Search: Posts Made By: Yade
Showing results 1 to 21 of 21
Search took 0.03 seconds.
Forum: Walkera Helis - Dragonfly, etc.. 08-04-2006, 05:57 PM
Replies: 12,090
Views: 836,327
Posted By Yade
RE: Walkera Dragonfly #36

I have saved the settings I use on a web page linked to here . They seem to work ok for me but I am a beginner with this radio too so there are probably better configutrations. They should get you...
Forum: Walkera Helis - Dragonfly, etc.. 07-23-2006, 07:02 PM
Replies: 3
Views: 777
Posted By Yade
RE: Speed Controller Connection Walkera 36

If you are refering to a adding a new brushless ESC here is a picture that may help you with your connections.
Forum: Electric RC Helis 07-23-2006, 06:51 PM
Replies: 2
Views: 426
Posted By Yade
RE: Electronics question about BEC's

It will still drop the voltage to 5v but since there is no current draw there will be almost no load on the battery and almost no power dissipation (heat) from the linear BEC. The linear regulator...
Forum: Walkera Helis - Dragonfly, etc.. 07-23-2006, 06:37 PM
Replies: 9
Views: 768
Posted By Yade
RE: "glitch free" chip upgrade

I also seen this on ebay. I think the guy selling them is on this forum as ViciousHeli. See this thread
http://www.rcuniverse.com/forum/m_4408907/anchors_4408907/mpage_1/key_/anchor/tm.htm#4408907...
Forum: Walkera Helis - Dragonfly, etc.. 07-10-2006, 07:41 PM
Replies: 5
Views: 727
Posted By Yade
RE: walkera 36, need urgent help... thanks!!!

Sounds like your speed controller is ok. Your problem is probably a combination of a couple of things not in the right position when you power up the heli.
The 3-D switch is the one I mentioned...
Forum: Walkera Helis - Dragonfly, etc.. 07-10-2006, 07:20 PM
Replies: 4
Views: 448
Posted By Yade
RE: HOW do i disable a walkera BEC ??

This manual for an electrifly controller explains how to do it. It will be the same for your controller.
Forum: Walkera Helis - Dragonfly, etc.. 07-09-2006, 06:31 PM
Replies: 5
Views: 727
Posted By Yade
RE: walkera 36, need urgent help... thanks!!!

1) The speed controller may be bad in your RX. It could also be the idle up switch, the one on the right ot your TX. It should be in the N position. I don't know what affect this switch would have on...
Forum: Electric RC Helis 06-16-2006, 05:57 PM
Replies: 8
Views: 1,004
Posted By Yade
RE: futab r156f receiver

The channels on the reciever are dependant on the transmitter. If the transmitter uses channel 3 for throttle, then channel 3 on the receiver is for throttle (esc). Consult you transmitter manual for...
Forum: Walkera Helis - Dragonfly, etc.. 06-16-2006, 05:24 PM
Replies: 2
Views: 423
Posted By Yade
RE: Dragonfly 36 inner rod unscrews from main shaft sleeve cross block

Sounds like the set screws are loose on the HM036-026, at the bottom of the main shaft.
Forum: Walkera Helis - Dragonfly, etc.. 06-09-2006, 03:39 PM
Replies: 1
Views: 575
Posted By Yade
RE: Dual Rate gyro on Walkera 36 problems

I read somewhere in this forum about people having this king of problem and the solution was the orientation of the gyro. I think it has to be mounted as shown in this picture. I don't own one...
Forum: Electric RC Helis 06-02-2006, 06:38 PM
Replies: 2
Views: 452
Posted By Yade
RE: lama 2 eflite 4-1 help

You will have to keep the 4-1 in the same orientation as it is on the CX in order for the onboard gyro to work properly. As for the spinning when you do this, it may be that one/or both of the motors...
Forum: Walkera Helis - Dragonfly, etc.. 05-28-2006, 10:24 AM
Replies: 56
Views: 14,578
Posted By Yade
RE: Beware EHIROBO.COM

I too have had problems with this store. They sent the wrong parts and asked me to pay shipping again for the correct parts. They never did send the correct parts, they just ignored me.

BTW,...
Forum: Walkera Helis - Dragonfly, etc.. 05-24-2006, 06:35 PM
Replies: 12,090
Views: 836,327
Posted By Yade
RE: Walkera Dragonfly #36

The GY401 is great, but it does not work with the stock radio that comes with a #36. There was some discussion on this topic here:
401 on the stock 36 electronics
Forum: Electric RC Helis 05-22-2006, 11:39 AM
Replies: 14
Views: 640
Posted By Yade
RE: Need help quick burned 4in1

I just noticed that you are local to me. I can fix that 4 in 1 for you for a modest fee. Message me if you are interested.
Forum: Electric RC Helis 05-22-2006, 11:17 AM
Replies: 14
Views: 640
Posted By Yade
RE: Need help quick burned 4in1

It should be an IRF7413 . The two, with the same pin count, below are the same part. The last number on the bottom should be F7413. They are about $2.00 to buy. I Get them from a local supplier. You...
Forum: Walkera Helis - Dragonfly, etc.. 05-21-2006, 07:18 PM
Replies: 12,090
Views: 836,327
Posted By Yade
RE: Walkera Dragonfly #36

Check that your flight mode switch is in the N position and that your throttle is all the way down before plugging the battery in.
Some 36 owners are using a Telebee gyro to replace the stock one....
Forum: Walkera Helis - Dragonfly, etc.. 05-05-2006, 07:31 PM
Replies: 12,090
Views: 836,327
Posted By Yade
RE: Walkera Dragonfly #36

If I am not mistaken, that is the same gyro as the Telebee/Align gyro.

http://cgi.ebay.com.au/Align-Gyro-Head-Lock-Standard-Dual-Rate-telebee-piezo_W0QQitemZ6033423740
...
Forum: Walkera Helis - Dragonfly, etc.. 05-04-2006, 04:24 PM
Replies: 1
Views: 594
Posted By Yade
RE: #36 Gyro Light Color

The gyro light is supposed to act that way. The servo should move as fast as the other servos. It did on mine when I was using that gyro. I think there are a few slightly different versions of this...
Forum: Walkera Helis - Dragonfly, etc.. 04-28-2006, 09:17 PM
Replies: 4
Views: 1,885
Posted By Yade
RE: The Best ESC for BL motor on #36 dragonfly

My 30 amp esc from Walkera worked good, but it started very hard. I went to an E-Flite 40-Amp Brushless ESC. It is relatively inexpensive, and it works great with my Walkera 180L motor.
Forum: Walkera Helis - Dragonfly, etc.. 04-08-2006, 07:50 PM
Replies: 14
Views: 2,258
Posted By Yade
RE: 401 on the stock 36 electronics

I checked my transistor, and it does not get very hot, just warm. It may be getting hot because there is something wrong with the antenna, or the wire going to it.
Forum: Walkera Helis - Dragonfly, etc.. 04-07-2006, 08:45 PM
Replies: 14
Views: 2,258
Posted By Yade
RE: 401 on the stock 36 electronics

I did some testing and I don't think that channel 5 can be made proportional. I could only make it go from one exteme to another, nothing in between.
Showing results 1 to 21 of 21



Forum Jump


All times are GMT -8. The time now is 01:09 PM.