are good. does anybody have any input on kyosho arfs, good or bad? thanks!
Forum: The Clubhouse
09-21-2013, 06:44 AM
Replies: 200
Views: 11,541
Posted By silvermansteve

nobody says hobbyking has good customer service. ...

nobody says hobbyking has good customer service. nobody. so there is nothing even to disagree on there. and why would it upset hk critics if some people have had good luck with hk, or are even...
09-18-2013, 01:32 AM
Replies: 4
Views: 442
Posted By silvermansteve

I suspected that what works in a 6s brushless...

I suspected that what works in a 6s brushless revo or 1/8 buggy wouldn't work here.... thanks for the replies.
09-16-2013, 10:37 PM
Replies: 4
Views: 442
Posted By silvermansteve

Batteries for Blade 500 3D

I see the blade 500 3d calls for 2800-3000 mah, 6s, 30c batteries. can I get away with 4000 mah, 6s, 30c batteries instead? because that's what I have plenty of already. thanks for any info on...
Showing results 1 to 25 of 368
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service