Register

If this is your first visit, please click the Sign Up now button to begin the process of creating your account so you can begin posting on our forums! The Sign Up process will only take up about a minute of two of your time.

Search:

Type: Posts; User: mustangman177

Page 1 of 28 1 2 3 4

Search: Search took 0.75 seconds.

  1. Replies
    5
    Views
    219

    Thanks for posting this........I have the exact...

    Thanks for posting this........I have the exact same engine and opto kill switch (that I haven't installed yet) and now I won't after reading this !!! I have heard of similar problems using this...
  2. Replies
    28
    Views
    849

    Are Futaba's Heavy Duty switch harnesses any...

    Are Futaba's Heavy Duty switch harnesses any better ? I'm using 2 of these on my DLE 35 RA Gasser. ? Was using smaller Hitec switch on the ignition side, unitl I too was experiencing sone surging...
  3. Replies
    54
    Views
    2,207

    That made me chuckle !!!!! Good one !! Al...

    That made me chuckle !!!!! Good one !!

    Al least he can laugh at this. I remember my first crash, thought it was the end of the world and I would never fly again.

    L8Cruiser: Welcome to the...
  4. Replies
    60
    Views
    2,669

    X2 My thoughts also...... Nothing like...

    X2 My thoughts also...... Nothing like messing up a good days activities than a DUI
  5. Replies
    33
    Views
    1,413

    Thanks for the tip. To get to the carb.filter...

    Thanks for the tip. To get to the carb.filter screen, I have to remove the engine from the plane, then the muffler before I can get to the back plate.
  6. Replies
    33
    Views
    1,413

    This particular gas can set up is not mine, but...

    This particular gas can set up is not mine, but rather a picture of "Earlwb" set-up that I copied ( See post #9). I "Zip tied" My dubro hand crank fuel pump to the handle. I don't know how he...
  7. Replies
    33
    Views
    1,413

    Just getting into gas engines,( DLE 35 RA), and...

    Just getting into gas engines,( DLE 35 RA), and looking at my gas can set up, I see I am doing it all wrong.

    What I was using is a metal "gas" can that is not sealed from the atmospheric air. ...
  8. Replies
    24
    Views
    602

    My nipple is metal too (whoops !) As CARS II...

    My nipple is metal too (whoops !) As CARS II stated.

    I did richen the low end today and got 7-8 flights in without any surging, so I think I licked the problem.

    I also switched to a XOAR 18...
  9. Replies
    24
    Views
    602

    So on the DLE 35, they cannot un-screw ?

    So on the DLE 35, they cannot un-screw ?
  10. Replies
    24
    Views
    602

    I removed the fuel valve and still had the same...

    I removed the fuel valve and still had the same results, so couldn't be the fuel valve causing the surging, also opened the low end needle valve 1/4 turn. Had better results here as had one...
  11. Replies
    33
    Views
    3,673

    Flew mine with a OS BGX 3500. Was quite a glow...

    Flew mine with a OS BGX 3500. Was quite a glow hog, but was fun to fly.
  12. What Vertical Grimmace said is correct. I...

    What Vertical Grimmace said is correct.

    I just tried my first Xoar prop yesterday on my DLE 35 RA., A 18 X 8 and I was THOROUGHLY impressed. I did nave to balance it before putting it on,...
  13. Replies
    13
    Views
    291

    Right !!! Missed the OP's original question. Me...

    Right !!! Missed the OP's original question. Me bad.
  14. Replies
    13
    Views
    291

    The way a fellow modeler told me once, and what I...

    The way a fellow modeler told me once, and what I use it is to- open the throttle to about half trottle (engine running), and adjust the low end needle until you reach maximum rpm's. I've used this....
  15. Replies
    24
    Views
    602

    Thanks Cars !! and Lifer Will completely...

    Thanks Cars !! and Lifer

    Will completely remove the fuel valve as the engine is completely exposed. Not sure why I put in the valve in the first place, habit I guess. Will go from tank to carb....
  16. Replies
    24
    Views
    602

    Thanks speedracer. Will by pass the filler...

    Thanks speedracer.

    Will by pass the filler valve to eliminate this as a culprit.
  17. Replies
    24
    Views
    602

    DLE 35 surging

    Need some help.

    Have a DLE 35 that will surge (increase throttle). Will usually occur after running 3/4 to full throttle and then going to idle. It is only for a brief second, but naturally has...
  18. Replies
    109
    Views
    21,049

    x 2

    x 2
  19. Replies
    102
    Views
    4,280

    Did not cover the plane after this. Don't notice...

    Did not cover the plane after this. Don't notice any turbulence problems. Been flying planes like this for 10+ years ?. When drilling these holes, it's important to offset the holes so that the...
  20. Replies
    102
    Views
    4,280

    Took off 1 lb. by cutting the lightning holes. ...

    Took off 1 lb. by cutting the lightning holes. Went from 13 lb. 6 oz. to 12 lb. 6 oz.

    http://images.rcuniverse.com/gallery/photos/16901/lg-245762.jpg
  21. Replies
    13
    Views
    350

    Pretty much scratch built. Built many spads...

    Pretty much scratch built. Built many spads before this. Flys very gentle and docile like. Came in at 28 oz. wing loading.
  22. Replies
    13
    Views
    350

    Here's my Gasser DLE 35 RA and SPAD USS. ...

    Here's my Gasser DLE 35 RA and SPAD USS.

    http://www.rcuniverse.com/gallery/galleryItem.cfm?itemID=245762&dummy=8990.870678612122&opener=/gallery/galleryCat.cfm%3FmemberID%3D16901
    ...
  23. Replies
    20
    Views
    649

    Straight from the DLE manual "Always use...

    Straight from the DLE manual

    "Always use high-quality oil intended for 2-stroke (2-cycle) engines. It’s a good idea to use a petroleum-based 2-cycle motor oil like Lawn Boy All Season - Ashless...
  24. Replies
    83
    Views
    2,292

    Where can I buy or how do i make a ethanol tester...

    Where can I buy or how do i make a ethanol tester ?

    Bought 5 gallon of ethanol free gas today from a station that was listed on the website. I asked the teen-age girl at the counter first to...
  25. Replies
    83
    Views
    2,292

    Good discussion on types-amounts and break in...

    Good discussion on types-amounts and break in oil. Also thanks for the stations that list the ethanol free gas.

    Just bought and breaking in a DLE 35 RA myself. In the manual it says "to use Lawn...
Results 1 to 25 of 678
Page 1 of 28 1 2 3 4
All times are GMT -6. The time now is 03:36 PM.

SEO by vBSEO 3.6.1 ©2011, Crawlability, Inc.