Register

If this is your first visit, please click the Sign Up now button to begin the process of creating your account so you can begin posting on our forums! The Sign Up process will only take up about a minute of two of your time.

Search:

Type: Posts; User: BuschBarber

Page 1 of 40 1 2 3 4

Search: Search took 0.59 seconds.

  1. RE: JR Matchbox & Futaba or Hitec Servos

    I still use the JR Matchbox when I can't use Channel Mixing. You can connect up to 4 servos to one channel and set Neutral, Direction, and End Points for each servo individually. If you are using...
  2. Replies
    12
    Views
    717

    RE: Servo Horn Screws?

    I thought you were referring to the scree that holds on the servo arm to the servo output gear. I understand now that you meant the bolt on adapter arm.
  3. Replies
    12
    Views
    717

    RE: Servo Horn Screws?

    I am guessing these servos have metal gears. The type of servo arm does not necessarily have anything to do with the screw used to hold the arm on. Microfastners is a good place to look for socket...
  4. RE: DX8 throttle rpm adjusting help?????

    What about Throttle Curve in the Mixing Menu?
  5. RE: Anyone Using Tactic ttx650 with Glow Engine Planes?

    I don't think the Tx cares what motor powers the aircraft.
  6. Replies
    156
    Views
    12,789

    RE: Spektrum AR8000 useless without satellite

    Thanks for the clarification. I never use 11ms so that was never an issue.
  7. Replies
    156
    Views
    12,789

    RE: Spektrum AR8000 useless without satellite

    The last time this subject came up, Andy indicated that it was just the same Protocol that mattered.
  8. Replies
    156
    Views
    12,789

    RE: Spektrum AR8000 useless without satellite

    It is my understanding that if you Bind multiple receivers to the same Model Memory, they each need to be the same Protocol ( both DMS2 or both DSMX). The Model Memory stores the Protocol for the...
  9. Replies
    9
    Views
    538

    RE: Master/slave mix problem

    Thanks!
  10. Replies
    156
    Views
    12,789

    RE: Spektrum AR8000 useless without satellite

    Pressing and holding the Bind Button down and then turning on the DX8, without the Rx set to Bind Mode, will wipe the Bind info from the DX8 Model Memory. This is true with other Spektrum...
  11. Replies
    9
    Views
    538

    RE: Master/slave mix problem

    If you do not Bind again, after you choose a Wing Type or Tail Type, you may see one control surface half deflect the wrong way when you first power up the Tx/Rx. This is because the Rx goes into...
  12. Replies
    156
    Views
    12,789

    RE: Spektrum AR8000 useless without satellite

    elite has a number of aircraft that are offered without receivers. The elite Beaver, Taylorcraft, F4 Phantom, and Extra 300 are ones I have. I put Spektrum receivers in them and I have no issues.
  13. Replies
    16
    Views
    828

    RE: JR 921 RECIEVERS

    The JR 10X does support the use of a Spektrum DSM2 module but not the JR DMSS module

    http://www.spektrumrc.com/Articles/Article.aspx?ArticleID=2126

    ...
  14. Replies
    156
    Views
    12,789

    RE: Spektrum AR8000 useless without satellite

    Go to a Futaba forum Mr Troll. You are not helping anyone here and you are sadly misguided.
  15. Replies
    156
    Views
    12,789

    RE: Spektrum AR8000 useless without satellite

    I still use my JR XP9303 with the Spektrum DM9 DSM2 module. Others in my club have the same radio and have had no problems since it came out in 2007. Many others have the X9303, 9503, 11X, 12X, DX8,...
  16. Replies
    156
    Views
    12,789

    RE: Spektrum AR8000 useless without satellite

    I travel to various model meets around the NE and I do not see any trend away from Spektrum. I have not seen any higher instances of failures with any particular manufacturer's radio. Modelers tend...
  17. Replies
    156
    Views
    12,789

    RE: Spektrum AR8000 useless without satellite

    My experiences exactly with the X7S and BNF, not sure why.

    This is not my first trip around the patch with Spektrum gear nor R/C flying in general. Not bashing Spektrum, just find their...
  18. Replies
    22
    Views
    1,065

    RE: wall charger and 6V - NiMH battery

    We have been using wall chargers for many years to charge both 4.8v and 6v NiCad and NiMh batteries. The wall charger charges at such a low rate (50ma-100ma) it is basically a trickle charge for most...
  19. Replies
    156
    Views
    12,789

    RE: Spektrum AR8000 useless without satellite

    I am sorry you are having problems with your AR8000 but many others are not. I never had an issue with mine. I follow the forums related to the DX8 and AR8000. I have not read about any problems with...
  20. Replies
    1
    Views
    300

    RE: new DX7 S and Orange receivers?

    Yes!
  21. Replies
    2
    Views
    293

    RE: Servo centering after Rx swap!

    Were you using a JR or Spektrum Tx with the Spektrum Rx? What Tx are you using with the Futaba receiver? What model Tx and Rx are you using?
    Were the Model Memories reset to Factory Defaults...
  22. Replies
    16
    Views
    828

    RE: JR 921 RECIEVERS

    The original JR 921 Rx is DSM2

    http://www.hobby-lobby.com/jr_r921_9_channel_dsm2_receiver_81195_prd1.htm

    The JR 921X is apparently DSMX

    ...
  23. Replies
    16
    Views
    828

    RE: JR 921 RECIEVERS

    JR 921 receivers are DSM2 only. They will work with a DSMX transmitter, because it is backwardly compatible with DSM2 receivers, but the DSMX transmitter switches to DSM2 to communicate with the JR...
  24. Replies
    16
    Views
    828

    RE: JR 921 RECIEVERS

    Yes! DSM2! Works great.
  25. Replies
    5
    Views
    259

    RE: Older Dx7 Question

    I was looking at the DX7 manual and it looks like Throttle Curve is not available in Acro mode, only Heli mode.
Results 1 to 25 of 1000
Page 1 of 40 1 2 3 4
All times are GMT -6. The time now is 08:48 AM.

SEO by vBSEO 3.6.1 ©2011, Crawlability, Inc.