Search: Posts Made By: xCOMBATx
Showing results 1 to 7 of 7
Search took 0.02 seconds.
Forum: Redcat Racing Support 07-03-2013, 09:57 PM
Replies: 4
Views: 3,828
Posted By xCOMBATx
RE: Tornado EPX pro wheels/tires combo. (brushless version)

Is there any street tires that would fit on the stock redcat racing wheels.?<div>
</div>
Forum: Redcat Racing Support 10-26-2012, 09:51 AM
Replies: 9
Views: 2,556
Posted By xCOMBATx
RE: Tornado EPX PRO 1/10 Buggy 8.4v NiMH Battery issue

FYI, for those of you who utilize the 8.4v NiMH battery make sure to turn off the Low-Voltage Protection setting which is programmed on the ESC. That has solved all my issues. That feature is only...
Forum: Redcat Racing Support 10-25-2012, 04:10 PM
Replies: 9
Views: 2,556
Posted By xCOMBATx
RE: Tornado EPX PRO 1/10 Buggy 8.4v NiMH Battery issue

I have a tamiya connector on the 8.4v battery. Do you think it can't handle the increase demand of amperage? I honestly doubt that the battery is at fault since I was able to operate once the battery...
Forum: Redcat Racing Support 10-25-2012, 02:13 PM
Replies: 4
Views: 3,828
Posted By xCOMBATx
Tornado EPX pro wheels/tires combo. (brushless version)

Hello, I'm looking where I can find street tires for this vehicle. The stock version of this wheel waste too much on asphalt. I'm looking for street tread version application since I mostly drive it...
Forum: Redcat Racing Support 10-25-2012, 10:47 AM
Replies: 9
Views: 2,556
Posted By xCOMBATx
RE: Tornado EPX PRO 1/10 Buggy 8.4v NiMH Battery issue

I am using a different charger and charging at 560milliamps at 9volts would do the trick. I could have had a cell not fully charged.
Forum: Redcat Racing Support 10-25-2012, 09:44 AM
Replies: 9
Views: 2,556
Posted By xCOMBATx
RE: Tornado EPX PRO 1/10 Buggy 8.4v NiMH Battery issue

Funny, I left the battery intact overnight without chariging it and attempted to try one more time before I send in the battery. Apparently, it worked fine this morning. I noticed the car had a lot...
Forum: Redcat Racing Support 10-24-2012, 08:52 PM
Replies: 9
Views: 2,556
Posted By xCOMBATx
Tornado EPX PRO 1/10 Buggy 8.4v NiMH Battery issue

Hello, I have a Tornado EPX PRO 1/10 Scale Brushless Buggy that I recently purchased new. I am able to run 7.2v batteries (NiMH) ranging from 2000mah to 5000mah all day long. I recently bought an...
Showing results 1 to 7 of 7



Forum Jump


All times are GMT -8. The time now is 09:06 AM.