Register

If this is your first visit, please click the Sign Up now button to begin the process of creating your account so you can begin posting on our forums! The Sign Up process will only take up about a minute of two of your time.

Search:

Type: Posts; User: k_sonn

Page 1 of 40 1 2 3 4

Search: Search took 0.71 seconds.

  1. Thread: skymaster pc-21

    by k_sonn
    Replies
    127
    Views
    11,119

    There is a strap on the top and bottom of each...

    There is a strap on the top and bottom of each exhaust stack.
  2. Thread: skymaster pc-21

    by k_sonn
    Replies
    127
    Views
    11,119

    Thanks John. Email has been sent. Kirk

    Thanks John. Email has been sent.

    Kirk
  3. Thread: skymaster pc-21

    by k_sonn
    Replies
    127
    Views
    11,119

    I don't think that would work. The exhaust...

    I don't think that would work. The exhaust stacks slide over the turboprop's exhaust openings and it is a very tight fit.
  4. Thread: skymaster pc-21

    by k_sonn
    Replies
    127
    Views
    11,119

    Hey Bob, Looking forward to catching up at the...

    Hey Bob,

    Looking forward to catching up at the Fall Jet Classic event.

    Kirk
  5. Thread: skymaster pc-21

    by k_sonn
    Replies
    127
    Views
    11,119

    Just talked to Danny and he's going to work with...

    Just talked to Danny and he's going to work with Anton to replace the exhaust stacks.

    Kirk
  6. Thread: skymaster pc-21

    by k_sonn
    Replies
    127
    Views
    11,119

    Yesterday I took the PC-21 to the field to run...

    Yesterday I took the PC-21 to the field to run the turboprop, range test, taxi test, and maiden if everything went well. Unfortunately, the tack welds on one of the exhaust hold down straps broke...
  7. Replies
    88
    Views
    5,778

    Yesterday I test ran the turboprop with a 3...

    Yesterday I test ran the turboprop with a 3 bladed 22 inch Solo prop dialed to 24 degrees. The rpm on the ground was 4700 at full throttle and 1580 at idle.

    Kirk
  8. Thread: skymaster pc-21

    by k_sonn
    Replies
    127
    Views
    11,119

    I received the turboprop yesterday and was able...

    I received the turboprop yesterday and was able to get it to start on first attempt this morning. I think this pretty much confirms I had some bad kero since I ran into the same issue with the K-180...
  9. Replies
    44
    Views
    1,588

    Thanks Basil. And thanks for posting video. ...

    Thanks Basil. And thanks for posting video.

    Kirk
  10. Replies
    44
    Views
    1,588

    I'm happy to report the maiden was successful. ...

    I'm happy to report the maiden was successful. :D Very nice flying plane!!

    Kirk
  11. Replies
    12
    Views
    520

    I built the one a few years ago. Here's a link...

    I built the one a few years ago. Here's a link to the build thread.
    http://www.rcuniverse.com/forum/rc-jets-120/9652030-ziroli-panther.html

    Kirk
  12. Replies
    44
    Views
    1,588

    Are you planning to bring your Viper to the field...

    Are you planning to bring your Viper to the field this weekend?
  13. Replies
    44
    Views
    1,588

    You know it. Maybe I should leave it as is :) ...

    You know it. Maybe I should leave it as is :) Good luck on your Hawk maiden.
  14. Replies
    44
    Views
    1,588

    Thanks Mike. Good to hear that I won't need to...

    Thanks Mike. Good to hear that I won't need to strip the paint and start over.
  15. Replies
    44
    Views
    1,588

    Thanks Mike. I've been considering crow. How...

    Thanks Mike. I've been considering crow. How much do you have in yours?

    Kirk
  16. Replies
    44
    Views
    1,588

    Keith, the paint is flat and the clear is satin.

    Keith, the paint is flat and the clear is satin.
  17. Replies
    44
    Views
    1,588

    It's been a while since the last update so here's...

    It's been a while since the last update so here's where things are. The painting has been completed but I did run into an issue with the clear. As the clear dried it left spotty, hazy areas. I...
  18. Thread: skymaster pc-21

    by k_sonn
    Replies
    127
    Views
    11,119

    John, I've been offline for a week or so busy...

    John, I've been offline for a week or so busy with work and such. I'll try to get some more photos in the next couple of days of the installation.

    David, no maiden yet. I had an issue with the...
  19. Thread: skymaster pc-21

    by k_sonn
    Replies
    127
    Views
    11,119

    Thanks for the video David. Kirk

    Thanks for the video David.

    Kirk
  20. Thread: skymaster pc-21

    by k_sonn
    Replies
    127
    Views
    11,119

    Great news David. I'm hoping to get my maiden...

    Great news David. I'm hoping to get my maiden next weekend or the weekend after.

    Did you get damping oil for the oleos with your kit? My kit didn't have the oil. If you didn't get the oil,...
  21. Thread: skymaster pc-21

    by k_sonn
    Replies
    127
    Views
    11,119

    Hi Reuben, The UniLights come with an aluminum...

    Hi Reuben,

    The UniLights come with an aluminum heat sink attached. (Photo is from the UniLight web site).

    Kirk

    2110411
  22. Thread: skymaster pc-21

    by k_sonn
    Replies
    127
    Views
    11,119

    Here's a short video showing the lights. The...

    Here's a short video showing the lights. The batteries are just about depleted so the lights aren't very bright. In the video, the top beacon light is pulsing as it gets brighter and dimmer but to...
  23. Thread: skymaster pc-21

    by k_sonn
    Replies
    127
    Views
    11,119

    Thanks Danny.

    Thanks Danny.
  24. Thread: skymaster pc-21

    by k_sonn
    Replies
    127
    Views
    11,119

    I purchased the UniLight large jet bundle from...

    I purchased the UniLight large jet bundle from DreamWorks but couldn't use the nav lights. I was able to use the landing, rear position, and beacon lights from the kit. I purchased 2 red and 2...
  25. Thread: skymaster pc-21

    by k_sonn
    Replies
    127
    Views
    11,119

    Hi Danny, Please share any info you may have. ...

    Hi Danny,

    Please share any info you may have. I talked to Bret before Kentucky Jets and he said you guys had some info that Anton shared with you guys about running temps and what to look for and...
Results 1 to 25 of 1000
Page 1 of 40 1 2 3 4
All times are GMT -6. The time now is 11:17 PM.

SEO by vBSEO 3.6.1 ©2011, Crawlability, Inc.