Search: Posts Made By: lmisner
Showing results 1 to 11 of 11
Search took 0.81 seconds.
05-23-2011, 06:22 AM
Replies: 14
Views: 1,000
Posted By lmisner

RE: S791 retract wiring help

I've run that servo on 5 cell packs and not experienced any problems, and was surprised to see the voltage proviso on Horizon's website, but YMMV. A simpler solution would be to solder a diode in...
09-25-2009, 11:09 AM
Replies: 1
Views: 684
Posted By lmisner

Spektrum Antenna for 10X

Hi:

I have broken the plastic Spektrum antenna adapter that screws into the adjustable ball several times now. Does anybody make a metal adapter or better yet can the 12x antenna be retrofitted...
06-05-2006, 11:24 AM
Replies: 40
Views: 17,506
Posted By lmisner

RE: World models groovy 50 F3A

Hey Guys:

I am putting an Eflite Power 60 (same as AXI 4130?) and a 6s pack in my Groovy. Has anyone put any cooling holes for the battery in the belly pan behind the wing? How about in the...
04-22-2006, 05:48 PM
Replies: 1
Views: 459
Posted By lmisner

YS 140L Header Problem

Hi:

My Johnson header backed out today in flight , so I finger snugged the header nut back in like I usually do and started to snug it with a wrench, when, you guessed it, the nut sheared,...
04-11-2006, 11:26 AM
Replies: 5
Views: 1,193
Posted By lmisner

RE: Pit stop servo change- Matchmaker

Hi Don:

It sounds like the device is actually programming the center and end points of the servo, as can be done with Hitec servos and their programmer. Is this the case, or is something else...
11-24-2005, 09:05 AM
Replies: 4
Views: 1,144
Posted By lmisner

RE: Groovy 50 Conversion questions

Hi:

I don't know if it is overkill, but this is about the same set up that I am going to use. It appears that the E-Flite 60 is the same as the AXI 4130, which is what I was going to use...
11-22-2005, 08:59 PM
Replies: 5
Views: 908
Posted By lmisner

RE: 10X Idle up

Hi Len:

Thanks, that was it. I thought I knew most of the ins and outs of the 10X until I read your article. Lots of good stuff.

Lonnie Misner
11-22-2005, 12:36 PM
Replies: 5
Views: 908
Posted By lmisner

10X Idle up

Hi Danny:

I wanted to do an idle up for both my H9 Sukhoi and my 2m Typhoon 2000. I ran across Len Alessi's great article and set it up per the article. Everything went OK for the T2K, but...
10-08-2005, 10:15 AM
Replies: 1
Views: 537
Posted By lmisner

Help identify coupler

Hi All;

I have a coupler and anti-vibe mount for the coupler and I don't know who makes them, since I purchased the engine (YS 1.40L) Johnson header, Hatori pipe and coupler from another modeler...
Replies: 1
Views: 530
Posted By lmisner

HS-5245MG

Hi:

I have a two part question. Number 1 is will there be a karbonite or nylon gear version of the 5245MG, something like the JR DS3421SA? I am thinking of using them as elevator servos...
05-02-2004, 07:28 AM
Replies: 3
Views: 503
Posted By lmisner

Range problem w/50MHz

Hi Danny:

The problem I have is, I am getting drastically reduced range on my new 6 meter stuff compared to my 72 MHz stuff. Initially I noticed it on my 10X on Ch 06 with a 649 Rx in my...
Showing results 1 to 11 of 11


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service