Register

If this is your first visit, please click the Sign Up now button to begin the process of creating your account so you can begin posting on our forums! The Sign Up process will only take up about a minute of two of your time.

Search:

Type: Posts; User: CAPT John

Page 1 of 9 1 2 3 4

Search: Search took 1.31 seconds.

  1. Replies
    1
    Views
    170

    On my setup the "Clear" button resets the timer.

    On my setup the "Clear" button resets the timer.
  2. Replies
    41
    Views
    4,896

    I replaced a Saito 1.50 with a DLE 20 on my GP...

    I replaced a Saito 1.50 with a DLE 20 on my GP Super Stearman and found it to be a great match. The power is every bit as good as the Saito 4 stroke if not better. The plane only required a few...
  3. Replies
    10
    Views
    291

    The P-47 batteries are good for at least 10...

    The P-47 batteries are good for at least 10 flights before charging, although I have never flown it more than 5 before charging. On my P-47 I have each battery connected to a separate switch. The...
  4. Replies
    10
    Views
    291

    I have two 2100 mah LIFE batteries for the...

    I have two 2100 mah LIFE batteries for the receiver and a 1700 mah LIFE for the ignition. My P-47 could easily fly 8 - 10 flights on these batteries with about 50% battery reserve. The plane uses an...
  5. Replies
    10
    Views
    291

    Yes, you only need to use one connector per...

    Yes, you only need to use one connector per battery. The batteries peak at 3.6 volts/cell or 7.2 volts total.
  6. Replies
    10
    Views
    291

    I use the same batteries on my TF GS P-47 and...

    I use the same batteries on my TF GS P-47 and love the LIFE batteries over NICADs/NIMHs. I use the JR leads to connect to the switches (one per battery) and use the balance leads when I balance...
  7. Replies
    14
    Views
    520

    Thanks Andy.

    Thanks Andy.
  8. Replies
    14
    Views
    520

    Andy, Please confirm that DX9 1.04 update is...

    Andy,
    Please confirm that DX9 1.04 update is only the Audio 1.03 file (no firmware update).
    Thanks
  9. Replies
    17
    Views
    392

    I request to join the Corsair Bro-hood. I have a...

    I request to join the Corsair Bro-hood. I have a Giant Scale Top Flite Corsair and a baby brother FlyZone Corsair.
    Thanks,
    CAPT John
  10. Replies
    3,567
    Views
    232,963

    I was able to get in a few flights this weekend...

    I was able to get in a few flights this weekend with my ESM Spitfire but did not get any photos.
  11. Replies
    1,848
    Views
    247,910

    RE: GP Super Stearman

    I am using the recommended 5 1/2" CG on my Super Stearman and like the way she flies at that balance point.
  12. Replies
    16
    Views
    1,060

    RE: Fox 3.2 Help

    My engine problem has been fixed and as they say, "we have met the enemy and he is us." The problem began as a loose/binding carb butterfly that was not allowing the throttle to close enough to get...
  13. Replies
    16
    Views
    1,060

    RE: Fox 3.2 Help

    Thanks everyone. I have sent the engine to Chris at Fox to determine if the problem is in the engine/carb. I had checked the fuel lines inside the tank, but while the engine is being checked out...
  14. Replies
    16
    Views
    1,060

    RE: Fox 3.2 Help

    I spoke with Chris at Fox and will be sending him the engine to check it out. If it runs good on his bench, I'll know the problem is with my fuel system.
  15. Replies
    16
    Views
    1,060

    RE: Fox 3.2 Help

    Iā€™m back for more help. I still cannot get my Fox 3.2 engine to idle below 4000 rpm. I found that the carb butterfly was binding and not closing completely, so I thought that was the problem with...
  16. Replies
    16
    Views
    1,060

    RE: Fox 3.2 Help

    Thanks everyone for the great suggestions. I had removed the idle screw, so that's not the problem. I'll check the butterfly valve and screw. I had removed the carb for a re-build, so maybe I...
  17. Replies
    16
    Views
    1,060

    Fox 3.2 Help

    I'm new to gas engines and am out of airspeed, altitude, and ideas with my Fox 3.2 engine. The engine is new with about 3 gallons of gas run through it. My problem is even with the throttle fully...
  18. Replies
    3,567
    Views
    232,963

    RE: Spitfire Brotherhood (All Spitfires Welcome)

    I have used PSP Mfg standoffs (specifically thier "Air Cooling" spacers). Here are links: http://www.pspmfg.com/RCAirCoolingSpacers.html and http://www.pspmfg.com/RCStandOffsMotorSpacers.html
  19. Replies
    3,567
    Views
    232,963

    RE: Spitfire Brotherhood (All Spitfires Welcome)

    I would be honored to join the Spitfire Bro Hood. I have an ESM 72" Spitfire. It's a real trooper and a blast to fly with a Saito 1.50.
    John
  20. Replies
    12
    Views
    795

    RE: Anzac Day 2012 - Lest We Forget

    Great poem with a great message.
  21. Replies
    1,006
    Views
    125,843

    RE: Top Flite Giant P47 arf IS coming

    Wyliewarbirds.com sells the fiberglass hatch for $10. I just ordered one! The Robart door hinges are not included but are available from Tower.
  22. Replies
    6
    Views
    1,130

    RE: topflite giant p-47 arf

    TFarmer96 posted a great series of build photos on the "Top Flite Giant P47 ARF Is Coming" thread. It's not a G-62, but here's a link to his photos:...
  23. Replies
    6
    Views
    773

    RE: Oh No !! HK

    Ditto. 13 orders with no issues. Shipping can be slow, but I know that when I place my order and try to be patient waiting for my order to arrive.
  24. Replies
    27,800
    Views
    1,668,037

    RE: Welcome to Club SAITO !

    I am having trouble tightening down the carb / intake manifold on a Saito 180. I replaced the metal gasket and added an o ring, but the carb still moves when I fully tighten the manifold. Any...
  25. Replies
    2
    Views
    420

    RE: FS120 Surpass III Question

    Thanks Bax.
Results 1 to 25 of 209
Page 1 of 9 1 2 3 4
All times are GMT -6. The time now is 02:37 AM.

SEO by vBSEO 3.6.1 ©2011, Crawlability, Inc.