Search: Posts Made By: dsnyder
Showing results 1 to 25 of 500
Search took 1.01 seconds.
03-25-2008, 11:33 AM
Replies: 7
Views: 1,717
Posted By dsnyder

RE: Forum

Thanks for all the kind words! When I began this forum, I worked in our product support department and the forum was an extension of my job responsibilities. Around a year ago I moved into product...
03-25-2008, 08:48 AM
Replies: 7
Views: 1,717
Posted By dsnyder

Forum

Due to growing work and time constraints I am unable to continue to support this forum. It has been my pleasure to support this forum over the last 6 years. Please contact our product support...
03-04-2008, 11:05 AM
Replies: 0
Views: 724
Posted By dsnyder

Out of the office

Just an update, for some reason the posts I made yesterday on the forum have dissapeared when an update to the site was performed and unfortunetely I don't have time today to repost to answer all of...
02-25-2008, 09:55 AM
Replies: 4
Views: 732
Posted By dsnyder

RE: Hitec Supreme FM Autoshift DC Receiver

A JR receiver will not work with a Hitec transmitter. A Hitec receiver that is made to be compatible with a JR transmitter will work.
02-25-2008, 09:53 AM
Replies: 1
Views: 658
Posted By dsnyder

RE: AR-9000 problem...

For piece of mind, I would recommend sending the module and the receiver in for a check up.
02-25-2008, 09:50 AM
Replies: 2
Views: 672
Posted By dsnyder

RE: 9100 will not power up

Have you bound the receiver to the TX with all remotes plugged in? What happens with the switch removed?
02-25-2008, 09:47 AM
Replies: 7
Views: 862
Posted By dsnyder

RE: R1221 info

We will have images up on the web site soon.
02-25-2008, 09:46 AM
Replies: 4
Views: 732
Posted By dsnyder

RE: Hitec Supreme FM Autoshift DC Receiver

Do you mean from one transmitter? If so, then as long as the receiver is Hitec compatible, then yes.
02-25-2008, 09:45 AM
Replies: 1
Views: 577
Posted By dsnyder

RE: 2.4 Question

Were the lights flashing slowly or fast? If slowly, that could be an indication of a power problem. If fast, it is being put into bind mode somehow.
02-25-2008, 09:43 AM
Replies: 1
Views: 482
Posted By dsnyder

RE: 9303 W SX600 BUDDY BOX & FLAPERONS

Yes it will, you will need to completely program the model in both systems.
02-25-2008, 09:41 AM
Replies: 2
Views: 661
Posted By dsnyder

RE: 921 RX install & Extension's

The receiver installation looks fine.
02-25-2008, 09:39 AM
Replies: 9
Views: 1,845
Posted By dsnyder

RE: Firmware upgrade instructions

http://www.horizonhobby.com/Content/Media/pdf/servicecenterchecklist.pdf

There is no "re-binding" delay issue. Binding is done when initially setting up the receiver and there are no binding...
02-25-2008, 09:37 AM
Replies: 12
Views: 2,354
Posted By dsnyder

RE: JR/Spektrum 2.4 GHZ Failsafe

You asked if the 6 or 7 channel receivers have any other options, they do not at this time. What I said was correct. Smartsafe is used in all Spektrum aircraft receivers. The 9 channel receivers...
02-25-2008, 09:32 AM
Replies: 5
Views: 885
Posted By dsnyder

RE: AR9100 : 3 questions

You can charge while plugged into the receiver, however the receiver will draw a small amount of current at all times while the batteries are plugged in, so disconnect them if you are not flying for...
02-25-2008, 09:31 AM
Replies: 9
Views: 2,655
Posted By dsnyder

RE: What does Spektrum mean by "Park Flyer

I'm not familiar with the model mentioned, however the receiver is for slow and park flyer aircraft. If you have a model that you may operate at greater distances than flown with slow/park flyers,...
02-25-2008, 09:28 AM
Replies: 5
Views: 840
Posted By dsnyder

RE: Help with programming an JR XP8103

You would need to send it in for this conversion.
02-25-2008, 09:28 AM
Replies: 6
Views: 1,027
Posted By dsnyder

RE: quick connect

Yes, it is available for everyone.
02-25-2008, 09:26 AM
02-25-2008, 09:25 AM
Replies: 3
Views: 557
Posted By dsnyder

RE: DX7 and pull pull setup

You would need to set the gear to gear mix to -100% in both directions (match the values of the travel adjust on the gear channel to cancel them). Then set the rudder to gear mix in program mix 4...
02-25-2008, 09:22 AM
Replies: 3
Views: 1,688
Posted By dsnyder

RE: AR7000 channel assignments

With the module installed it will use the same channel order as marked on the receiver.
02-25-2008, 09:20 AM
Replies: 20
Views: 4,061
Posted By dsnyder

RE: Spektrum DX6i

The system is a Spektrum brand system throughout.
02-25-2008, 09:19 AM
Replies: 1
Views: 350
Posted By dsnyder

RE: DX2 going into failsafe

What exactly is happening? If you are not able to locate the problem please feel free to send the system in for a check up.
02-25-2008, 09:17 AM
Replies: 5
Views: 1,063
Posted By dsnyder

RE: Kudos to the Horizon Service Center!

Very good to hear! Thanks for posting!
02-25-2008, 09:16 AM
Replies: 3
Views: 1,001
Posted By dsnyder

RE: battery voltage drop capacitor - please clarify

The Spektrum voltage protector is for 1/12 scale cars that use a 4 cell pack to power the ESC and generally the output of the BEC is low, so the voltage protector helps prevent power loss. This is...
02-25-2008, 09:14 AM
Replies: 1
Views: 486
Posted By dsnyder

RE: alarm volume DX7

The only thing I would say to do would be to send the system in for a check up as there is no volume control.
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service