Search: Posts Made By: rafeeki
Showing results 1 to 25 of 436
Search took 0.41 seconds.
11-04-2019, 06:04 PM
Replies: 183
Views: 26,451
Posted By rafeeki

you mean while using that dumb thumb.....?

you mean while using that dumb thumb.....?
Forum: Glow Engines
11-01-2019, 02:56 PM
Replies: 43,645
Views: 2,439,272
Posted By rafeeki

Saito FA 180 anyone?

-------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Looking for an unaltered...
10-30-2019, 07:17 AM
Replies: 183
Views: 26,451
Posted By rafeeki

Thanks Prekin Mine has a Saito FA 180 in it...

Thanks Prekin
Mine has a Saito FA 180 in it that handles it quite well. However the roll rate is very slow. Any suggestions?
I increased the aileron deflection (same for up and down) somewhat but...
Forum: Marketplace
08-29-2019, 07:09 PM
Replies: 1
Views: 293
Posted By rafeeki

I will take all off your hands. not sure if...

I will take all off your hands.
not sure if there is any cost involved as the ad said you were asking $0.
what would shipping cost to 46373
Thank you
Rafeek
Forum: Marketplace
08-23-2019, 07:46 AM
Replies: 1
Views: 246
Posted By rafeeki

Moki 210xl SOLD

Unused MOKI 210XL
Included original radial engine mount, spare needle valves, prop nut & washer as well as spray bar.
Asking $180 obo. I will pay shipping within the USA
PayPal or certified banker...
Forum: Glow Engines
08-22-2019, 07:49 PM
Replies: 43,645
Views: 2,439,272
Posted By rafeeki

3 cyl Saito drops a cylinder on idle

Could you get it to run on all 3 cylinders all the time? A friend of mine has been having such problems with his.

Rafeek
08-22-2019, 06:01 PM
Replies: 183
Views: 26,451
Posted By rafeeki

How much down elevator did u have to mix in with...

How much down elevator did u have to mix in with the flaps? I am at zero mix and it dives when I engage the flaps.

Tks

Rafeek
Forum: Marketplace
08-03-2019, 09:35 AM
Replies: 0
Views: 237
Posted By rafeeki

Unused moki 210xl

Unused MOKI 210XL
Included an original radial mount, spare needle valves, nut and washer as well as spray bar.
Pl see attached photos
asking $210 obo I will pay shipping in mainland USA
Pay Pal...
Forum: Kit Building
12-23-2018, 12:06 PM
Replies: 4,282
Views: 296,715
Posted By rafeeki

Spinner

You need a prop hub and not a spinner. True Turn make a prop hub for cubs... Fits on the prop no cutout necessary.

Best

Rafeek
Forum: Marketplace
11-23-2018, 07:38 AM
Replies: 0
Views: 293
Posted By rafeeki

Great Planes GILES 202 arf

Good condition, minor scratch on canopy.
73" wingspan
20-30cc engine required
Aluminum spinner included as in pictures
No engine or electronics included
This is a large plane shipping might be...
Forum: Marketplace
10-30-2018, 06:15 PM
Replies: 0
Views: 511
Posted By rafeeki

Great Planes GILES 202

Good condition, minor scratch on canopy.
73" wingspan
20-30cc engine
SPECIFICATIONS
Stock Number: GPMA1315
Wingspan: 73 in (1855 mm)
Wing Area: 973 in˛ (62.8 dm˛)
Weight: 12.5 lb (5.67 kg)...
Forum: ARF or RTF
02-14-2018, 11:38 AM
Replies: 3,263
Views: 419,931
Posted By rafeeki

Cowls

If the cowls are in good condition would you be willing to sell them?

