Register

If this is your first visit, please click the Sign Up now button to begin the process of creating your account so you can begin posting on our forums! The Sign Up process will only take up about a minute of two of your time.

Search:

Type: Posts; User: Thud_Driver

Page 1 of 40 1 2 3 4

Search: Search took 1.49 seconds.

  1. Replies
    3
    Views
    170

    For Aero, note that the VR for flaps only works...

    For Aero, note that the VR for flaps only works with the flap switch in Flap Position 1 plus you can only get 0 - 100% travel, not the full range of the channel. If you want more than that, you have...
  2. Worth a shot in any event. I just went in the...

    Worth a shot in any event. I just went in the garage and took an ECU set to a P-70 and hooked it to a P-80SE and let it reset. Then, I hooked it back up to the P-70 and it reset itself back to a...
  3. You should just plug it into the engine and power...

    You should just plug it into the engine and power it up. Usually, the ECU will read what engine it is attached to and make the switch. If you have the GSU plugged in, you can watch it happen on the...
  4. As dbsonic says, it was a rocket capable of very...

    As dbsonic says, it was a rocket capable of very high g's.
  5. Replies
    4
    Views
    201

    Just go fly. Works fine for me. There's nothing...

    Just go fly. Works fine for me. There's nothing to change.
  6. Replies
    8
    Views
    196

    http://www.radicalrc.com/category/Lipo-TX--RX-Pack...

    http://www.radicalrc.com/category/Lipo-TX--RX-Packs-274

    The 2800mah 2S 7.4 pack on this page from Radical R/C. $22 + $3 shipping. Been using 2 since June 2011 in my SD-10G's.
  7. I just use a very small screwdriver and/or a dull...

    I just use a very small screwdriver and/or a dull Xacto with a very dull tip. Trick is to work the blade under the top of the rim and behind the o-ring and pry it out.
  8. Replies
    4
    Views
    166

    If you can get to the starter, you can push it...

    If you can get to the starter, you can push it sideways a little to increase the friction of the o-ring to the nose cone. This will work for a little while but then you will have to change it.

    If...
  9. Replies
    2
    Views
    122

    That cable also powers the electronics module...

    That cable also powers the electronics module inside the cowling which reports RPM and EGT over the data bus. You probably had a LOW RPM shutdown indication on the GSU.
  10. Yeah, Hitec and Futaba are both negative shift so...

    Yeah, Hitec and Futaba are both negative shift so should probably work. Everybody else is positive shift.
  11. Dual conversion receivers need dual conversion...

    Dual conversion receivers need dual conversion crystals due to the higher Intermediate Frequency (IF) in the first conversion stage. Tx crystal is ok but you'll need a DC Rx crystal.
    ...
  12. Replies
    64
    Views
    2,784

    Slow again today. I'm on a 12 Mbs cable...

    Slow again today. I'm on a 12 Mbs cable connection with an I7 Quad core 3Ghz system. Many times when I click on a forum, it will think for awhile and not do anything. 2nd click usually gets it but...
  13. You'll have to call JetCat about the serial...

    You'll have to call JetCat about the serial number and service history. Not likely anybody would know that. P-120's with serial #1996 and up are capable of being converted to SE. I don't know the...
  14. Kero plug is $200 via online ordering on JetCat's...

    Kero plug is $200 via online ordering on JetCat's web site. You can buy 10 years worth of propane for that.

    You can verify the run time under Statistics on the GSU.

    Just start the engine. ...
  15. Replies
    64
    Views
    2,784

    +1

    +1
  16. Replies
    53
    Views
    4,002

    62-4425 - Named "naada" and located outside of...

    62-4425 - Named "naada" and located outside of American Legion Post 325 in Blissfield, Michigan.

    Jimmy Boyd's airplane. "naada" isn't right. Should be a Thai inscription in white on a black...
  17. Replies
    53
    Views
    4,002

    Funny how Mig-21's proliferate. In the late...

    Funny how Mig-21's proliferate. In the late '90's Lockheed was doing a re-engine/avionics upgrade of A-4M's out of the boneyard for the Argentine AF and we were looking for a chase aircraft to...
  18. Replies
    44
    Views
    2,503

    Don't have the answer, but I've seen pretty much...

    Don't have the answer, but I've seen pretty much every engine from a P-60 thru a P-200 stick at one time or another. The P-200 was bad enough that we carried a dowel to reach up the tailpipe and...
  19. Don't use a Y harness., and, with that radio, you...

    Don't use a Y harness., and, with that radio, you should pretty much try not to have to use a Y harness for anything. 2 batteries to 2 switches to 2 ports. Provides higher current capacity to the...
  20. Replies
    1
    Views
    103

    You might want to repost this on the KingTech...

    You might want to repost this on the KingTech forum:

    www.rcuniverse.com/forum/kingtech-turbines-international-521/
  21. Mark, The club has the trophy. At the second...

    Mark,

    The club has the trophy. At the second last Fresno Jets, I "let" George Manning beat me.:cool: It was only us competing against each other anyway.We brought it back for the last meet and...
  22. Replies
    5
    Views
    229

    Ok, whatever gets loaded when the ECU...

    Ok, whatever gets loaded when the ECU self-detected that it was attached to a P-80 must just be the 117K base load. I don't know if there are any other non-SE P-80 files in the ECU.

    Used to be...
  23. Replies
    5
    Views
    229

    Need more information. First, just to ask, you...

    Need more information.

    First, just to ask, you went to Limits on the GSU, moved to Max RPM, where it shows 117000 rpm, then you held down the Chg Button and tried to increase the rpm with the...
  24. Replies
    5
    Views
    246

    I've done it. The canopy has to be acetate,...

    I've done it. The canopy has to be acetate, butyrate, or the like. Soda bottles and polycarbonate just won't take the tint. I just tried that a couple months ago.

    Find a container large enough...
  25. Replies
    7
    Views
    421

    The 3 pistons each have an o-ring. Remove the...

    The 3 pistons each have an o-ring. Remove the band and use low air pressure to pop out the pistons (make sure you restrain them from flying off). Then you can lube the O-rings and reinstall the...
Results 1 to 25 of 1000
Page 1 of 40 1 2 3 4
All times are GMT -6. The time now is 03:42 AM.

SEO by vBSEO 3.6.1 ©2011, Crawlability, Inc.