Register

If this is your first visit, please click the Sign Up now button to begin the process of creating your account so you can begin posting on our forums! The Sign Up process will only take up about a minute of two of your time.

Search:

Type: Posts; User: chubbysuncle

Page 1 of 25 1 2 3 4

Search: Search took 1.00 seconds.

  1. RE: weve got a thread about location, what about how old we are

    I'm 40 too old man,,, don't worry..It's all downhill from here! LOL[sm=wink_smile.gif]
  2. Replies
    1,226
    Views
    99,521

    RE: Redcat vehicle repair/tune FAQ

    I wrote that!:D
  3. Replies
    1,226
    Views
    99,521

    RE: Redcat vehicle repair/tune FAQ

    NO;)
  4. Replies
    1,226
    Views
    99,521

    RE: Redcat vehicle repair/tune FAQ

    AAAAA..... I used a vise. A small shop vise is cheep. Buy one. It slowly and evenly presses the bearing into the retainer. By hitting it with a hammer you dented the end. This bound up the bearings...
  5. Replies
    1,226
    Views
    99,521

    RE: Redcat vehicle repair/tune FAQ

    Mine works fine. I had no issues with it. Like Eddie stated above.. I think you either got a bad bearing, the shaft was damaged( nicked scored or dirty) or if you forced the bearing in hard it may...
  6. Replies
    1,226
    Views
    99,521

    RE: Redcat vehicle repair/tune FAQ

    Yeah.. it seized to the shaft. It only takes a few minutes for the temps to equalize. They would've been the same temp by the time you had it ready to start up. I don't see how the cooler bearing did...
  7. Replies
    17
    Views
    1,000

    RE: engine wont start after it warms up

    Check for Air leaks. Seal the motor and richen it up.
  8. Replies
    1,226
    Views
    99,521

    RE: Redcat vehicle repair/tune FAQ

    The bearing is a press fit in the steel hex holder. By freezing the bearing it will shrink. The hex holder should be warm or at least room temp. This helps prevent any damage to the bearing when it's...
  9. Replies
    20
    Views
    808

    RE: break in on new motor

    Make sure that when you shut the engine down the pistopn is @ BDC or the furthest point from the glow plug when you allow it to cool. If not you'll have a short lived engine..:D Hey Everyone!...
  10. Replies
    58
    Views
    2,737

    RE: Merry Christmas

    Merry Christmas You Guys & Girls!!:D I haven't been around for awhile. Been playing with my Jeep and hanging out on the Jeep forum. I hope everyone's doing well and has a safe and great...
  11. Replies
    39
    Views
    3,145

    RE: where is everyone

    "were" in Fl[sm=lol.gif][sm=lol.gif]
  12. Replies
    75
    Views
    5,334

    RE: What Does Everybody Drive *PICS*

    Here's my "new Ride. I had the top off to reseal it for Winter. I,ve got the softop too that'll go on next spring. It's an 89. The Wife drives a 01 Grand Cherokee.
  13. Replies
    39
    Views
    3,145

    RE: where is everyone

    http://www.putfile.com/pic.php?img=3790386
    LOL Here's a pic. Funny thing is the Jeep found it's way from FL to NJ last May. I've had a long talk with her and she doesn't wanna go back!
  14. Replies
    39
    Views
    3,145

    RE: where is everyone

    You live in the middle of the state! LOL Nice "boat" HE he ! Hey Eddie! WAAAASSSUPP?? LOL Guess what? The Volcano hasn't broke in a month..cause the kid hasn't driven it! Ha. Been playing with my...
  15. Replies
    1
    Views
    286

    RE: HPI Clutch Bell

    Yup.
  16. Replies
    1
    Views
    255

    RE: stock 2 speed shifting Q

    Just keep adjusting til it shifts when you want it to. There's a small hole in the top of the tranny that you can get to the screw thru or turn the car over. Just turn it in 1/2 turn at a time till...
  17. RE: This may sound strange.....engine start problem

    Also the seal on the tank lid sucks. It's a poor design. Put some liquid soap around the tank lid an blow in the pressure tube. I bet it leaks. You'll see the bubbles.
  18. Replies
    11
    Views
    1,014

    RE: Diff oil suggestions?

    The Higher the # weight the thicker the viscosity oil. Molassass would be 50000 wt, mineral oil would be 10wt.
  19. RE: ? on how to make the tornado xp with higher ground clearence

    Hey, I didn't say it would be easy...LOL You know whats easier... Jato? Revo? Savage???? LOL
  20. Replies
    31
    Views
    1,779

    RE: CAUTION: INSTRUCTION BOOKLET

    I'm just miffed about his SAME post on almost every thread. I'm goin thru posts to catch up and they're all his Same posts. I know the dealers on this forum and if I need parts I know who to order...
  21. Replies
    11
    Views
    1,014

    RE: Diff oil suggestions?

    Oh.. I'm not sure. I just picked the # outta the air. try Tower Hobbies. they're probably cheaper anyway. But the thicker or higher# weight oil the more equal the power transfer is. You may not even...
  22. RE: ? on how to make the tornado xp with higher ground clearence

    ;)
  23. Replies
    11
    Views
    1,014

    RE: Diff oil suggestions?

    The higher the #"weight" of oil the more equal the power transfer is to each driveshaft or tire. IE: If you spin the input of the rear differential and hold 1 tire the other tire will spin and the...
  24. Replies
    1,226
    Views
    99,521

    RE: Redcat vehicle repair/tune FAQ

    I've already responded to the cross post advertiseing above in one of the other threads. Jared... I don't think a 2 speed in in a truck is worth it. It will work but you'll need the crappy 2 speed...
  25. RE: ? on how to make the tornado xp with higher ground clearence

    All this talk about ground clearence.. Undo the top shock mount and let the wheel hang. Note where the lower A arm hits the chassis and remove the spots that hit. You can only go so far though,...
Results 1 to 25 of 621
Page 1 of 25 1 2 3 4
All times are GMT -6. The time now is 10:29 AM.

SEO by vBSEO 3.6.1 ©2011, Crawlability, Inc.