Register

If this is your first visit, please click the Sign Up now button to begin the process of creating your account so you can begin posting on our forums! The Sign Up process will only take up about a minute of two of your time.

Search:

Type: Posts; User: 600Bob

Page 1 of 5 1 2 3 4

Search: Search took 0.10 seconds.

  1. Replies
    173
    Views
    18,085

    It has been some time since I did mine. I did...

    It has been some time since I did mine. I did not assemble the wings to glue them in. Is there any difference between the pieces? I can't tell by looking at them after being installed. Maybe some...
  2. Replies
    9
    Views
    261

    You are welcome :)

    You are welcome :)
  3. Replies
    9
    Views
    261

    Limited stock here:...

    Limited stock here:
    http://www.valuehobby.com/xt60-male-to-ec3-female-adapter.html

    15 here:
    http://www.ebay.com/itm/1-XT60-Male-To-Female-EC3-Connector-Adapter-/330462587127

    10 here but from...
  4. Replies
    9
    Views
    261

    If you can solder just cut off and replace the...

    If you can solder just cut off and replace the XT60 with EC3, or make an adapter lead, or there are a number of pre made adapters chances are you could buy one too.
  5. Replies
    17
    Views
    513

    Huh? FAA regulates full scale aircraft and...

    Huh? FAA regulates full scale aircraft and licensed pilots, not RC models flown line of sight unless you are near an airport. RC transmitters are a Part 15 device, no license required and can be...
  6. Replies
    23
    Views
    1,021

    I don't think you meant to say that the bind plug...

    I don't think you meant to say that the bind plug shorts the + and - leads, that would short out your receiver battery or BEC. The bind plug shorts the Signal and neg. leads of the receiver.
  7. Replies
    23
    Views
    1,021

    Okay, then it doesn't lose "Bind", if it did you...

    Okay, then it doesn't lose "Bind", if it did you would have to go through the bind process again. The flashing light generally indicates a loss of signal. It could be from the antennas being...
  8. Replies
    23
    Views
    1,021

    ^^^Do you have to put the bind plug in and...

    ^^^Do you have to put the bind plug in and re-bind it?
  9. Replies
    23
    Views
    1,021

    I use Spektrum and some of the cheaper Orange...

    I use Spektrum and some of the cheaper Orange receivers. I always bind them and center the servo arms outside the plane. Make sure that if you have to reverse the throttle servo channel after...
  10. Replies
    23
    Views
    1,021

    If it lost the bind when you removed the...

    If it lost the bind when you removed the battery/power then you would need to re-bind every time you turned off the plane and re-bind before each flight. No one would use them if they were like...
  11. Thread: dle 20 voltage

    by 600Bob
    Replies
    7
    Views
    263

    If we were talking about servos I would say it...

    If we were talking about servos I would say it would be fine. But I err on the side of caution with ignitions. I use one of these for my ignitions with LiFe batteries.
    ...
  12. Replies
    5
    Views
    196

    The DX8 has a Dual elevator tail and Dual Aileron...

    The DX8 has a Dual elevator tail and Dual Aileron found under the Wing Type menu. It only works for 2 ail. and 2 elev. servos though. If you have more servos then the Match Box or similar is the way...
  13. Twists in the wings or tail? Check the lateral...

    Twists in the wings or tail? Check the lateral balance to see that it isn't more than just a muffler.
  14. The 30c means the battery is able to deliver a...

    The 30c means the battery is able to deliver a higher max amps if the power system will pull more.

    1300ma x 20c = 26 amps max
    1300ma x 30c = 39 amps max

    Now if your electronic setup can only...
  15. If you need a 3s battery you don't want to use a...

    If you need a 3s battery you don't want to use a 2s to replace it. Here is a 3s 1300mah which would be fine if it fits the battery compartment. They come with different connectors too, I just picked...
  16. Thread: Blade nano qx

    by 600Bob
    Replies
    3
    Views
    360

    Just did some reading, it looks like you need to...

    Just did some reading, it looks like you need to use a switch that controls channel 6. You flip it on then back off to switch modes.
  17. Thread: Blade nano qx

    by 600Bob
    Replies
    3
    Views
    360

    What switch does it show for the Spektrum TX? If...

    What switch does it show for the Spektrum TX? If it's the gear switch it's channel 5 by default.
  18. Replies
    14
    Views
    448

    I had a 17cc in a Thunder Tiger Cloud Dancer...

    I had a 17cc in a Thunder Tiger Cloud Dancer which has a very narrow fuselage and it was a tight fit. Loved that plane but it met it's expiration date :( That engine is now in the 60 size Hangar 9...
  19. Replies
    14
    Views
    448

    You don't have to run a second battery and switch...

    You don't have to run a second battery and switch for the ignition.
  20. If that RX does have failsafe for channels other...

    If that RX does have failsafe for channels other than just the throttle you have to use a different bind procedure.

    Put bind plug into RX. Power up RX. Lights flash. Remove bind plug. Hold TX...
  21. Replies
    6
    Views
    170

    Did you actually create a mix to run both...

    Did you actually create a mix to run both elevator servos? In the DX8 all you need to do is go into the Wing Type menu and for Tail select Dual Elevator. No need to create a mix for it.
  22. Replies
    5
    Views
    1,361

    Maybe start with a 4 channel like the Blade 120Sr...

    Maybe start with a 4 channel like the Blade 120Sr then move on to collective pitch.
  23. Replies
    10
    Views
    1,159

    I too am new to quads. The 350QX has new blades...

    I too am new to quads. The 350QX has new blades so broken props shouldn't be an issue. My problem with the quads you listed is the one piece frame, you break one arm and you need a new frame.

    I...
  24. Replies
    11
    Views
    386

    Hangar 9 Taylorcraft. ...

    Hangar 9 Taylorcraft.

    http://www.hangar-9.com/Products/Default.aspx?ProdID=HAN4900
  25. Replies
    3
    Views
    231

    If the wings are straight, not swept, then...

    If the wings are straight, not swept, then measure the cord from the leading edge of the forward wing to the trailing edge of the other wing as if it was a single wing, use 25% of the cord.
Results 1 to 25 of 119
Page 1 of 5 1 2 3 4
All times are GMT -6. The time now is 08:01 AM.

SEO by vBSEO 3.6.1 ©2011, Crawlability, Inc.