Thanks

Rafeek
01-06-2018, 02:50 PM
Replies: 50
Views: 6,059
Posted By rafeeki

Bd 5

Sold
Forum: ARF or RTF
12-05-2017, 10:11 AM
Replies: 192
Views: 30,502
Posted By rafeeki

wing struts Hi Pittit If u still have your...

wing struts
Hi Pittit
If u still have your Tiger Moth would u pl measure the length of the wing struts from hole to hole. I am rebuilding mine.
thanks
Rafeeki

Rjbesheer@aol.com
Forum: ARF or RTF
09-22-2017, 08:06 AM
Replies: 192
Views: 30,502
Posted By rafeeki

Looking for a Cowl for the Hangar 9 Moth. Also...

Looking for a Cowl for the Hangar 9 Moth.
Also need dimension from top to bottom of wing struts. Not sure if the front and rear are the same length.

Thank you

rafeek
Forum: Glow Engines
06-07-2017, 08:20 PM
Replies: 43,645
Views: 2,439,272
Posted By rafeeki

I have a Saito FA 180 that I have been using for...

I have a Saito FA 180 that I have been using for the last 2 seasons, Runs well with tons of power turning an APC 18x6 until last week when the muffler loosened twice causing the engine to cough in...
02-09-2017, 08:50 PM
Replies: 50
Views: 6,059
Posted By rafeeki

I just acquired a BD5 arf fiberglass fues and...

I just acquired a BD5 arf fiberglass fues and built up wings with electric retracts. Beautiful job. No instructions nor do I know who made it. It most probably came from Hobbyking.
Willing to sell.
Forum: Glow Engines
02-07-2017, 08:11 AM
Replies: 43,645
Views: 2,439,272
Posted By rafeeki

Do you have a pic from underneath showing the...

Do you have a pic from underneath showing the exhaust pipes, I presume they are mated to one exhaust pipe.

Thanks

Rafeek
Forum: Glow Engines
02-06-2017, 08:22 AM
Replies: 43,645
Views: 2,439,272
Posted By rafeeki

Thanks for your suggestion. I really wanted a...

Thanks for your suggestion. I really wanted a Pitts style muffler which RC Specialties dont carry. Which I only found at Slimline.
Any suggestions?
Forum: Glow Engines
02-06-2017, 08:02 AM
Replies: 43,645
Views: 2,439,272
Posted By rafeeki

I would suggest that for the first start up in...

I would suggest that for the first start up in inverted mode that you go back to the original engine specs for the high speed needle valve which may be 4-5 turns out. As the larger 4 strokes are...
Forum: Glow Engines
02-05-2017, 01:34 PM
Replies: 43,645
Views: 2,439,272
Posted By rafeeki

Really upset with "Slimline Mufflers" Have been...

Really upset with "Slimline Mufflers"
Have been trying to get Slimline mufflers for my inverted FA 150 &180. Has been a month now on one and 3 months on the other which was ordered through my local...
Forum: ARF or RTF
02-05-2017, 11:07 AM
Replies: 192
Views: 30,502
Posted By rafeeki

MAXFORD also have one that is even larger. ...

MAXFORD also have one that is even larger.
http://www.maxfordusa.com/105tigermotharf.aspx
Forum: ARF or RTF
01-14-2017, 02:29 PM
Replies: 192
Views: 30,502
Posted By rafeeki

Hi Hector, nice to hear from you. Looks like you...

Hi Hector, nice to hear from you. Looks like you are still having fun with it as much as I am however as I am in the Chicago area the weather is not conducive for outdoor flying yet. Not until...
Forum: ARF or RTF
01-07-2017, 08:59 AM
Replies: 3,263
Views: 419,931
Posted By rafeeki

Bobby, take a look at this link they have the...

Bobby, take a look at this link they have the glass although v slightly smaller. Worked for me though after some modification to the nose gunners cockpit....
Forum: Glow Engines
12-29-2016, 12:28 PM
Replies: 43,645
Views: 2,439,272
Posted By rafeeki

Your input pl. A friend haded me his FA 180...

Your input pl.
A friend haded me his FA 180 with practically no compression. Vslves snd gaps adjusted should i assume i need a new ring job?
Tks
Showing results 1 to 25 of 436
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service