Search: Posts Made By: larry_L
Showing results 1 to 10 of 10
Search took 0.54 seconds.
Forum: Gas Engines
08-26-2011, 10:48 AM
Replies: 7
Views: 561
Posted By larry_L

RE: How do you remove the Cylinder sleeve from a Evolution 40GX?

I followed your instructions and had success! You were absolutely right about when you reach the right moment in time the liner slides right out. Thank you very much for your help.
Forum: Gas Engines
08-25-2011, 06:50 PM
Replies: 7
Views: 561
Posted By larry_L

RE: How do you remove the Cylinder sleeve from a Evolution 40GX?

Thanks. This helps a lot. I'll give it a try tomorrow.
Forum: Gas Engines
08-24-2011, 08:55 AM
Replies: 7
Views: 561
Posted By larry_L

How do you remove the Cylinder sleeve from a Evolution 40GX?

I tried heating the case with a butane torch and pushing the sleeve out by wedging a piece of wood between the piston and sleeve port and turning the crankshaft but had no luck. Does anyone have...
02-15-2011, 12:03 PM
Replies: 3
Views: 671
Posted By larry_L

What's a good charger for 6s, 5000mah batteries?

I am in the market for a 6s, 5000mah charger and was wondering what guys are using. My power setup requires 12s so I wonder if a duel port would make more sense. Also, what would be a good power...
11-22-2010, 09:03 AM
Replies: 4
Views: 911
Posted By larry_L

RE: YS-140 to electric

What are the advantages of going with (2) 5 cell packs in series vs (1) 10 cell pack?
11-20-2010, 01:51 PM
Replies: 4
Views: 911
Posted By larry_L

YS-140 to electric

I want to convert my 80” Taylor Craft over to electric and could use some advice on what I should install. The present flying weight is around 10 ¾ pounds and it hovers good at about ¾ throttle...
Replies: 0
Views: 463
Posted By larry_L

Need Help Converting YS-140 T-Craft to Electric

I am converting my 80” Taylor Craft over to electric and was wondering if anyone had suggestions on the setup. The present flying weight is around 10 ¾ pounds and it hovers good at about ¾...
07-22-2008, 04:07 PM
Replies: 4
Views: 387
Posted By larry_L

RE: Cowling screws on Quique 86" Yak

Thanks for the great tips.
07-21-2008, 10:41 AM
Replies: 4
Views: 387
Posted By larry_L

Cowling screws on Quique 86" Yak

I am having trouble keeping the cowling screws from vibrating out during flight. Any suggestions?
Showing results 1 to 10 of 10


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service